RESUMEN
A highly sensitive strain sensor based on tunable cascaded Fabry-Perot interferometers (FPIs) is proposed and experimentally demonstrated. Cascaded FPIs consist of a sensing FPI and a reference FPI, which effectively generate the Vernier effect (VE). The sensing FPI comprises a hollow core fiber (HCF) segment sandwiched between single-mode fibers (SMFs), and the reference FPI consists of a tunable air reflector, which is constituted by a computer-programable fiber holding block to adjust the desired cavity length. The simulation results predict the dispersion characteristics of modes carried by HCF. The sensor's parameters are designed to correspond to a narrow bandwidth range, i.e., 1530 nm to 1610 nm. The experimental results demonstrate that the proposed sensor exhibits optimum strain sensitivity of 23.9 pm/µÎµ, 17.54 pm/µÎµ, and 14.11 pm/µÎµ cascaded with the reference FPI of 375 µm, 365 µm, and 355 µm in cavity length, which is 13.73, 10.08, and 8.10 times higher than the single sensing FPI with a strain sensitivity of 1.74 pm/µÎµ, respectively. The strain sensitivity of the sensor can be further enhanced by extending the source bandwidth. The proposed sensor exhibits ultra-low temperature sensitivity of 0.49 pm/°C for a temperature range of 25 °C to 135 °C, providing good isolation for eliminating temperature-strain cross-talk. The sensor is robust, cost-effective, easy to manufacture, repeatable, and shows a highly linear and stable response for strain sensing. Based on the sensor's performance, it may be a good candidate for high-resolution strain sensing.
RESUMEN
The near-infrared luminescence of Bi-doped aluminosilicate fiber within pump wavelengths between 710 and 990 nm and under varying pump powers and operation temperatures has been investigated systematically. It is revealed that there exist two emission bands peaking around 1120 and at 1300 nm, which are believed to be associated with two different aluminum-related bismuth active centers (BAC-Al1 and BAC-Al2); the BAC-Al2 is found to be more efficiently excited at a lower temperature within the spectral range of 790-850 nm. This is the first time, to the best of our knowledge, that two sub-bands of BAC-Al are identified. The thermal annealing effect on the luminescence of BACs is also studied under 830 nm pumping. In contrast to the quenching of BAC-Si, the luminescence intensity of BAC-Al1 is enhanced by 1.5 times after 500°C heating and subsequent cooling. The results demonstrate an effective strategy for tuning the emission scheme in the range of 1100-1400 nm by adjusting the excitation wavelength and operation temperature.
RESUMEN
α-MoO3 has been used as a hydrogen sensing material due to its excellent properties and unique crystalline layer structure. However, the low repeatability of α-MoO3 based hydrogen sensor restricts its practical application. In this paper, the effect of intercalated ion species and the amount in α-MoO3 is experimentally investigated and discussed. It is concluded that the repeatability of the sensor depends on the radius of intercalated ions and amount of ionic bonds. The optimal ion species is Na+ and the optimal amount of precursor is 1 mmol.
RESUMEN
We have presented and demonstrated a fiber optic gas pressure sensor with ultra-high sensitivity based on Vernier effect. The sensor is composed of two integrated parallel Mach-Zehnder interferometers (MZIs) which are fabricated by fusion splicing a short section of dual side-hole fiber (DSHF) in between two short pieces of multimode fibers (MMFs). Femtosecond laser is applied for cutting off part of the MMF and drilling openings on one air hole of the DSHF to achieve magnified gas pressure measurement by Vernier effect. Experimental results show that the gas pressure sensitivity can be enhanced to about -60 nm/MPa in the range of 0-0.8 MPa. In addition, the structure possesses a low temperature cross-sensitivity of about 0.55 KPa/°C. This presented sensor has practically value in gas pressure detection, environmental monitoring and other industrial applications.
RESUMEN
An extrinsic Fabry-Perot interferometer (EFPI) composed of double fiber FP cavities in a glass capillary tube to generate Vernier effect has been fabricated and employed for gas pressure sensing. A lead-in single-mode fiber (LSMF) and a reflective single-mode fiber (RSMF) were inserted into the capillary tube to form a FP cavity. Femtosecond (fs) laser was used to ablate openings on a capillary tube for gas passage to the FP cavity. A fusion hole was also drilled on the end face of a SMF by fs laser. The sensitivity of the sensor is enhanced due to Vernier effect. Experimental results show that the sensitivity was as high as 86.64 nm/MPa in the range of 0~0.6 MPa, which is 32.8 times larger than that of an open-cavity EFPI sensor without Vernier effect. The temperature cross-sensitivity of the sensor was measured to be about 5.18 KPa/°C. The proposed sensor was characterized by its high sensitivity, compact structure and ease of fabrication, and would have extensive application prospects in gas sensing fields.
RESUMEN
Hydrogen gas sensing properties of Pt-WO3 films on spiral microstructured fiber Bragg grating (FBG) has been demonstrated. Pt-WO3 film was prepared by hydrothermal method. The spiral microsturctured FBG was fabricated using femtosecond laser. Spiral microstructure FBG hydrogen sensor can detect hydrogen concentration from 0.02% H2 to 4% H2 at room temperature, and the response time is shortened from a few minutes to 10~30 s. Double spiral microstructure at pitch 60 µm and sputtered with 2 µm Pt-WO3 film recorded hydrogen sensitivity of 522 pm/%(v/v) H2 responding to hydrogen gas in air. This translated to approximately 2~4 times higher than the unprocessed standard FBG. The humidity has little effect on the sensing property. The sensor has fast response time, good stability, large detection range and has the good prospect of practical application for hydrogen leak detection.
RESUMEN
A novel fiber optic hydrogen concentration detection platform with significantly enhanced performance is proposed and demonstrated in this paper. The hydrogen sensing probe was prepared by depositing WO3-Pd2Pt-Pt composite film on the fiber tip of two Bragg gratings paired with high-low reflectivity. At a room temperature of 25°C, the hydrogen sensor has a significant response towards 10 ppm hydrogen in nitrogen atmosphere, and may detect tens of ppb hydrogen changes when the hydrogen concentration is between 10~60 ppm. Besides, the proposed system shows quick response when the hydrogen concentration is above 40 ppm. Moreover, the hydrogen sensor shows good repeatability during the hydrogen response. This work proposes a new concept to develop hydrogen sensing technology with ultra-high sensitivity, which can significantly promote its potential application in various fields, especially for ultra-low hydrogen detection in oxygen-free environment.
RESUMEN
To meet the requirements for low-frequency vibration monitoring, a new type of FBG (fiber Bragg grating) accelerometer with a bended spring plate is proposed. Two symmetrical bended spring plates are used as elastic elements, which drive the FBG to produce axial strains equal in magnitude but opposite in direction when exciting vibrations exist, leading to doubling the wavelength shift of the FBG. The mechanics model and a numerical method are presented in this paper, with which the influence of the structural parameters on the sensitivity and the eigenfrequency are discussed. The test results show that the sensitivity of the accelerometer is more than 1000 pm/g when the frequency is within the 0.7-20 Hz range.
RESUMEN
A performance optimization design for a high-speed fiber Bragg grating (FBG) interrogation system based on a high-speed distributed feedback (DFB) swept laser is proposed. A time-division-multiplexing sensor network with identical weak FBGs is constituted to realize high-capacity sensing. In order to further improve the multiplexing capacity, a waveform repairing algorithm is designed to extend the dynamic demodulation range of FBG sensors. It is based on the fact that the spectrum of an FBG keeps stable over a long period of time. Compared with the pre-collected spectra, the distorted spectra waveform are identified and repaired. Experimental results show that all the identical weak FBGs are distinguished and demodulated at the speed of 100 kHz with a linearity of above 0.99, and the range of dynamic demodulation is extended by 40%.
RESUMEN
A composite microstructure in fiber Bragg grating (FBG) with film deposition for hydrogen detection is presented. Through ablated to FBG cladding by a femtosecond laser, straight-trenches and spiral micro-pits are formed. A Pd-Ag film is sputtered on the surface of the laser processed FBG single mode fiber, and acts as hydrogen sensing transducer. The demonstrated experimental outcomes show that a composite structure produced the highest sensitivity of 26.3 pm/%H, nearly sevenfold more sensitive compared with original standard FBG. It offers great potential in engineering applications for its good structure stability and sensitivity.
RESUMEN
We discuss hydrogen sensors based on fiber Bragg gratings (FBGs) micro-machined by femtosecond laser to form microgrooves and sputtered with Pd/Ag composite film. The atomic ratio of the two metals is controlled at Pd:Ag = 3:1. At room temperature, the hydrogen sensitivity of the sensor probe micro-machined by 75 mW laser power and sputtered with 520 nm of Pd/Ag film is 16.5 pm/%H. Comparably, the standard FBG hydrogen sensitivity becomes 2.5 pm/%H towards the same 4% hydrogen concentration. At an ambient temperature of 35°C, the processed sensor head has a dramatic rise in hydrogen sensitivity. Besides, the sensor shows good response and repeatability during hydrogen concentration test.
RESUMEN
To meet the requirements for medium-high frequency vibration monitoring, a new type fiber Bragg grating (FBG) accelerometer with an integrative matrix structure is proposed. Two symmetrical flexible gemels are used as elastic elements, which drive respective inertial mass moving reversely when exciting vibration exists, leading to doubling the wavelength shift of the FBG. The mechanics model and a numerical method are presented in this paper, by which the influence of the structural parameters on the sensitivity and eigenfrequency is discussed. Sensitivity higher than 200 pm/g and an eigenfrequency larger than 3000 Hz can be realized separately, but both cannot be achieved simultaneously. Aiming for a broader measuring frequency range, a prototype accelerometer with an eigenfrequency near 3000 Hz is designed, and results from a shake table test are also demonstrated.
RESUMEN
A multilayer-based fiber optic sensor enabling simultaneous measurement of humidity and temperature is proposed and demonstrated. The sensitive elements were multilayer coatings consisting of nano-porous TiO(2) and SiO(2) films, which were deposited on fiber end-face to form a Fabry-Perot (F-P) filter structure. Relative-humidity (RH) sensing is correlated with the shift of interference fringe due to the change of effective refractive index of porous coatings when exposed to different RH environments. The sensor is sealed in a glass tube in case of temperature measurement. Experimental results show that the average sensitivity are 0.43nm/%RH and 0.63nm/°C respectively when environmental RH changes from 1.8%RH to 74.7%RH and temperature changes from 21.4°C to 38.8°C. The proposed sensors present high repeatability, and especially highly sensitive to lower moisture measure.
RESUMEN
A novel (to our knowledge) 3D microstructure manufactured by a femtosecond laser in fiber Bragg grating (FBG) fiber cladding is proposed. The special spiral parameters including single thread and double thread with certain pitches of 60 and 80 µm are controlled by the feed and rotation speed of a rotary fixture. Moreover, supermagnetostrictive TbDyFe film with a thickness of nearly 6 µm is deposited on microgrooves of a FBG by magnetron sputtering technology to form the magnetic field sensing probe. Experimental results demonstrate that a FBG with a double-thread microstructure has a sensitivity of 1.1 pm/mT responding to a magnetic field, and in a theoretical situation, it is approximately six times higher than the original optical fiber grating (approximately 0.2 pm/mT). This new microstructure and method show great prospect in the magnetic field sensing domain.
RESUMEN
Self-assembly of C3 discotic molecules bearing dipeptide pendants into helical supramolecular polymers is investigated. The dipeptides are constituted from glycine and alanine with altered sequence, aiming at modulating the steric hindrance and examining the steric effects on the assembly. This steric hindrance effect is further illustrated with a dipeptide formed from glycine and valine, which carries a much larger isopropyl side unit. Their supramolecular polymerization is examined in various organic solvents and at different temperatures. The assembly morphology is directly visualized with atomic force microscopy. It is found that small changes in the dipeptide motifs in combination with solvent structure and the solution concentrations lead to different expression of the supramolecular assembly.
Asunto(s)
Dipéptidos/química , Polímeros/química , Alanina/química , Benzamidas/química , Glicina/química , Enlace de Hidrógeno , Microscopía de Fuerza Atómica , Polimerizacion , Estructura Secundaria de Proteína , Solventes/química , TemperaturaRESUMEN
In this work, we have proposed a novel long-range surface plasmon resonance (LRSPR) sensor with sharp reflection spectrum, which consists of a glass prism, a (A/B)4-type waveguide-coupled layer and a metal layer. To reveal its sharp reflection spectrum perfectly, we have simulated the effects of all factors of this LRSPR sensor on the reflection spectrum, and finally presented the optimal parameters of the LRSPR sensor with sharp reflection spectrum.
RESUMEN
A novel magnetic field sensor based on Terfenol-D coated fiber Bragg grating with spiral microstructure was proposed and demonstrated. Through a specially-designed holder, the spiral microstructure was ablated into the fiber Bragg grating (FBG) cladding by femtosecond laser. Due to the spiral microstructure, the sensitivity of FBG coated with magnetostrictive film was enhanced greatly. When the spiral pitch is 50 µm and microgroove depth is 13.5 µm, the sensitivity of the magnetic field sensor is roughly 5 times higher than that of non-microstructured standard FBG. The response to magnetic field is reversible, and could be applicable for magnetic field detection.