Glossary on atmospheric electricity and its effects on biology.

There is an increasing interest to study the interactions between atmospheric electrical parameters and living organisms at multiple scales. So far, relatively few studies have been published that focus on possible biological effects of atmospheric electric and magnetic fields. To foster future work in this area of multidisciplinary research, here we present a glossary of relevant terms. Its main purpose is to facilitate the process of learning and communication among the different scientific disciplines working on this topic. While some definitions come from existing sources, other concepts have been re-defined to better reflect the existing and emerging scientific needs of this multidisciplinary and transdisciplinary area of research.

Influence of TiN Coating on the Drawing Force and Friction Coefficient in the Deep Drawing Process of AlMg4.5Mn0.7 Thin Sheets.

The influence of various process parameters on the deep drawing process is a current research topic in sheet metal forming technology. Starting from the application of the previously constructed original testing device, an original tribological model was developed based on the process of sheet metal strip sliding between flat contact surfaces under variable pressures. A complex experiment was executed using an Al alloy sheet, tool contact surfaces of different roughness, two types of lubricants and variable contact pressures. The procedure included analytically pre-defined contact pressure functions based on which, for each of the mentioned conditions, the dependencies of the drawing forces and friction coefficients were obtained. The pressure in function P1 constantly decreased from a high initial value until the minimum, while in function P3 the pressure increased until the minimum value at the halfway point of the stroke, after which it increased up to the initial value. On the other hand, the pressure in function P2 constantly increased from the initial minimum value until the maximum value, while in function P4 the pressure increased until reaching the maximum value at the halfway point of the stroke, after which it decreased to the minimum value. This enabled the determination of the influence of tribological factors on the process parameters of intensity of traction (deformation force) and coefficient of friction. The pressure functions starting with decreasing trends produced higher values for the traction forces and the friction coefficient. In addition, it was established that the roughness of the contact surfaces of the tool, especially those with titanium nitride coating, has a significant influence on the process parameters. For surfaces of lower roughness (polished), a tendency of the Al thin sheet to form a glued-on layer was noticed. This was especially prominent for lubrication with MoS2-based grease under conditions of high contact pressure (functions P1 and P4 at the beginning of the contact).

Basic types of the first-day glycemia in acute myocardial infarction: Prognostic, diagnostic, threshold and target glycemia.

We described the importance of stress hyperglycemia (SH) in critical illnesses and their evaluation in the emergency department (ED) and coronary care unit (CCU). Hyperglycemia is found in over half of the patients with suspected acute myocardial infarction (AMI). SH can be used for several purposes in AMI. Receiver operating characteristic curves are needed to find optimal cut-offs to divide blood glucose levels associated with good from bad prognosis in AMI. There is a need for a consensus for pragmatic classification of first day glycemia in order to be useful in a busy ED and CCU.

Should Cushing's Syndrome be Considered as a Disease with High Cardiovascular Risk in Relevant Guidelines?

A considerable amount of data supports a 1.8-7.4-fold increased mortality associated with Cushing's syndrome (CS). This is attributed to a high occurrence of several cardiovascular disease (CVD) risk factors in CS [e.g. adiposity, arterial hypertension (AHT), dyslipidaemia and type 2 diabetes mellitus (T2DM)]. Therefore, practically all patients with CS have the metabolic syndrome (MetS), which represents a high CVD risk. Characteristically, despite a relatively young average age, numerous patients with CS display a 'high' or 'very high' CVD risk (i.e. risk of a major CVD event >20% in the following 10 years). Although T2DM is listed as a condition with a high CVD risk, CS is not, despite the fact that a considerable proportion of the CS population will develop T2DM or impaired glucose tolerance. CS is also regarded as a risk factor for aortic dissection in current guidelines. This review considers the evidence supporting listing CS among high CVD risk conditions.