RESUMEN
OBJECTIVE: Nephrolithiasis is a common urological disease that can lead to renal failure. Oxidative stress has been shown to be a contributing factor for nephrolithiasis and many agents have been studied to prevent and treat oxidative stress-related nephrolithiasis and renal damage. Myrtus communis (MC) extract has been shown to be an important antioxidant in different animal models. In this study, MC extract was administered preventively or therapeutically to rats with kidney stones, and its effectiveness was investigated. METHODS: Wistar albino rats were divided into four groups (n=8); control (C), ethylene glycol (EG), EG+preventive MC, and EG+curative MC groups. The nephrolithiasis model was created by adding 0.75% EG to drinking water for 8 weeks. Ultimately, 24-hour urine was collected to measure calcium, citrate, and creatinine levels. After decapitation, kidney tissues were harvested for histological analyses, measurement of osteopontin and 8-hydroxydeoxyguanosine (8-OHdG) levels, and N-acetyl-ß-glucosaminidase (NAG), myeloperoxidase (MPO) and caspase-3 activities. RESULTS: In 24-hour urine samples, calcium, citrate and creatinine levels were decreased in the EG group, while oxalate levels were increased and in treatment groups these parameters returned to control levels. MPO, 8-OHdG, caspase-3 and NAG activity were significantly increased in tissue and these changes were reversed in both MC groups. Histological findings also supported the biochemical parameters. CONCLUSION: MC can reduce oxidative stress and histopathological changes in kidney tissues in rat nephrolithiasis model when used as either a preventive or therapeutic agent. If supported with further clinical trials, MC might have clinical implications in preventing oxidative renal cell injury and ultimately kidney stone formation.
RESUMEN
PURPOSE: Radiation exposure is affected by C-arm fluoroscopy device positioning during percutaneous renal puncture. Our aim was to compare the exposure of surgeon's lens, hand and chest with a fluoroscopy protocol replicated in different C-arm positions. MATERIALS AND METHODS: A standardized fluoroscopy protocol was created using water-equivalent solid phantoms to replicate a surgeon and patient. 111 mGy radiation (360 s) was applied in standard fluoroscopy mode (91 kVp, 2.7 mA/mAs). Dosimeters were placed on lens, chest and hand of surgeon and patient phantom models. 7 different C-arm positions were created: 0°, mediolateral (ML) +90°, ML -90°, ML +30°, ML -15°, craniocaudal (CC) +30°, CC +15°. Measurements were evaluated separately for different positions. RESULTS: The highest radiation exposure was measured on patient dosimeter (2.97 mSv). The highest exposure on surgeon was recorded on finger dosimeter in all C-arm positions; highest dose was recorded in ML +90° position (2.88 mSv). In finger dosimeters, lowest exposure was recorded in 0° position (0.51 mSv). The lowest exposure of all positions was measured in chest dosimeter in ML -90° position (0.24 mSv). CONCLUSIONS: In positions where X-ray generator of the C-arm was facing towards the surgeon, radiation exposure measured in all dosimeters was higher compared to positions where the generator was facing away. The hand radiation exposure in all positions was higher than chest and lens. Special care must be taken to avoid facing the X-ray generator tube and hands should be as well-protected as chest and eyes with special protective gear.