Parametric study on conductive patterns by low-temperature sintering of micron silver ink.

The fabrication of dense conductive patterns was achieved by low-temperature sintering of 1-3 µm micron silver flakes. A small amount of 20-50 nm nanosilver particles were added in the gaps of the micron silver flakes. The effects of sintering temperature, holding time and heating rate on the morphological evolution and formation mechanism of the sintered silver pattern were investigated in detail. Interestingly, rapid sintering (RS) can be achieved by removing the heating process from 70 °C up to the sintering temperature. The electrical resistivity of the sintered silver patterns was 10.8 × 10-6 Ω cm at 140 °C for 30 min under a pressure of 10 MPa. Moreover, the electrical resistivity of the sintered silver pattern for RS for 20 min does not change significantly after 6000 bending cycles. This work provides a new method to fabricate conductive patterns using micron silver flakes with the purpose of promoting the application of silver inks.

Halloysite@Polyaniline Nanoparticles Loaded with the Praseodymium (III) Cation for Improving Active Corrosion Protection of Waterborne Epoxy Coating.

The corrosion resistance of the waterborne epoxy coating is poor during long-term service, which greatly limits its widespread application. In this paper, the halloysite nanotubes (HNTs) were modified by polyaniline (PANI) and then used as nanocontainers to encapsulate the green corrosion inhibitor praseodymium (III) cations (Pr3+), obtaining HNTs@PANI@Pr3+ nanoparticles. A scanning electron microscope, transmission electron microscopy, energy dispersive spectroscopy, Fourier transform infrared spectroscopy, X-ray diffraction, and thermogravimetric analysis were applied to characterize the formation of PANI and the absorption of Pr3+ cations. The corrosion-inhibiting ability of the HNTs@PANI@Pr3+ nanoparticles for iron sheets and the anticorrosion properties of the nanocomposite coatings were evaluated by the electrochemical impedance spectroscopy technique. The results indicated that the coating containing HNTs@PANI@Pr3+ nanoparticles exhibited excellent anticorrosion performance. After immersion in 3.5 wt % NaCl solution for 50 days, its Zf=0.01 Hz value was still as high as 9.4 × 108 Ω cm2. The icorr value was 3 orders of magnitude lower than that of the pure WEP coating. The excellent anticorrosion property of the HNTs@PANI@Pr3+ coating could be attributed to the synergy of three beneficial factors, including evenly distributed nanoparticles, PANI, and Pr3+ cations. This research will provide theoretical and technical support for the development of waterborne coatings with high corrosion resistance.