All-fiber high-resolution incoherent broadband spectrometer.

Portable optical spectrometers are crucial devices for bio-chemical sensing and spectroscopic applications whereby robust, compact and cost-effective set-ups are desirable. However, existing miniaturized instruments typically struggle to achieve broad wavelength operation and high spectral resolution at the same time. Here, an all-fiber optical spectrometer based on two cascaded Bragg gratings is devised and demonstrated, showing a record resolution and a wavelength span-to-resolution ratio larger than that of most miniature broadband spectrometers reported to date. Thanks to a synchronous control of the grating lengths and to a unique combination of their reflection features, spectral analysis of incoherent light within 1 pm is achieved. On the other hand, fast and reproducible wavelength tuning over several nanometers on a millisecond-timescale is ensured by mechanical stretching of the internal fiber, limited only by the actuator's dynamic range. A striking evidence of the spectrometer capabilities is provided with Doppler-limited spectroscopy of gas absorption bands performed with a near-infrared LED source. The observed spectra exhibit lineshapes comparable with those obtained by laser-based set-ups and the retrieved gas-line parameters are in agreement with existing spectroscopic databases. The spectrometer lends itself to applications in high-resolution interrogation of multiple fiber-optic sensors as well as broadband imaging with supercontinuum light.

Fiber-optic gyroscope for rotational seismic ground motion monitoring of the Campi Flegrei volcanic area.

The real-time monitoring of densely populated areas with high seismic and volcanic risk is of crucial importance for the safety of people and infrastructures. When an earthquake occurs, the Earth surface experiences both translational and rotational motions. The latter are usually not monitored, but their measurement and characterization are essential for a full description of the ground motion. Here we present preliminary observational data of a high-sensitivity rotational sensor based on a 2-km-long fiber-optic Sagnac gyroscope, presently under construction in the middle of the Campi Flegrei Volcanic Area (Pozzuoli, Italy). We have evaluated its performance by analyzing data continuously recorded during an acquisition campaign of five months. The experimental setup was composed of a digital nine-component seismic station equipped with both a rotational sensor and conventional seismic sensors (seismometers, accelerometers, and tiltmeters). During this experiment we detected seismic noise and ground rotations wavefield induced by small to medium local earthquakes (M D<3). The prototype gyroscope shows a very promising sensitivity in the range of 5×10-7-8×10-9 r a d/s/H z over the frequency bandwidth 5 mHz-50 Hz. Future upgrades and perspectives are discussed.

Optrode-Assisted Multiparametric Near-Infrared Spectroscopy for the Analysis of Liquids.

We demonstrate a sensing scheme for liquid analytes that integrates multiple optical fiber sensors in a near-infrared spectrometer. With a simple optofluidic method, a broadband radiation is encoded in a time-domain interferogram and distributed to different sensing units that interrogate the sample simultaneously; the spectral readout of each unit is extracted from its output signal by a Fourier transform routine. The proposed method allows performing a multiparametric analysis of liquid samples in a compact setup where the radiation source, measurement units, and spectral readout are all integrated in a robust telecom optical fiber. An experimental validation is provided by combining a plasmonic nanostructured fiber probe and a transmission cuvette in the setup and demonstrating the simultaneous measurement of the absorption spectrum and the refractive index of water-methanol solutions.

Automatic Alignment Method for Controlled Free-Space Excitation of Whispering-Gallery Resonances.

Whispering-gallery mode microresonators have gained wide popularity as experimental platforms for different applications, ranging from biosensing to nonlinear optics. Typically, the resonant modes of dielectric microresonators are stimulated via evanescent wave coupling, facilitated using tapered optical fibers or coupling prisms. However, this method poses serious shortcomings due to fabrication and access-related limitations, which could be elegantly overcome by implementing a free-space coupling approach; although additional alignment procedures are needed in this case. To address this issue, we have developed a new algorithm to excite the microresonator automatically. Here, we show the working mechanism and the preliminary results of our experimental method applied to a home-made silica microsphere, using a visible laser beam with a spatial light modulator and a software control.

Liquid Droplet Microresonators.

We provide here an overview of passive optical micro-cavities made of droplets in the liquid phase. We focus on resonators that are naturally created and suspended under gravity thanks to interfacial forces, illustrating simple ways to excite whispering-gallery modes in various slow-evaporation liquids using free-space optics. Similar to solid resonators, frequency locking of near-infrared and visible lasers to resonant modes is performed exploiting either phase-sensitive detection of the leakage cavity field or multiple interference between whispering-gallery modes in the scattered light. As opposed to conventional micro-cavity sensors, each droplet acts simultaneously as the sensor and the sample, whereby the internal light can detect dissolved compounds and particles. Optical quality factors up to 107⁻108 are observed in liquid-polymer droplets through photon lifetime measurements. First attempts in using single water droplets are also reported. These achievements point out their huge potential for direct spectroscopy and bio-chemical sensing in liquid environments. Finally, the first experiments of cavity optomechanics with surface acoustic waves in nanolitre droplets are presented. The possibility to perform studies of viscous-elastic properties points to a new paradigm: a droplet device as an opto-fluid-mechanics laboratory on table-top scale under controlled environmental conditions.

Investigation of refractive index sensing based on Fano resonance in fiber Bragg grating ring resonators.

In this paper we theoretically investigate a ring resonant cavity obtained by closing on itself a π-shifted fiber Bragg grating, to be used for refractive index sensing applications. Differently from a conventional π-shifted fiber Bragg grating, the spectral structure of this cavity is characterized by an asymmetric splitting doublet composed by a right side resonance having an asymmetric Fano profile and a left side resonance having a symmetric Lorentzian profile. The right side resonance shows a narrower and sharper peak than all the other kinds of resonance achievable with both conventional ring resonators and π-shifted fiber Bragg gratings. A reduction of the resonant linewidth with respect to a conventional π-shifted Fiber Bragg grating and a fiber ring resonator, having the same physical parameters, is theoretically proved, achieving up to five orders of magnitude improvement with respect to the usual ring resonator. Due to these resonance features, the π-shifted Bragg grating ring resonator results suitable for RI sensing applications requiring extremely narrow resonances for high resolution measurements. In particular, by assuming a refractive index sensing to detect the presence of sugar in water, the sensor can show a theoretical resolution better than 10-9 RIU.

Ionizing radiation detectors based on Ge-doped optical fibers inserted in resonant cavities.

The measurement of ionizing radiation (IR) is a crucial issue in different areas of interest, from environmental safety and industrial monitoring to aerospace and medicine. Optical fiber sensors have recently proven good candidates as radiation dosimeters. Here we investigate the effect of IR on germanosilicate optical fibers. A piece of Ge-doped fiber enclosed between two fiber Bragg gratings (FBGs) is irradiated with gamma radiation generated by a 6 MV medical linear accelerator. With respect to other FBG-based IR dosimeters, here the sensor is only the bare fiber without any special internal structure. A near infrared laser is frequency locked to the cavity modes for high resolution measurement of radiation induced effects on the fiber optical parameters. In particular, we observe a variation of the fiber thermo-optic response with the radiation dose delivered, as expected from the interaction with Ge defect centers, and demonstrate a detection limit of 360 mGy. This method can have an impact in those contexts where low radiation doses have to be measured both in small volumes or over large areas, such as radiation therapy and radiation protection, while bare optical fibers are cheap and disposable.

Investigation of fiber Bragg grating based mode-splitting resonant sensors.

In this paper, we report on theoretical investigation of split mode resonant sensors based on fiber Bragg grating (FBG) ring resonators and π-shifted fiber Bragg grating (π-FBG) ring resonators. By using a π-shifted Bragg grating ring resonator (π-FBGRR) instead of a conventional fiber Bragg grating ring resonator (FBGRR), the symmetric and antisymmetric resonance branches (i.e., the eigen-modes of the perturbed system) show peculiar and very important features that can be exploited to improve the performance of the fiber optic spectroscopic sensors. In particular, the π-FBGRR symmetric resonance branch can be taylored to have a maximum splitting sensitivity to small environmental perturbations. This optimal condition has been found around the crossing points of the two asymmetric resonance branches, by properly choosing the physical parameters of the system. Then, high sensitivity splitting mode sensors are theoretically demonstrated showing, as an example, a strain sensitivity improvement of at least one order of magnitude over the state-of-the-art.

Musical instrument pickup based on a laser locked to an optical fiber resonator.

A low-noise transducer based on a fiber Fabry-Perot (FFP) cavity was used as a pickup for an acoustic guitar. A distributed feedback (DFB) laser was locked to a 25 MHz-wide resonance of the FFP cavity using the Pound-Drever-Hall method. The correction signal was used as the audio output and was preamplified and sampled at up to 96 kHz. The pickup system is largely immune against optical noise sources, exhibits a flat frequency response from the infrasound region to about 25 kHz, and has a distortion-free audio output range of about 50 dB.

High-resolution absolute frequency referenced fiber optic sensor for quasi-static strain sensing.

We present a quasi-static fiber optic strain sensing system capable of resolving signals below nanostrain from 20 mHz. A telecom-grade distributed feedback CW diode laser is locked to a fiber Fabry-Perot sensor, transferring the detected signals onto the laser. An H(13)C(14)N absorption line is then used as a frequency reference to extract accurate low-frequency strain signals from the locked system.

Optical fiber sensing based on reflection laser spectroscopy.

An overview on high-resolution and fast interrogation of optical-fiber sensors relying on laser reflection spectroscopy is given. Fiber Bragg-gratings (FBGs) and FBG resonators built in fibers of different types are used for strain, temperature and acceleration measurements using heterodyne-detection and optical frequency-locking techniques. Silica fiber-ring cavities are used for chemical sensing based on evanescent-wave spectroscopy. Various arrangements for signal recovery and noise reduction, as an extension of most typical spectroscopic techniques, are illustrated and results on detection performances are presented.

Continuous in situ measurements of volcanic gases with a diode-laser-based spectrometer: CO2 and H2O concentration and soil degassing at Vulcano (Aeolian islands: Italy).

We report on a continuous-measurement campaign carried out in Vulcano (Aeolian islands, Sicily), devoted to the simultaneous monitoring of CO2 and H2O concentrations. The measurements were performed with an absorption spectrometer based on a semiconductor laser source emitting around a 2-microm wavelength. The emitted radiation was selectively absorbed by two molecular ro-vibrational transitions specific of the investigated species. Data for CO2 and H2O concentrations, and CO2 soil diffusive flux using an accumulation chamber configuration, were collected at several interesting sampling points on the island (Porto Levante beach- PLB, Fossa Grande Crater - FOG- and Valley of Palizzi, PAL). CO2/H2O values, measured on the ground, are very similar (around 0.019 (+/- 0.006)) and comparable to the previous discrete detected values of 0.213 (Fumarole F5-La Fossa crater rim) and 0.012 (Fumarole VFS - Baia Levante beach) obtaid during the 1977-1993 heating phase of the crater fumaroles. In this work much more homogeneous values are found in different points of the three sites investigated. The field work, although carried out in a limited time window (25th-28th August 2004), pointed out the new apparatus is suitable for continuous gas monitoring of the two species and their ratios, which are important geochemical indicators of volcanic activity, for which other reliable continuous monitoring systems are not yet available.

A frequency-modulated quantum-cascade laser for spectroscopy of CH4 and N2O isotopomers.

We report the development of a novel laser spectrometer for high-sensitivity detection of methane and nitrous oxide. The system relies on a quantum-cascade laser source emitting wavelength of around 8.06 microm, where strong fundamental absorption bands occur for the considered species and their isotopomers. The detection technique is based on audio-frequency and radio-frequency modulation of laser radiation. First experimental tests have been performed to estimate the achievable detection limits and the signal reproducibility levels in view of possible measurements of (13)C/(12)C, (18)O/(16)O, (17)O/(16)O and (15)N/(14)N isotope ratios.

Spectral characterization of integrated acousto-optic tunable filters by means of laser frequency modulation spectroscopy.

The spectral characteristics of an integrated acousto-optic tunable filter (AOTF) as well as its responsivity to the rf driving signal and sensitivity to temperature changes are experimentally investigated and quantified using a diode-laser-based interrogation system. A spectroscopic technique, exploiting the rf frequency modulation of the laser beam and the phase-sensitive detection of the AOTF transmission, has been used for this purpose. That allows for the generation of a dispersivelike signal, which serves as a reference for tracking any wavelength change of the filter's peak with high resolution. The possibility of using the integrated AOTF as a spectrum analyzer with this interrogation scheme for fiber Bragg grating (FBG) strain sensing is also discussed.

Generation of tunable far-infrared radiation with a quantum cascade laser.

We demonstrate the generation of cw tunable far-infrared radiation by mixing a quantum cascade laser and a CO>(2) laser in a W-Ni metal-insulator-metal diode. The first known spectroscopic application to the recording of an H(79)Br transition near 4.47 THz is reported.