RESUMEN
Metal-organic framework-808 has been functionalized with 11 amino acids (AA) to produce a series of MOF-808-AA structures. The adsorption of CO2 under flue gas conditions revealed that glycine- and dl-lysine-functionalized MOF-808 (MOF-808-Gly and -dl-Lys) have the highest uptake capacities. Enhanced CO2 capture performance in the presence of water was observed and studied by using single-component sorption isotherms, CO2/H2O binary isotherm, and dynamic breakthrough measurements. The key to the favorable performance was uncovered by deciphering the mechanism of CO2 capture in the pores and attributed to the formation of bicarbonate as evidenced by 13C and 15N solid-state nuclear magnetic resonance spectroscopy studies. On the basis of these results, we examined the performance of MOF-808-Gly in simulated coal flue gas conditions and found that it is possible to capture and release CO2 by vacuum swing adsorption. MOF-808-Gly was cycled at least 80 times with full retention of performance. This study significantly advances our understanding of CO2 chemistry in MOFs by revealing how strongly bound amine moieties to the MOF backbone create the chemistry and environment within the pores, leading to the binding and release of CO2 under mild conditions without application of heat.
Asunto(s)
Aminoácidos/química , Dióxido de Carbono/química , Gases/química , Compuestos Organometálicos/química , Humedad , Incineración , Modelos Moleculares , Estructura MolecularRESUMEN
The binary adsorption of CO2 and water on an amine-functionalized UiO-66 metal-organic framework (MOF) was studied experimentally and computationally. Grand canonical Monte Carlo simulations were used to investigate three additional UiO-66 MOFs with different functionalized linkers. Each MOF was studied in a defect-free form as well as two additional forms with precise linker defects. Binary adsorption isotherms are presented for CO2 at specific water loadings. While water loading in defect-free MOFs reduces the CO2 uptake, the defects slightly boost the CO2 uptake at low water loadings. It was found that water bridges form between the metal oxide cores, replacing the missing linkers. Effectively, this creates smaller pores that are more welcoming of CO2 adsorption. Experimental measurement of the binary isotherms for UiO-66-NH2 shows a behavior that is consistent with this enhancement.
RESUMEN
Spinel ferrite magnetic nanoparticles, MnFe2O4, NiFe2O4, and CoFe2O4, were synthesized and used as gas-phase adsorbents for the removal of cyanogen chloride from dry air. Fixed-bed adsorption breakthrough experiments show adsorption wave behavior at the leading edge of the breakthrough curve that is not typical of physically adsorbed species. Fourier transform infrared spectroscopy (FTIR) results indicate that CK is reacting with the spinel ferrite surface and forming a carbamate species. The reaction is shown to be a function of the hydroxyl groups and adsorbed water on the surface of the particles as well as the metallic composition of the particles. The surface reaction decreases the remnant and saturation magnetism of the MnFe2O4 and CoFe2O4 particles by approximately 25%.
Asunto(s)
Cianuros/química , Compuestos Férricos/química , Nanopartículas de Magnetita/química , Adsorción , Propiedades de SuperficieRESUMEN
The structure of a molecule and its concentration can strongly influence diffusional properties for transport in nanoporous materials. We study mass transfer of alkanes in BPL activated carbon using the concentration-swing frequency response method, which can easily discriminate among mass transfer mechanisms. We measure concentration-dependent diffusion rates for n-hexane, n-octane, n-decane, 2,7-dimethyloctane, and cyclodecane, which have different carbon numbers and geometries: straight chain, branched chain, and cyclic. Micropore diffusion is determined to be the controlling mass transfer resistance except at low relative saturation for n-decane, where an external mass transfer resistance also becomes important, showing that the controlling mass transfer mechanism can change with system concentration. Micropore diffusion coefficients are found to be strongly concentration dependent. Adsorption isotherm slopes obtained from measured isotherms, the concentration-swing frequency response method, and a predictive method show reasonably good agreement.
Asunto(s)
Alcanos/química , Carbono/química , Adsorción , Presión , VolatilizaciónRESUMEN
[This corrects the article DOI: 10.1039/D0RA03220D.].
RESUMEN
The adsorption of ammonia on Zr(OH)(4), as well as Zr(OH)(4) treated with sulfuric acid, were examined. The results show that treating Zr(OH)(4) with sulfuric acid leads to the formation of a sulfate on the surface of the material, and that the sulfate contributes to the ammonia adsorption capacity through the formation of an ammonium sulfates species. Calcination of Zr(OH)(4) decreases the ammonia adsorption capacity of the material and limits the formation of sulfate species. NMR and FTIR spectroscopy results are presented that show the presence of two distinct ammonium species on the surface of the material. The adsorption capacity of the materials is shown to be a complex phenomenon that is impacted by the surface area, the sulfur content, and the pH of the material. The results illustrate that Zr(OH)(4), which is known to adsorb acidic gases, can be modified and used to adsorb basic gases.
Asunto(s)
Amoníaco/química , Hidróxidos/química , Ácidos Sulfúricos/química , Circonio/química , Adsorción , Concentración de Iones de Hidrógeno , Propiedades de SuperficieRESUMEN
Adsorption of sulfur dioxide on 10 nm CoFe(2)O(4) spinel ferrite nanoparticles was examined. Adsorption loadings of sulfur dioxide at breakthrough conditions were determined to be approximately 0.62 mol/kg, which is significant given the 150 m(2)/g surface area of the nanoparticles. Adsorption proceeds through a chemisorption mechanism with sulfur dioxide forming a sulfate upon adsorption on the particle surface, which leads to a 23% decrease in the remnant magnetization, a 20% decrease in the saturation magnetization, and a 9% decrease in the coercivity of the magnetic nanoparticles. Adsorbent materials that provide a magnetic signal when adsorption occurs could have broad implications on adsorption-based separations.
RESUMEN
Selective capture of CO(2), which is essential for natural gas purification and CO(2) sequestration, has been reported in zeolites, porous membranes, and amine solutions. However, all such systems require substantial energy input for release of captured CO(2), leading to low energy efficiency and high cost. A new class of materials named metal-organic frameworks (MOFs) has also been demonstrated to take up voluminous amounts of CO(2). However, these studies have been largely limited to equilibrium uptake measurements, which are a poor predictor of separation ability, rather than the more industrially relevant kinetic (dynamic) capacity. Here, we report that a known MOF, Mg-MOF-74, with open magnesium sites, rivals competitive materials in CO(2) capture, with 8.9 wt. % dynamic capacity, and undergoes facile CO(2) release at significantly lower temperature, 80 degrees C. Mg-MOF-74 offers an excellent balance between dynamic capacity and regeneration. These results demonstrate the potential of MOFs with open metal sites as efficient CO(2) capture media.
Asunto(s)
Dióxido de Carbono/aislamiento & purificación , Magnesio/química , Compuestos Orgánicos/química , Adsorción , Cristalografía por Rayos X , Metano/químicaRESUMEN
A novel technique for determining the relative accessibility and reactivity of basic surface hydroxyl sites by reacting various zirconium(IV) hydroxide materials with 2,2,2-trifluoroethanol (TFE) and characterizing the resulting material using (19)F magic angle spinning (MAS) nuclear magnetic resonance (NMR) is presented here. Studied here are three zirconium hydroxide samples, two unperturbed commercial materials, and one commercial material that is crushed by a pellet press. Factors, such as the ratio of bridging/terminal hydroxyls, surface area, and pore size distribution, are examined and found to affect the ability of the zirconium(IV) hydroxide to react with TFE. X-ray diffraction, nitrogen isotherms, and (1)H MAS NMR were used to characterize the unperturbed materials, while thermogravitric analysis with gas chromatography and mass spectrometry along with the (19)F MAS NMR were used to characterize the materials that were reacted with TFE. Zirconium hydroxide materials with a high surface area and a low bridging/terminal hydroxyl ratio were found to react TFE in the greatest amounts.
Asunto(s)
Flúor/química , Hidróxidos/química , Trifluoroetanol/química , Circonio/química , Espectroscopía de Resonancia Magnética , Modelos Moleculares , Estructura Molecular , Propiedades de SuperficieRESUMEN
Recent work by Wasserscheid, et al. suggests that PPh4 + is an organic molecular ion of truly exceptional thermal stability. Herein we provide data that cements that conclusion: specifically, we show that aliphatic moieties of modified PPh4 +-based cations incorporating methyl, methylene, or methine C-H bonds burn away at high temperatures in the presence of oxygen, forming CO, CO2, and water, leaving behind the parent ion PPh4 +. The latter then undergoes no further reaction, at least below 425 °C.
RESUMEN
The past decade has seen tremendous advances in both our understanding of cancer immunosuppressive microenvironments and colonic bacteria facilitated by immune checkpoint inhibitor antibodies and next generation sequencing, respectively. Because an important role of the host immune system is to communicate with and regulate the gut microbial community, it should not come as a surprise that the behavior of one is coupled to the other. In this review, we will attempt to dissect some of the studies demonstrating cancer immunotherapy modulation by specific gut microbes and discuss possible molecular mechanisms for this effect.
Asunto(s)
Microbioma Gastrointestinal/inmunología , Neoplasias/inmunología , Neoplasias/terapia , Animales , Humanos , Sistema Inmunológico/inmunología , Inmunoterapia/métodosRESUMEN
Sorbent-assisted water harvesting from air represents an attractive way to address water scarcity in arid climates. Hitherto, sorbents developed for this technology have exclusively been designed to perform one water harvesting cycle (WHC) per day, but the productivities attained with this approach cannot reasonably meet the rising demand for drinking water. This work shows that a microporous aluminum-based metal-organic framework, MOF-303, can perform an adsorption-desorption cycle within minutes under a mild temperature swing, which opens the way for high-productivity water harvesting through rapid, continuous WHCs. Additionally, the favorable dynamic water sorption properties of MOF-303 allow it to outperform other commercial sorbents displaying excellent steady-state characteristics under similar experimental conditions. Finally, these findings are implemented in a new water harvester capable of generating 1.3 L kgMOF -1 day-1 in an indoor arid environment (32% relative humidity, 27 °C) and 0.7 L kgMOF -1 day-1 in the Mojave Desert (in conditions as extreme as 10% RH, 27 °C), representing an improvement by 1 order of magnitude over previously reported devices. This study demonstrates that creating sorbents capable of rapid water sorption dynamics, rather than merely focusing on high water capacities, is crucial to reach water production on a scale matching human consumption.
RESUMEN
Covalent organic frameworks (COFs) are porous crystalline materials composed of light elements linked by strong covalent bonds. A number of these materials contain a high density of Lewis acid boron sites that can strongly interact with Lewis basic guests, which makes them ideal for the storage of corrosive chemicals such as ammonia. We found that a member of the covalent organic framework family, COF-10, shows the highest uptake capacity (15 mol kg⻹, 298 K, 1 bar) of any porous material, including microporous 13X zeolite (9 mol kg⻹), Amberlyst 15 (11 mol kg⻹) and mesoporous silica, MCM-41 (7.9 mol kg⻹). Notably, ammonia can be removed from the pores of COF-10 by heating samples at 200°C under vacuum. In addition, repeated adsorption of ammonia into COF-10 causes a shift in the interlayer packing, which reduces its apparent surface area to nitrogen. However, owing to the strong Lewis acid-base interactions, the total uptake capacity of ammonia and the structural integrity of the COF are maintained after several cycles of adsorption/desorption.
Asunto(s)
Amoníaco/química , Compuestos Orgánicos/química , Adsorción , PorosidadRESUMEN
A concentration-swing frequency response method is extended to examine mass transfer mechanisms and the concentration dependence of mass transfer rates for adsorption of condensable vapors in single adsorbent particles. The adsorption kinetics of water and hexane in BPL activated carbon and the adsorption of water in silica gel are determined at several different concentrations. The mechanism that best describes the adsorption of water in BPL activated carbon is nanopore diffusion. The diffusivity of water in BPL activated carbon has a clear minimum at approximately P/Po = 0.5, and the concentration dependence of the diffusion data are not described well by the Darken relationship. Both nanopore diffusion and the Glueckauf linear driving force models can be used to describe the diffusion of hexane in BPL activated carbon for the pressure range studied, and the dependence of the diffusivity on concentration can be described approximately using the Darken relationship. However, the diffusion of water in silica gel cannot be described by the nanopore diffusion model and is best characterized by the Glueckauf linear driving force model. The results illustrate the ability of concentration-swing frequency response to accurately determine adsorption rate mechanisms and quantify the complex adsorption kinetics of condensable vapors using small quantities of adsorbent.