RESUMEN
SignificancePhysical and chemical properties of individual atmospheric particles determine their climate impacts. Hygroscopic inorganic salt particles mixed with trace amounts of organic material are predicted to be liquid under typical tropospheric conditions in the summertime Arctic. Yet, we unexpectedly observed a significant concentration of solid particles composed of ammonium sulfate with an organic coating under conditions of high relative humidity and low temperature. These particle properties are consistent with marine biogenic-derived new particle formation and growth, with particle collision hypothesized to result in the solid phase. This particle source is predicted to have increasing relevance in the context of declining Arctic sea ice and increasing open water, with impacts on clouds, and therefore climate.
RESUMEN
A rare example of crystal form-dependent, gamma radiation-induced degradation is presented. Islatravir is known to exist in several polymorphic forms, but only one of these forms shows the generation of a specific dimer degradation product under gamma irradiation. Extended gamma irradiation studies demonstrated that only one of the known crystalline forms shows an appreciable rate of dimer formation. Additionally, this dimer is not observed to form under other forced stress conditions. We present the structural elucidation of this dimer impurity and rationalize its form-dependent generation based on the analysis of the underlying crystal structure.
Asunto(s)
Desoxiadenosinas , Desoxiadenosinas/química , Rayos gammaRESUMEN
Messenger RNA (mRNA) vaccines represent a landmark in vaccinology, especially with their success in COVID-19 vaccines, which have shown great promise for future vaccine development and disease prevention. As a platform technology, synthetic mRNA can be produced with high fidelity using in vitro transcription (IVT). Magnesium plays a vital role in the IVT process, facilitating the phosphodiester bond formation between adjacent nucleotides and ensuring accurate transcription to produce high-quality mRNA. The development of the IVT process has prompted key inquiries about in-process characterization of magnesium ion (Mg++) consumption, relating to the RNA polymerase (RNAP) activation, fed-batch mode production yield, and mRNA quality. Hence, it becomes crucial to monitor the free Mg++ concentration throughout the IVT process. However, no free Mg++ analysis method has been reported for complex IVT reactions. Here we report a robust capillary zone electrophoresis (CZE) method with indirect UV detection. The assay allows accurate quantitation of free Mg++ for the complex IVT reaction where it is essential to preserve IVT samples in their native-like state during analysis to avoid dissociation of bound Mg complexes. By applying this CZE method, the relationships between free Mg++ concentration, the mRNA yield, and dsRNA impurity level were investigated. Such mechanistic understanding facilitates informed decisions regarding the quantity and timing of feeding starting materials to increase the yield. Furthermore, this approach can serve as a platform method for analyzing the free Mg++ in complex sample matrices where preserving the native-like state of Mg++ binding is key for accurate quantitation.
Asunto(s)
Electroforesis Capilar , Magnesio , ARN Mensajero , Transcripción Genética , Electroforesis Capilar/métodos , Magnesio/análisis , ARN Mensajero/genética , ARN Mensajero/análisis , SARS-CoV-2/genética , HumanosRESUMEN
The rapid decrease in Arctic sea ice is motivating development and increasing oil and gas extraction activities. However, few observations of these local Arctic emissions exist, limiting the understanding of impacts on atmospheric composition and climate. To address this knowledge gap, the chemical composition of atmospheric aerosols was measured within the North Slope of Alaska oil fields during August and September 2016 using an aerosol time-of-flight mass spectrometer (ATOFMS) and a time-of-flight aerosol chemical speciation monitor (ToF-ACSM). Plumes from oil and gas extraction activities were characterized by soot internally mixed with sulfate (matching diesel soot) and organic carbon particles containing aminium sulfate salts. Sea spray aerosol at the coastal site was frequently internally mixed with sulfate and nitrate, from multiphase chemical processing from elevated NOx and SO2 within the oil field. Background (nonplume) air masses were characterized by aged combustion aerosol. No periods of "clean" (nonpolluted) Arctic air were observed. The composition of the nonrefractory aerosol measured with the ACSM was similar during plume and background periods and was consistent with the mass concentrations of nonrefractory particles measured by ATOFMS. Two ultrafine aerosol growth events were observed during oil field background periods and were correlated with fine mode amine-containing particles.
Asunto(s)
Contaminantes Atmosféricos , Hollín , Aerosoles , Alaska , Aminas , Monitoreo del Ambiente , Yacimiento de Petróleo y Gas , Tamaño de la Partícula , Sulfatos , Ésteres del Ácido SulfúricoRESUMEN
In freshwater lakes, harmful algal blooms (HABs) of Cyanobacteria (blue-green algae) produce toxins that impact human health. However, little is known about the lake spray aerosol (LSA) produced from wave-breaking in freshwater HABs. In this study, LSA were produced in the laboratory from freshwater samples collected from Lake Michigan and Lake Erie during HAB and nonbloom conditions. The incorporation of biological material within the individual HAB-influenced LSA particles was examined by single-particle mass spectrometry, scanning electron microscopy with energy-dispersive X-ray spectroscopy, and fluorescence microscopy. Freshwater with higher blue-green algae content produced higher number fractions of individual LSA particles that contained biological material, showing that organic molecules of biological origin are incorporated in LSA from HABs. The number fraction of individual LSA particles containing biological material also increased with particle diameter (greater than 0.5 µm), a size dependence that is consistent with previous studies of sea spray aerosol impacted by phytoplankton blooms. Similar to sea spray aerosol, organic carbon markers were most frequently observed in individual LSA particles less than 0.5 µm in diameter. Understanding the transfer of biological material from freshwater to the atmosphere via LSA is crucial for determining health and climate effects of HABs.
Asunto(s)
Floraciones de Algas Nocivas , Lagos , Aerosoles , Humanos , Michigan , FitoplanctonRESUMEN
Ion Chromatography (IC) is one of the most widely used methods for analyzing ionic species in pharmaceutical samples. A universal IC method that can separate a wide range of different analytes is highly desired as it can save a lot of time for method development and validation processes. Herein we report the development of a universal method for anions in active pharmaceutical ingredients (APIs) using computer-assisted chromatography modeling tools. We have screened three different IC columns (Dionex IonPac AS28-Fast 4 µm, AS19 4 µm and AS11-HC 4 µm) to determine the best suitable column for universal IC method development. A universal IC method was then developed using an AS11-HC 4 µm column to separate 31 most common anionic substances in 36 mins. This method was optimized using LC Simulator and a model which precisely predicts the retention behavior of 31 anions was established. This model demonstrated an excellent match between predicted and experimental analyte retention time (R2 =0.999). To validate this universal IC method, we have studied the stability of sulfite and sulfide analytes in ambient conditions. The method was then validated for a subset of 29 anions using water and organic solvent/water binary solvents as diluents for commercial APIs. This universal IC method provides an efficient and simple way to separate and analyze common anions in APIs. In addition, the method development process combined with LC simulator modeling can be effectively used as a starting point during method development for other ions beyond those investigated in this study.
Asunto(s)
Medicamentos a Granel , Agua , Cromatografía por Intercambio Iónico/métodos , Aniones/química , Iones , Solventes/análisis , ComputadoresRESUMEN
Biocatalytic processes have become more prevalent in the pharmaceutical industry, leading to analytical challenges not faced when characterizing more traditional synthetic routes. A novel one-pot biocatalytic process has been established for Islatravir, an HIV reverse transcriptase translocation inhibitor for the treatment and prevention of HIV-1. As a one-pot reaction, the Islatravir chemistry contains multiple intermediates that are not isolated. Additionally, these unisolated intermediates have no chromophores, making traditional LC-UV techniques ineffective for characterization. A hydrophilic interaction chromatography (HILIC) method with a charged aerosol detector (CAD) was initially developed, however numerous inorganic species present in the one-pot reaction were retained; this led to co-elution of compounds and poor peak shapes. An innovative ion-pairing LC method was developed in order to resolve inorganic species, intermediates, and the API, for use during in-process control of the Islatravir biocatalytic reaction. Aided by a volatile ion-pairing reagent compatible with the CAD, this method successfully retains and resolves the highly polar intermediates of interest and Islatravir API. This novel method was successfully validated and has allowed the Islatravir biocatalytic process to be fully characterized from the early intermediates through the final API within the one-pot reaction without the need for isolations. This novel ion-pairing HPLC-CAD technique lays the groundwork for method development on current and future biocatalytic-produced drug substances.
Asunto(s)
Desoxiadenosinas , Aerosoles , Cromatografía Líquida de Alta Presión/métodos , Interacciones Hidrofóbicas e HidrofílicasRESUMEN
As the Arctic continues to change and warm rapidly, it is increasingly important to understand the organic carbon (OC) contribution to Arctic aerosol. Biogenic sources of primary and secondary OC in the Arctic will be impacted by climate change, including warming temperatures and earlier snow and ice melt. This study focuses on identifying potential sources and regional influences on the seasonal concentration of organic aerosol through analysis of chemical and isotopic composition. Aerosol samples were collected at two sites on the North Slope of Alaska (Utqiagvik, UQK, and Oliktok Point, OLK, which is in an Arctic oilfield) over three summers from 2015 to 2017. The elemental carbon (EC) trends at each site were used to understand local combustion influences. Local sources drove EC concentrations at Oliktok Point, where high EC was attributed to oil and gas extraction activity, including diesel combustion emissions. Utqiagvik had very low EC in the summer. OC was more similar in concentration and well correlated between the two sites with high contributions of contemporary carbon by radiocarbon apportionment (UQK = 74%, OLK = 63%), which could include both marine and terrestrial sources of contemporary carbon (e.g. primary and secondary biogenic, biomass burning and/or associated SOA, and bioaerosols). OC concentrations are strongly correlated to maximum ambient temperatures on the NSA during the summer, which may have implications for predicting future OC aerosol concentrations in a warming Arctic. Biomass burning was determined to be an episodic influence at both sites, based on interpretation of combined aerosol composition, air mass trajectories, and remote sensing of smoke plumes. The results from this study overall strongly suggests contribution from regional sources of contemporary organic aerosol on the NSA, but additional analysis is needed to better constrain contributions from both biogenic sources (terrestrial and/or marine) and bioaerosol to better understand temperature-related aerosol processes in the Arctic.
Asunto(s)
Contaminantes Atmosféricos , Material Particulado , Aerosoles/análisis , Contaminantes Atmosféricos/análisis , Alaska , Biomasa , Carbono/análisis , Monitoreo del Ambiente/métodos , Material Particulado/análisis , Estaciones del AñoRESUMEN
Inland sources of particulate chloride for atmospheric nitryl chloride (ClNO2) formation remain unknown and unquantified, hindering air quality assessments. Globally each winter, tens of millions of tons of road salt are spread on roadways for deicing. Here, we identify road salt aerosol as the primary chloride aerosol source, accounting for 80-100% of ClNO2 formation, at an inland urban area in the wintertime. This study provides experimental evidence of the connection between road salt and air quality through the production of this important reservoir for nitrogen oxides and chlorine radicals, which significantly impact atmospheric composition and pollutant fates. A numerical model was employed to quantify the contributions of chloride sources to ClNO2 production. The traditional method for simulating ClNO2 considers chloride to be homogeneously distributed across the atmospheric particle population; yet, we show that only a fraction of the particulate surface area contains chloride. Our new single-particle parametrization considers this heterogeneity, dramatically lowering overestimations of ClNO2 levels that have been routinely reported using the prevailing methods. The identification of road salt as a ClNO2 source links this common deicing practice to atmospheric composition and air quality in the urban wintertime environment.