Arabidopsis pollen-specific glycerophosphodiester phosphodiesterase-like genes are essential for pollen tube tip growth.

In angiosperms, pollen tube growth is critical for double fertilization and seed formation. Many of the factors involved in pollen tube tip growth are unknown. Here, we report the roles of pollen-specific GLYCEROPHOSPHODIESTER PHOSPHODIESTERASE-LIKE (GDPD-LIKE) genes in pollen tube tip growth. Arabidopsis thaliana GDPD-LIKE6 (AtGDPDL6) and AtGDPDL7 were specifically expressed in mature pollen grains and pollen tubes and green fluorescent protein (GFP)-AtGDPDL6 and GFP-AtGDPDL7 fusion proteins were enriched at the plasma membrane at the apex of forming pollen tubes. Atgdpdl6 Atgdpdl7 double mutants displayed severe sterility that was rescued by genetic complementation with AtGDPDL6 or AtGDPDL7. This sterility was associated with defective male gametophytic transmission. Atgdpdl6 Atgdpdl7 pollen tubes burst immediately after initiation of pollen germination in vitro and in vivo, consistent with the thin and fragile walls in their tips. Cellulose deposition was greatly reduced along the mutant pollen tube tip walls, and the localization of pollen-specific CELLULOSE SYNTHASE-LIKE D1 (CSLD1) and CSLD4 was impaired to the apex of mutant pollen tubes. A rice pollen-specific GDPD-LIKE protein also contributed to pollen tube tip growth, suggesting that members of this family have conserved functions in angiosperms. Thus, pollen-specific GDPD-LIKEs mediate pollen tube tip growth, possibly by modulating cellulose deposition in pollen tube walls.

Cas9/gRNA-Mediated Mutations in PtrFLA40 and PtrFLA45 Reveal Redundant Roles in Modulating Wood Cell Size and SCW Synthesis in Poplar.

Fasciclin-like arabinogalactan proteins (FLAs) play an important role in plant development and adaptation to the environment. However, the roles of FLAs in wood formation remain poorly understood. Here, we identified a total of 50 PtrFLA genes in poplar. They were classified into four groups: A to D, among which group A was the largest group with 28 members clustered into four branches. Most PtrFLAs of group A were dominantly expressed in developing xylem based on microarray and RT-qPCR data. The roles of PtrFLA40 and PtrFLA45 in group A were investigated via the Cas9/gRNA-induced mutation lines. Loss of PtrFLA40 and PtrFLA45 increased stem length and diameter in ptrfla40ptrfla45 double mutants, but not in ptrfla40 or ptrfla45 single mutants. Further, our findings indicated that the ptrfla40ptrfla45 mutants enlarged the cell size of xylem fibers and vessels, suggesting a negative modulation in stem xylem cell size. In addition, wood lignin content in the ptrfla40fla45 mutants was increased by nearly 9%, and the lignin biosynthesis-related genes were significantly up-regulated in the ptrfla40fla45 mutants, in agreement with the increase in wood lignin content. Overall, Cas9/gRNA-mediated mutations in PtrFLA40 and PtrFLA45 reveal redundant roles in modulating wood cell size and secondary cell wall (SCW) synthesis in poplar.

Investigation of synergistic effects and high performance of La-Co composite oxides for toluene catalytic oxidation at low temperature.

Cobalt oxides have been considered as a kind of highly efficient catalyst for the oxidation of volatile organic compounds (VOCs). In this work, lanthanum-cobalt composite oxides were prepared by using the co-precipitation method, and toluene was used as the model compound. Diversified techniques including XRD, SEM, Raman spectra, XPS, H2-TPR, and N2 adsorption-desorption were applied to investigate the physicochemical properties of as-prepared materials. The composite catalysts showed different morphology including larger specific surface area and higher pore volume which would accelerate the adsorption of toluene and improve the amount of active sites on surface. Moreover, the addition of lanthanum could enhance the low-temperature reducibility, and it could be also beneficial to expose more Co3+ and adsorbed oxygen species on the surface of catalysts which could accelerate the oxidation of toluene and lower onset oxidation temperature. 0.05La-Co (with a molar ratio of lanthanum against cobalt is 0.05) showed the best catalytic performance. The complete conversion of toluene was achieved at 225 °C under the condition of toluene concentration = 1000 ppm and SV = 20,000 ml·g-1·h-1. Stability test over 0.05La-Co was conducted at 225 °C and it could maintain the 100% conversion of toluene for 720 min, indicating the excellent stability of as-prepared catalysts. Undoubtedly, lanthanum-cobalt composite oxide is a kind of promising material for the catalytic oxidation of VOCs.