Three-micrometer-diameter needle electrode with an amplifier for extracellular in vivo recordings.

Microscale needle-electrode devices offer neuronal signal recording capability in brain tissue; however, using needles of smaller geometry to minimize tissue damage causes degradation of electrical properties, including high electrical impedance and low signal-to-noise ratio (SNR) recording. We overcome these limitations using a device assembly technique that uses a single needle-topped amplifier package, called STACK, within a device of ∼1 × 1 mm2 Based on silicon (Si) growth technology, a <3-µm-tip-diameter, 400-µm-length needle electrode was fabricated on a Si block as the module. The high electrical impedance characteristics of the needle electrode were improved by stacking it on the other module of the amplifier. The STACK device exhibited a voltage gain of >0.98 (-0.175 dB), enabling recording of the local field potential and action potentials from the mouse brain in vivo with an improved SNR of 6.2. Additionally, the device allowed us to use a Bluetooth module to demonstrate wireless recording of these neuronal signals; the chronic experiment was also conducted using STACK-implanted mice.

Nanoneedle-Electrode Devices for In Vivo Recording of Extracellular Action Potentials.

Microscale needle-like electrode technologies offer in vivo extracellular recording with a high spatiotemporal resolution. Further miniaturization of needles to nanoscale minimizes tissue injuries; however, a reduced electrode area increases electrical impedance that degrades the quality of neuronal signal recording. We overcome this limitation by fabricating a 300 nm tip diameter and 200 µm long needle electrode where the amplitude gain with a high-impedance electrode (>15 MΩ, 1 kHz) was improved from 0.54 (-5.4 dB) to 0.89 (-1.0 dB) by stacking it on an amplifier module of source follower. The nanoelectrode provided the recording of both local field potential (<300 Hz) and action potential (>500 Hz) in the mouse cortex, in contrast to the electrode without the amplifier. These results suggest that microelectrodes can be further minimized by the proposed amplifier configuration for low-invasive recording and electrophysiological studies in submicron areas in tissues, such as dendrites and axons.

A Magnetically Assembled High-Aspect-Ratio Needle Electrode for Recording Neuronal Activity.

Microelectrode devices, which enable the detection of neuronal signals in brain tissues, have made significant contributions in the field of neuroscience and the brain-machine interfaces. To further develop such microelectrode devices, the following requirements must be met: i) a fine needle's diameter (<30 µm) to reduce damage to tissues; ii) a long needle (e.g., ≈1 mm for rodents and ≈2 mm for macaques); and iii) multiple electrodes to achieve high spatial recording (<100 µm in pitch). In order to meet these requirements, this study herein reports an assembly technique for high-aspect-ratio microneedles, which employs a magnet. The assembly is demonstrated, in which nickel wires of length 750 µm and diameter 25 µm are produced on a silicon substrate. The impedance magnitude of the assembled needle-like electrode measured at 1 kHz is 5.6 kΩ, exhibiting output and input signal amplitudes of 96.7% at 1 kHz. To confirm the recording capability of the fabricated device, neuronal signal recordings are performed using mouse cerebra in vivo. The packaged single microneedle electrode penetrates the barrel field in the primary somatosensory cortex of the mouse and enables the detection of evoked neuronal activity of both local field potentials and action potentials.