High-speed phase-shifting interferometry using triangular prism for time-resolved temperature measurement.

This study proposes a high-speed phase-shifting interferometer with an original optical prism. This phase-shifting interferometer consists of a polarizing Mach-Zehnder interferometer, an original optical prism, a high-speed camera, and an image-processing unit for a three-step phase-shifting technique. The key aspect of the application of the phase-shifting technique to high-speed experiments is an original prism, which is designed and developed specifically for a high-speed phase-shifting technique. The arbaa prism splits an incident beam into four output beams with different information. The interferometer was applied for quantitative visualization of transient heat transfer. In order to test the optical system for measuring high-speed phenomena, the temperature during heat conduction was measured around a heated thin tungsten wire (diameter of 5 µm) in water. The visualization area is approximately 90 µm×210 µm, and the spatial resolution is 3.5 µm at 300,000 fps of the maximum temporal resolution with a high-speed camera. The temperature fields around the heated wire were determined by converting phase-shifted data using the inverse Abel transform. Finally, the measured temperature distribution was compared with numerical calculations to validate the proposed system; a good agreement was obtained.

24-gauge ultrafine cryoprobe with diameter of 550 µm and its cooling performance.

This paper describes the development of a novel cryoprobe with the same size as a 24-gauge injection needle and the evaluation of its cooling performance. This ultrafine cryoprobe was designed to reduce the invasiveness and extend application areas of cryosurgery. The ultrafine cryoprobe has a double-tube structure and consists of two stainless steel microtubes. The outer diameter of the cryoprobe is 550 µm, and the inner tube has a 70-µm inner diameter to depressurize the high-pressure refrigerant. By solving the bioheat transfer equation and considering freezing phenomena, the relationship between the size of the frozen region and the heat transfer coefficient of the refrigerant flow in an ultrafine cryoprobe was derived analytically. The results showed that the size of the frozen region is strongly affected by the heat transfer coefficient. A high heat transfer coefficient such as that of phase change heat transfer is required to generate a frozen region of sufficient size. In the experiment, trifluoromethane (HFC-23) was used as the refrigerant, and the cooling effects of the gas and liquid phase states at the inlet were evaluated. When the ultrafine cryoprobe was cooled using a liquid refrigerant, the surface temperature was approximately -50°C, and the temperature distribution on the surface was uniform for a thermally insulated condition. However, for the case with vaporized refrigerant, the temperature distribution was not uniform. Therefore, it was concluded that the cooling mechanism using liquid refrigerant was suitable for ultrafine cryoprobes. Furthermore, to simulate cryosurgery, a cooling experiment using hydrogel was conducted. The results showed that the surface temperature of the ultrafine cryoprobe reached -35°C and formed a frozen region with a radius of 4 mm in 4 min. These results indicate that the ultrafine cryoprobe can be applied in actual cryosurgeries for small affected areas.

Measurement of Soret and Fickian diffusion coefficients by orthogonal phase-shifting interferometry and its application to protein aqueous solutions.

We have developed a method to measure thermodiffusion and Fickian diffusion in transparent binary solutions. The measuring instrument consists of two orthogonally aligned phase-shifting interferometers coupled with a single rotating polarizer. This high-resolution interferometer, initially developed to measure isothermal diffusion coefficients in liquid systems [J. F. Torres, A. Komiya, E. Shoji, J. Okajima, and S. Maruyama, Opt. Lasers Eng. 50, 1287 (2012)], was modified to measure transient concentration profiles in binary solutions subject to a linear temperature gradient. A convectionless thermodiffusion field was created in a binary solution sample that is placed inside a Soret cell. This cell consists of a parallelepiped cavity with a horizontal cross-section area of 10 × 20 mm(2), a variable height of 1-2 mm, and transparent lateral walls. The small height of the cell reduces the volume of the sample, shortens the measurement time, and increases the hydrodynamic stability of the system. An additional free diffusion experiment with the same optical apparatus provides the so-called contrast factors that relate the unwrapped phase and concentration gradients, i.e., the measurement technique is independent and robust. The Soret coefficient is determined from the concentration and temperature differences between the upper and lower boundaries measured by the interferometer and thermocouples, respectively. The Fickian diffusion coefficient is obtained by fitting a numerical solution to the experimental concentration profile. The method is validated through the measurement of thermodiffusion in the well-known liquid pairs of ethanol-water (ethanol 39.12 wt.%) and isobutylbenzene-dodecane (50.0 wt.%). The obtained coefficients agree with the literature values within 5.0%. Finally, the developed technique is applied to visualize biomolecular thermophoresis. Two protein aqueous solutions at 3 mg∕ml were used as samples: aprotinin (6.5 kDa)-water and lysozyme (14.3 kDa)-water. It was found that the former protein molecules are thermophilic and the latter thermophobic. In contrast to previously reported methods, this technique is suitable for both short time and negative Soret coefficient measurements.

Graphene Oxide-Gold Nanorods Nanocomposite-Porphyrin Conjugate as Promising Tool for Cancer Phototherapy Performance.

The cancer mortality rate has increased, and conventional cancer treatments are known for having many side effects. Therefore, it is imperative to find a new therapeutic agent or modify the existing therapeutic agents for better performance and efficiency. Herein, a synergetic phototherapeutic agent based on a combination of photothermal and photodynamic therapy is proposed. The phototherapeutic agent consists of water-soluble cationic porphyrin (5,10,15,20-tetrakis(N-methylpyridinium-3-yl)porphyrin, TMePyP), and gold nanorods (AuNRs) anchored on graphene-oxide (GO) sheet. The TMePyP was initially synthesized by Adler method, followed by methylation, while GO and AuNRs were synthesized using Hummer's and seed-mediated methods, respectively. The structural and optical properties of TMePyP were confirmed using UV-Vis, zeta analyzer, PL, FTIR and NMR. The formation of both GO and AuNRs was confirmed by UV-Vis-NIR, FTIR, TEM and zeta analyzer. TMePyP and AuNRs were anchored on GO to form GO@AuNRs-TMePyP nanocomposite. The as-synthesized nanocomposite was stable in RPMI and PBS medium, and, on irradiation, produced high heat than the bare AuNRs, with high photothermal efficiency. In addition, the nanocomposite produced higher singlet oxygen than TMePyP with high biocompatibility in the absence of light. These results indicated that the as-synthesized nanocomposite is a promising dual photodynamic and photothermal agent for cancer therapy.

Development and estimation of a novel cryoprobe utilizing the Peltier effect for precise and safe cryosurgery.

We have developed a novel cryoprobe for skin cryosurgery utilizing the Peltier effect. The four most important parameters for necrotizing tissue efficiently are the cooling rate, end temperature, hold time and thawing rate. In cryosurgery for small skin diseases such as flecks or early carcinoma, it is also important to control the thickness of the frozen region precisely to prevent necrotizing healthy tissue. To satisfy these exacting conditions, we have developed a novel cryoprobe to which a Peltier module was attached. The cryoprobe makes it possible to control heat transfer to skin surface precisely using a proportional-integral-derivative (PID) controller, and because it uses the Peltier effect, the cryoprobe does not need to move during the operation. We also developed a numerical simulation method that allows us to predict the frozen region and the temperature profile during cryosurgery. We tested the performance of our Peltier cryoprobe by cooling agar, and the results show that the cryoprobe has sufficient cooling performance for cryosurgery, because it can apply a cooling rate of more than 250 degrees C/min until the temperature reaches -40 degrees C. We also used a numerical simulation to reconstruct the supercooling phenomenon and examine the immediate progress of the frozen region with ice nucleation. The calculated frozen region was compared with the experimentally measured frozen region observed by an interferometer, and the calculation results showed good agreement. The results of numerical simulation confirmed that the frozen region could be predicted accurately with a margin of error as small as 150 microm during use of the cryoprobe in cryosurgery. The numerical simulation also showed that the cryoprobe can control freezing to a depth as shallow as 300 microm.

The effect of contact force during radiofrequency catheter ablation using a vibrating catheter: New cooling method for catheter ablation.

BACKGROUND: A new cooling method is proposed for preventing electrode-tissue overheating during cardiac catheter ablation using a vibrating catheter. Previous work has shown that vibration that results from increased flow velocity around the catheter can have a cooling effect on the electrode. OBJECTIVE: Contact force has been shown to be an important factor that affects cooling and lesion formation, because contact force determines the ratio of power delivery between blood and tissue. In this study, the effect of contact force on electrode cooling and tissue heating was investigated during the operation of an electrode cooled by vibration. METHODS: Using PVA-H or myocardium ablation tissue models under conditions of no flow, electrode and tissue temperatures and lesion sizes were measured at various vibrational frequencies and contact force conditions. RESULTS: The experiments showed that the catheter vibration still decreases the electrode temperature over a contact force range of 2-30 gf. The lesion size was increased with increasing contact force at each vibrational frequency. CONCLUSIONS: Increasing contact force can increase lesion size with cooling by vibration remaining effective.

Computer simulation for postmortem cooling processes in the outer ear.

INTRODUCTION: A simulation using a computer model was undertaken to investigate postmortem cooling patterns in the outer ear. METHODS: Cooling patterns were analyzed using a 3-dimensional head model built from brain CT images of a volunteer. The simulation was verified with a case subject under constant environmental conditions to obtain an appropriate heat transmission coefficient. RESULTS: The cooling pattern of the head model agreed with that of the case subject when the heat transmission coefficient was 6W/m(2) degrees C, and it could be approximated to a single exponential curve. DISCUSSION: This is the first simulative study to show the postmortem cooling pattern of the head of an adult human. Our head model will prove useful to predict the cooling patterns of not only the outer ear but also of the entirety of the head.

Treatment of tumor in lymph nodes using near-infrared laser light-activated thermosensitive liposome-encapsulated doxorubicin and gold nanorods.

Tumor metastasis to lymph nodes is an important contributory factor for cancer-related deaths despite recent developments in cancer therapy. In this study, we demonstrate that tumor in the proper axillary lymph node (PALN) of the mouse can be treated by the application of external laser light to trigger the unloading of doxorubicin (DOX) encapsulated in thermosensitive liposomes (TSLs) administered together with gold nanorods (GNRs). GNRs + DOX-TSLs were injected into a mouse lymph node containing cancer cells (malignant fibrous histiocytoma-like cells) and intranodal DOX release was activated using near-infrared (NIR) laser irradiation. The temperature changes arising from the laser-irradiated GNRs triggered the release of DOX from the TSLs. A greater degree of inhibition of tumor growth was found in the co-therapy group compared to the other groups. The treatment effect was achieved by a combination of chemotherapy and NIR-activated hyperthermia. In vivo bioluminescence imaging and histological analysis confirmed tumor necrosis in response to combined treatment. This work presents a theranostic approach with excellent treatment results that has the potential to be developed into an alternative to surgery for the treatment of breast cancer metastasis.

A novel treatment for metastatic lymph nodes using lymphatic delivery and photothermal therapy.

Systemic delivery of an anti-cancer agent often leads to only a small fraction of the administered dose accumulating in target sites. Delivering anti-cancer agents through the lymphatic network can achieve more efficient drug delivery for the treatment of lymph node metastasis. We show for the first time that polymeric gold nanorods (PAuNRs) can be delivered efficiently from an accessory axillary lymph node to a tumor-containing proper axillary lymph node, enabling effective treatment of lymph node metastasis. In a mouse model of metastasis, lymphatic spread of tumor was inhibited by lymphatic-delivered PAuNRs and near-infrared laser irradiation, with the skin temperature controlled by cooling. Unlike intravenous injection, lymphatic injection delivered PAuNRs at a high concentration within a short period. The results show that lymphatic administration has the potential to deliver anti-cancer agents to metastatic lymph nodes for inhibition of tumor growth and could be developed into a new therapeutic method.

Transition from multiplicity to singularity of steady natural convection in a tilted cubical enclosure.

The transition from the complex Rayleigh-Bénard convection to the simple heated-from-the-sides configuration in a cubical cavity filled with a Newtonian fluid is numerically studied. The cavity is tilted by an angle θ around its lower horizontal edge and is heated and cooled from two opposite tilted sides. We first analyze the effect of a marginal inclination angle on quasi-Rayleigh-Bénard convection (θ≈0∘), which is a realistic physical approximation to the ideal Rayleigh-Bénard convection. We then yield the critical angles where multiple solutions that were initially found for θ≈0∘ disappear, eventually resulting in the single steady roll solution found in the heated-from-the-sides configuration (θ=90∘). We confirm the existence of critical angles during the transition θ:0∘→90∘, and we demonstrate that such angles are a consequence of either singularities or collisions of bifurcation points in the Rayleigh-number-θ parameter space. We finally derive the most important critical angles corresponding to any Newtonian fluid of Prandtl number greater than that of air.

Effects of rounding errors on postmortem temperature measurements caused by thermometer resolution.

Beginning 7 h after death, a datalogger was used to measure the temperature in the external auditory canal of an adult male body placed in a refrigerated room. The sequence of measured values approximated a single exponential function with a correlation coefficient of 0.998475. This suggests that the starting time of body cooling in the refrigerated room under constant temperature can be calculated with less error using any two data points recorded by the datalogger. However, the results of such calculations varied widely and longer postmortem intervals demonstrated greater calculation errors. Periodic errors also appeared. Mathematical simulations showed that this variation was caused by rounding errors, which represent the difference between the thermometer readings and the true temperature. The resolution of the thermometer was 0.1 degrees C, a normal specification; however, even this led to noticeable rounding errors. Therefore, significant errors may influence postmortem interval estimations using other body temperatures. When body temperatures are used to determine the time of death, a method that minimizes rounding errors should be considered.