Quantitative Analysis of the Volar Ulnar Corner of the Distal Radius: A Reference for Intraoperative Distal Radius Fracture Reduction.

PURPOSE: The reduction of distal radius fractures using volar locking plate fixation can be performed by securing the plate to the distal fragments and then levering the plate to the radial shaft. Oblique placement of the plate on the radial shaft may lead to malreduction. The aim of this study was to evaluate parameters that can be used for the assessment of intraoperative distal radius fracture reduction using "distal-first" volar plate fixation, especially the geometry of the ulnar corner. The prevalence of Tolat distal radioulnar joint (DRUJ) types was determined, and the angles of the volar corner were quantitatively described. METHODS: Three hundred seventy-five adult patients with a conventional wrist radiograph in their medical chart were identified. From this cohort, 50 radiographs of each Tolat DRUJ type were quantitatively analyzed using 4 angles. The probability density of each angle was described using Kernel density estimation graphs. A multivariable analysis was used to study the association between the 4 angles and Tolat DRUJ types and other patient factors. RESULTS: One hundred fifty-one patients (40%) had a wrist with type 1 DRUJ, 147 (39%) had a wrist with type 2 DRUJ, and 77 (21%) had a wrist with type 3 DRUJ. The measurements of the distal ulnar corner, volar ulnar corner, and DRUJ angulation were significantly different among each Tolat DRUJ type. The median lunate facet inclination, relative to the axis of the radial shaft, measured 14° (interquartile range, 12°-16°) across all the Tolat DRUJ types. CONCLUSIONS: The prevalence of Tolat type 1, 2, and 3 DRUJ was 40%, 39%, and 21%, respectively. The angles of the volar ulnar corner varied with each DRUJ type. CLINICAL RELEVANCE: Because the lunate facet inclination was relatively consistent among all the Tolat DRUJ types, this angle may be useful as a reference for "distal-first" distal radius volar plating.

Anterior locking plate fixation versus cast immobilization for acceptably reduced extra- articular distal radial fractures: long-term follow-up of a randomized controlled trial.

This study reports the long-term results of a randomized controlled trial comparing anterior locking plate fixation with cast immobilization for extra-articular distal radial fractures. After 5.3 years of follow-up, no clinically relevant functional differences were found.

Concomitant ligament injuries can be left untreated during surgery of distal radial fractures.

Instability of the distal radioulnar joint and scapholunate dissociation may cause pain, functional impairment and subsequent arthrosis. There is no consensus about whether these injuries should be treated acutely in patients undergoing surgery for distal radial fractures. We conducted a prospective cohort study to determine whether concomitant distal radioulnar joint instability or scapholunate dissociation negatively influence patient-related outcomes in these patients. The primary outcome was the patient-reported wrist/hand evaluation at 6 and 12 months after surgery. Out of 62 patients, 58% and 27% had intraoperative distal radioulnar joint instability and scapholunate dissociation, respectively. No significant differences were found in patient-reported scores at follow-up between patients with stable and unstable distal radioulnar joints, nor between patients with and without scapholunate dissociation. Sixty-three per cent of patients with an unstable distal radioulnar joint during surgery were stable on retesting after 6 months. Our study suggests that a wait-and-see policy in these patients therefore seems reasonable.Level of evidence: III.

Comparison of extra-articular radiographic parameters of distal radius fractures on plain radiographs and CT scans.

The aim of this study was to compare extra-articular radiographic parameters of distal radial fractures measured on plain radiographs and CT scans. Two researchers independently measured four extra-articular radiographic parameters (dorsal tilt, carpal alignment, radial inclination and ulnar variance) on both radiographs and CT scans in 85 patients. Inter-observer reliability for both techniques was assessed, along with the agreement between CT scans and radiographs using the intraclass correlation coefficient and Bland-Altman plots. The results showed that dorsal tilt, carpal alignment, radial inclination and ulnar variance can be measured reliably on both radiographs and CT scans. At a patient level, carpal alignment, radial inclination and ulnar variance CT scan measurements are an acceptable alternative to plain radiograph measurements in the vast majority of patients. In contrast, dorsal tilt CT scan measurements are not comparable with radiographs in 40% of the cases. Therefore, caution should be taken in measuring dorsal tilt on CT scans.

[A man with a red umbilicus]. / Een man met een rode navel.

A 76-year-old man was sent to the dermatology department because of a red, sore belly button since 3 weeks. Based on histology, a CT-scan and increased Cancer Antigen 19-9 levels, this was interpreted as a pancreas carcinoma metastasis. This type of metastasis is also called a 'Sister Mary Joseph's nodule'.