A Wettability Contrast SERS Droplet Assay for Multiplexed Analyte Detection.

Droplet assay platforms have emerged as a significant methodology, providing distinct advantages such as sample compartmentalization, high throughput, and minimal analyte consumption. However, inherent complexities, especially in multiplexed detection, remain a challenge. We demonstrate a novel strategy to fabricate a plasmonic droplet assay platform (PDAP) for multiplexed analyte detection, enabling surface-enhanced Raman spectroscopy (SERS). PDAP efficiently splits a microliter droplet into submicroliter to nanoliter droplets under gravity-driven flow by wettability contrast between two distinct regions. The desired hydrophobicity and adhesive contrast between the silicone oil-grafted nonadhesive hydrophilic zone with gold nanoparticles is attained through (3-aminopropyl) triethoxysilane (APTES) functionalization of gold nanoparticles (AuNPs) using a scotch-tape mask. The wettability contrast surface facilitates the splitting of aqueous droplets with various surface tensions (ranging from 39.08 to 72 mN/m) into ultralow volumes of nanoliters. The developed PDAP was used for the multiplexed detection of Rhodamine 6G (Rh6G) and Crystal Violet (CV) dyes. The limit of detection for 120 nL droplet using PDAP was found to be 134 pM and 10.1 nM for Rh6G and CV, respectively. These results align with those from previously reported platforms, highlighting the comparable sensitivity of the developed PDAP. We have also demonstrated the competence of PDAP by testing adulterant spiked milk and obtained very good sensitivity. Thus, PDAP has the potential to be used for the multiplexed screening of food adulterants.

Exfoliating a CdII -Purine Framework: Conversion of Nanosheets-to-Nanofibers and Studies of Elastic and Capacitive Properties.

Layered bulk crystals are amenable to exfoliation to yield 2D nanosheets through isolation and intercalation processes, which could be further converted to 1D nanoscale structures. The latter inherit gross morphological and physical properties associated with the precursor structures. Herein, we report three purine-based crystal structures 1, 2, and 3, where 3 is obtained by a single-crystal-to-single-crystal transformation from 2 and is a conformational polymorph of 1. Next, we describe the sonication-assisted liquid exfoliation of 1, a CdII -purine coordination framework, into nanosheets and nanofibers in a solvent-dependent process. The exfoliation was carefully studied at low temperatures to ascertain this unique conversion. This work also features the determination of the Young's modulus and surface potential of the bioinspired CdII -based nanostructures by using amplitude modulation-frequency modulation atomic force microscopy and Kelvin probe force microscopy, respectively, revealing their interesting elastic and capacitive properties for their possible use in electronics and energy devices. Electron impedance spectroscopy measurements further established a higher value of capacitance for the exfoliated CdII framework as compared to the ligand alone.

Doxorubicin Conjugated γ-Globulin Functionalised Gold Nanoparticles: A pH-Responsive Bioinspired Nanoconjugate Approach for Advanced Chemotherapeutics.

Developing successful nanomedicine hinges on regulating nanoparticle surface interactions within biological systems, particularly in intravenous nanotherapeutics. We harnessed the surface interactions of gold nanoparticles (AuNPs) with serum proteins, incorporating a γ-globulin (γG) hard surface corona and chemically conjugating Doxorubicin to create an innovative hybrid anticancer nanobioconjugate, Dox-γG-AuNPs. γG (with an isoelectric point of ~7.2) enhances cellular uptake and exhibits pH-sensitive behaviour, favouring targeted cancer cell drug delivery. In cell line studies, Dox-γG-AuNPs demonstrated a 10-fold higher cytotoxic potency compared to equivalent doxorubicin concentrations, with drug release favoured at pH 5.5 due to the γ-globulin corona's inherent pH sensitivity. This bioinspired approach presents a novel strategy for designing hybrid anticancer therapeutics. Our study also explored the intricacies of the p53-mediated ROS pathway's role in regulating cell fate, including apoptosis and necrosis, in response to these treatments. The pathway's delicate balance of ROS emerged as a critical determinant, warranting further investigation to elucidate its mechanisms and implications. Overall, leveraging the robust γ-globulin protein corona on AuNPs enhances biostability in harsh serum conditions, augments anticancer potential within pH-sensitive environments, and opens promising avenues for bioinspired drug delivery and the design of novel anticancer hybrids with precise targeting capabilities.

Plasmonic Paper-Based Flexible SERS Biosensor for Highly Sensitive Detection of Lactic and Uric Acid.

Selective detection and quantification of biomarkers related to human diseases are essential for preventive healthcare. Surface-enhanced Raman scattering (SERS) spectroscopy is a powerful analytical tool offering high sensitivity. However, the success of this promising analytical tool relies on the ability to effectively fabricate SERS substrate. Herein we have demonstrated a plasmonic paper-based flexible substrate (PPFS) for SERS sensing. In situ growth of silver nanostructures (AgNS) on the paper-based substrate was achieved by using a simple one-step silver mirror reaction (SMR). FESEM and TEM results depicts that the increasing silver ion content influences the morphology (growth of multifacets), as well as size of AgNS. Further, the PPFS substrate was tested with Rhodamine-6G (Rh-6G) dye and an attomole sensitivity with a LOD of 4.54 × 10-18 M was achieved. Further, two biomarkers, lactic acid (LA) and uric acid (UA) were detected on the PPFS substrate, with [Formula: see text] and pM sensitivity, having LOD values of 0.6 × 10-6 and 0.3 × 10-12 M respectively. Above detection levels for UA on PPFS is two orders better than reported values, whereas for LA it is comparable with reported substrates. Finally, UA, LA and their mixtures were tested on PPFS and results compared with commercial substrate. The performance of PPFS were found better in all cases, thus, multifaceted AgNS paper based PPFS offers the potential to be used as a biosensor for detection of various biomarkers from body fluids, responsible for the detection of the critical disease for preventive health care.

High-resolution imaging and fast number estimation of suspended particles using dewetted polymer microlenses in a microfluidic channel.

We have fabricated polymer micro-lens array by self-organized dewetting inside the microchannel, which shows remarkable enhancement in the resolution, contrast and more than 10 times add-on magnification to a microscope. These lenses are demonstrated to resolve sub-micrometer features and detect moving micro-particles when suspension is flown in a microchannel. Polystyrene (PS) micro-lenses are fabricated on a polydimethylsiloxane (PDMS) substrate using the controlled dewetting of PS thin film then this PDMS substrate is used to close the microchannel with inverted micro-lenses on it. An aqueous suspension of polystyrene particles is flown through the microchannel and we have observed the particles through an optical microscope. Focusing and magnification through PS micro-lenses is analyzed to get a quantitative estimate of the particle number density in the solution. This method offers a promising low-cost high throughput solution for determining the approximate number density of flowing particles or suitably stained biological cells. Particularly in a pathology lab it can tremendously increase detection limit by enabling visibility of sub-micrometer pathogens using a standard laboratory microscope.

Ultra-sensitive reusable SERS sensor for multiple hazardous materials detection on single platform.

We demonstrate the detection of dipicolinic acid, (DPA), a biomarker of bacterial spores for Bacillus anthracis, 2,4-Dinitrotoluene (DNT) and picric acid (PA) nitroaromatic hazardous chemicals on ultra-sensitive, reusable femtosecond laser textured Au nanostructures decorated with hierarchical AuNPs as a SERS substrate. The AuNPs were achieved by ablating an Au sheet using two different laser scan speeds (1 and 0.1 mm/s) in linear and crossed patterns. The morphological studies revealed dense hierarchical nanostructures decorated with spherical AuNPs possessing 30-40 nm in size in 0.1 mm/s laser scan. The limits of detection (LOD) of the sensor were determined from the detailed SERS measurements and were estimated to be 0.83 pg/L, 3.6 pg/L and 2.3 pg/L for DPA, DNT, and PA, respectively. To the best of our knowledge, the achieved sensitivity is nearly 2 orders improved for DPA when compared with the currently reported LODs using other techniques and 1 order in the case of SERS. Moreover, for DNT and PA the LODs were found to be either superior or comparable with recent reports. We have also demonstrated the competence of our SERS substrates by testing a few real samples (water spiked with these analytes) and again obtained very good sensitivity.

Tripeptide-induced modulation of mesenchymal stem cell biomechanics stimulates proliferation and wound healing.

We demonstrate the ability of two tripeptides to promote proliferation and modulate the mechanical properties of human mesenchymal stem cells (hMSCs). Notably, Young's modulus of peptide-treated hMSCs was found to be ∼2 fold higher compared to the control group. These peptides promoted wound healing in hMSCs, without stimulating osteogenic and adipogenic differentiation, thus showing high potential in vascular tissue engineering applications.

Hierarchical Laser-Patterned Silver/Graphene Oxide Hybrid SERS Sensor for Explosive Detection.

We demonstrate an ultrafast laser-ablated hierarchically patterned silver nanoparticle/graphene oxide (AgNP/GO) hybrid surface-enhanced Raman scattering (SERS) substrate for highly sensitive and reproducible detection of an explosive marker 2,4-dinitrotoluene (2,4-DNT). A hierarchical laser-patterned silver sheet (Ag-S) is achieved by ultrafast laser ablation in air with pulse energies of 25, 50, and 100 µJ. Multiple laser pulses at a wavelength of 800 nm and a pulse repetition rate of 50 fs at 1 kHz are directly focused on Ag-S to produce and deposit AgNPs onto Ag-S. The surface morphology of ablated Ag-S was evaluated using atomic force microscopy, optical profilometry, and field emission scanning electron microscopy (FESEM). A rapid increase in the ablation rate with increasing laser energy was observed. Selected area Raman mapping is performed to understand the intensity and size distribution of AgNPs on Ag-S. Further, GO was spin-coated onto the AgNPs produced by ultrafast ablation on Ag-S. The hierarchical laser-patterned AgNP/GO hybrid structure was characterized using FESEM, high-resolution transmission electron microscopy, X-ray diffraction, Fourier transform infrared spectroscopy, and Raman spectroscopy. Further, hierarchical laser-patterned AgNP/GO hybrid structures have been utilized as SERS-active substrates for the selective detection of 2,4-DNT, an explosive marker. The developed SERS-active sensor shows good stability and high sensitivity up to picomolar (pM) concentration range with a Raman intensity enhancement of ∼1010 for 2,4-DNT. The realized enhancement of SERS intensity is due to the cumulative effect of GO coated on Ag-S as a proactive layer and AgNPs produced by ultrafast ablation.

Hierarchically Patterned Elastomeric and Thermoplastic Polymer Films through Nanoimprinting and Ultraviolet Light Exposure.

The surface relief structure of polymer films over large areas can be controlled by combining nanoscale imprinting and microscale ultraviolet-ozone (UVO) radiation, resulting in hierarchical structured surfaces. First, nanoscale patterns were formed by nanoimprinting elastomer [poly(dimethylsiloxane) (PDMS)] films with a pattern on a digital video disk. Micron-scale patterns were then superimposed on the nanoimprinted PDMS films by exposing them to ultraviolet radiation in oxygen (UVO) through a transmission electron microscopy grid mask having variable microscale patterning. UVO exposure leads to conversion and densification of PDMS to SiO x , leading to micron height relief features that follow a linear scaling relation with pattern dimension. Further, the pattern scopes are shown to collapse into a master curve by normalized feature values. Interestingly, these relief structures preserve the nanoscale features. In this paper, the influence of the self-limiting PDMS densification, wall stress at the boundary of micro-depression, and UVO exposure energy is studied in control of the micro-depression scale. This simple two-step imprinting process involving both nanoimprinting and UV radiation allows for facile fabrication of the dimension adjustable micro-nano hierarchically structures not only on elastomer films but also on thermoplastic polymer films. Coarse-grained molecular dynamics simulations were performed to correlate the surface tension and elastic properties of polymeric materials to the deformation of the pattern structure.

Transport of liquids using superhydrophobic aerogels.

The experimental results of the studies on the transportation of water droplets on a superhydrophobic silica aerogel-powder-coated surface are reported. The superhydrophobic silica aerogels were prepared using sol-gel processing of methyltrimethoxysilane (MTMS) precursor, methanol (MeOH) solvent, and base (NH4OH)-catalyzed water followed by supercritical drying using methanol solvent. The molar ratio of NH4OH/MTMS, H2O/MTMS, and MeOH/MTMS were varied from 1.7x10(-1) to 3.5x10(-1), 2 to 8, and 1.7 to 14, respectively, to find out the best-quality aerogels in terms of higher hydrophobicity and high droplet velocity. A specially built device was used for the measurement of velocity of water droplet of size 2.8 mm (+/-0.2 mm) on an inclined surface coated with superhydrophobic aerogel powder. Liquid marbles were prepared by rolling water droplets on aerogel powder and the marble(s) velocities on a noncoated inclined surface were compared with that of the water droplets. It was observed that the microstructure of the aerogel affects the droplet as well as marble velocities considerably. For an aerogel with uniform and smaller particles, the water droplet and marble velocities were observed to be maximum, i.e., 144 and 123 cm/s, respectively, whereas for the aerogels with bigger and nonuniform particles, the water droplet and marble velocities were observed to be minimum, i.e., 92 and 82 cm/s, respectively. The results have been discussed by taking into account the contact angles and microstructural observations.