Nanofiber/hydrogel core-shell scaffolds with three-dimensional multilayer patterned structure for accelerating diabetic wound healing.

Impaired angiogenesis is one of the predominant reasons for non-healing diabetic wounds. Herein, a nanofiber/hydrogel core-shell scaffold with three-dimensional (3D) multilayer patterned structure (3D-PT-P/GM) was introduced for promoting diabetic wound healing with improved angiogenesis. The results showed that the 3D-PT-P/GM scaffolds possessed multilayered structure with interlayer spacing of about 15-80 µm, and the hexagonal micropatterned structures were uniformly distributed on the surface of each layer. The nanofibers in the scaffold exhibited distinct core-shell structures with Gelatin methacryloyl (GelMA) hydrogel as the shell and Poly (D, L-lactic acid) (PDLLA) as the core. The results showed that the porosity, water retention time and water vapor permeability of the 3D-PT-P/GM scaffolds increased to 1.6 times, 21 times, and 1.9 times than that of the two-dimensional (2D) PDLLA nanofibrous scaffolds, respectively. The in vitro studies showed that the 3D-PT-P/GM scaffolds could significantly promote cell adhesion, proliferation, infiltration and migration throughout the scaffolds, and the expression of cellular communication protein-related genes, as well as angiogenesis-related genes in the same group, was remarkably upregulated. The in vivo results further demonstrated that the 3D-PT-P/GM scaffolds could not only effectively absorb exudate and provide a moist environment for the wound sites, but also significantly promote the formation of a 3D network of capillaries. As a result, the healing of diabetic wounds was accelerated with enhanced angiogenesis, granulation tissue formation, and collagen deposition. These results indicate that nanofiber/hydrogel core-shell scaffolds with 3D multilayer patterned structures could provide a new strategy for facilitating chronic wound healing.

Isolation and characterization of two lytic cold-active bacteriophages infecting Pseudomonas fluorescens from the Napahai plateau wetland.

As the "kidneys of the Earth", wetlands play important roles as biodiversity reservoirs, in water purification, and in flood control. In this study, 2 lytic cold-active bacteriophages, named VW-6S and VW-6B, infecting Pseudomonas fluorescens W-6 cells from the Napahai plateau wetland in China were isolated and characterized. Electron microscopy showed that both VW-6S and VW-6B had an icosahedral head (66.7 and 61.1 nm, respectively) and a long tail (8.3 nm width × 233.3 nm length and 11.1 nm width × 166.7 nm length, respectively). The bacteriophages VW-6S and VW-6B were classified as Siphoviridae and had an approximate genome size of 30-40 kb. The latent and burst periods of VW-6S were 60 and 30 min, whereas those of VW-6B were 30 and 30 min, respectively. The optimal pH values for the bacteriophages VW-6S and VW-6B were 8.0 and 10.0, respectively, and their activity decreased rapidly at temperatures higher than 60 °C. These cold-active bacteriophages provide good materials for further study of cold-adaptation mechanisms and interaction with the host P. fluorescens.

Complete genome sequence of the lytic cold-active Pseudomonas fluorescens bacteriophage VSW-3 from Napahai plateau wetland.

The lytic cold-active bacteriophage VSW-3, belonging to the Podoviridae family and infecting the host Pseudomonas fluorescens SW-3, was isolated from the Napahai plateau wetland in China. With the development of sequencing technology, the study of Pseudomonas genomic diversity has increased; however, knowledge of cold-active phages infecting Pseudomonas is limited. The newly sequenced phage VSW-3 was classified based on virion morphology by transmission electron microscope. Sequence analysis revealed that the genome size was 40,556 bp with an overall GC content of 57.54 % and 46 open reading frames. The genome was organized into several modules containing genes for packaging, structural proteins, replication/transcription, and phage lysis. The sequence contained 45 potential promoters, 3 transcription terminators, and yet no tRNAs. This is the first report of cold-active Pseudomonas fluorescens bacteriophage genome sequencing.

Formation of single-mode laser in transverse plane of perovskite microwire via micromanipulation.

The synthesized perovskites are randomly distributed and their optical properties are fixed after synthesis. Here we demonstrate the tailoring of lasing properties of perovskite microwire via micromanipulation. One microwire has been lifted by a tungsten probe and repositioned on a nearby perovskite microplate with one end suspended in air. Consequently, the conventional Fabry-Perot lasers are completely suppressed and a single laser peak has been observed. The numerical calculations reveal that the single-mode laser is formed by the whispering-gallery mode in the transverse plane of microwire. Our research provides a simple way to tailor the properties of microwire postsynthesis.

The combination of directional outputs and single-mode operation in circular microdisk with broken PT symmetry.

Monochromaticity and directionality are two key characteristics of lasers. However, the combination of directional emission and single-mode operation is quite challenging, especially for the on-chip devices. Here we propose a microdisk laser with single-mode operation and directional emissions by exploiting the recent developments associated with parity-time (PT) symmetry. This is accomplished by introducing one-dimensional periodic gain and loss into a circular microdisk, which induces a coupling between whispering gallery modes with different radial numbers. The lowest threshold mode is selected at the positions with least initial wavelength difference. And the directional emissions are formed by the introduction of additional grating vectors by the periodic distribution of gain and loss regions. We believe this research will impact the practical applications of on-chip microdisk lasers.

Metal-Organic Frameworks in Microfluidics Enable Fast Encapsulation/Extraction of DNA for Automated and Integrated Data Storage.

DNA as an exceptional data storage medium offers high information density. However, DNA storage requires specialized equipment and tightly controlled environments for storage. Fast encapsulation within minutes for enhanced DNA stability to do away with specialized equipment and fast DNA extraction remain a challenge. Here, we report a DNA microlibrary that can be encapsulated by metal-organic frameworks (MOFs) within 10 min and extracted (5 min) in a single microfluidic chip for automated and integrated DNA-based data storage. The DNA microlibrary@MOFs enhances the stability of data-encoded DNA against harsh environments. The encoded information can be read out perfectly after accelerated aging, equivalent to being readable after 10 years of storage at 25 °C, 50% relative humidity, and 10 000 lx sunlight radiation. Moreover, the library enables fast retrieval of target data via flow cytometry and can be reproduced after each access.

The semenogelin I-derived peptide SgI-52 in seminal plasma participates in sperm selection and clearance by macrophages.

BACKGROUND: Macrophages can phagocytose sperm, especially damaged spermatozoa, in the female genital tract. The semenogelin I-derived peptide SgI-52 in seminal plasma exhibits seminal plasma motility inhibitor (SPMI) activity and can inhibit sperm motility. This raises the question of the role played by SPMIs in macrophage-mediated phagocytosis of sperm. We speculated that SgI-52 promotes sperm clearance by macrophages. Therefore, we investigated the phagocytosis of sperm in different states using this peptide. METHODS: SgI-52 was fluorescently labeled, and its binding site for sperm was observed. The ability of macrophages to phagocytose sperm was observed using fluorescence confocal microscopy. Spermatozoa from different sources were co-cultured with SgI-52 in BWW medium for 4 and 22 h to compare the differences in their phagocytosis by macrophages. Sperm motility, induced acrosome reaction, mitochondrial membrane potential, and ATP content were examined after incubation with SgI-52. RESULTS: SgI-52 could bind to spermatozoa in different states, mainly to the tail, and then spread to the acrosome. This effect was more pronounced in demembranated spermatozoa. SgI-52 promoted phagocytosis of spermatozoa by macrophages, decreased the mitochondrial membrane potential, and increased the average ATP content of spermatozoa (P < 0.05). CONCLUSIONS: We found for the first time that SgI-52 can bind to spermatozoa in different states and promote their phagocytosis by macrophages. Therefore, we speculate that SgI-52 is involved in the screening of sperm in the female reproductive tract and has potential value in improving assisted reproductive technology.

A Mussel-Inspired Extracellular Matrix-Mimicking Composite Scaffold for Diabetic Wound Healing.

In this study, a micropatterned scaffold with surface-loaded spherical bioactive glasses was successfully fabricated by the electrospinning technique and polydopamine (PDA) coating method for diabetic wound healing. The micro- to nanoscaled hierarchical structure and PDA coating could mimic the structure and function of the native extracellular matrix (ECM), and the scaffold could sustainably release the Si and Ca ions. The in vitro study revealed that the adhesion, proliferation, migration, and angiogenic differentiation of human umbilical vein endothelial cells could be significantly promoted by the scaffold. The in vivo experiment further revealed that the PDA-coated patterned scaffolds showed a high efficiency in diabetic wound healing and a significant improvement in re-epithelialization and collagen deposition in diabetic wounds. More importantly, the controllably released Si ions from the scaffold could further promote angiogenesis and inhibit inflammation in the wound site, thereby improving the healing quality of the diabetic wound. Our results suggest that this kind of scaffold with the ECM-mimicking structure and function as well as the released Si ions could be a promising treatment for diabetic wound.

Copper-Based Metal-Organic Framework as a Controllable Nitric Oxide-Releasing Vehicle for Enhanced Diabetic Wound Healing.

Chronic wounds are one of the most serious complications of diabetes mellitus. Even though utilizing nitric oxide (NO) as a gas medicine to repair diabetic wounds presents a promising strategy, controlling the NO release behavior in the affected area, which is vital for NO-based therapy, still remains a significant challenge. In this work, a copper-based metal-organic framework, namely, HKUST-1, has been introduced as a NO-loading vehicle, and a NO sustained release system with the core-shell structure has been designed through the electrospinning method. The results show that the NO is quantificationally and stably loaded in the HKUST-1 particles, and the NO-loaded HKUST-1 particles are well incorporated into the core layer of the coaxial nanofiber. Therefore, NO can be controllably released with an average release rate of 1.74 nmol L-1 h-1 for more than 14 days. Moreover, the additional copper ions released from the degradable HKUST-1 play a synergistic role with NO to promote endothelial cell growth and significantly improve the angiogenesis, collagen deposition as well as anti-inflammatory property in the wound bed, which eventually accelerate the diabetic wound healing. These results suggest that such a copper-based metal-organic framework material as a controllable NO-releasing vehicle is a highly efficient therapy for diabetic wounds.

Coupling the normal incident light into waveguide modes of DBR mirrors via a diffraction grating.

Here we numerically and experimentally demonstrate the conversion of normally incident light into the guiding modes of distributed Bragg reflector (DBRs) mirror. By fabricating a gold grating onto a 7.5 pairs TiO2/SiO2 DBR mirror, a series of asymmetrical resonances have been formed at the bandgap range of the DBR mirror. The detailed numerical calculations show that these Fano resonances are attributed to the coupling of incident waves into guiding modes of the DBR mirror. Compared with the other resonances, this coupling mechanism can be simply realized and it has also been revealed to be quite robust to the environmental changes, making the conversion between propagating waves and guiding waves to be practically interesting for many applications.

Postsynthetic and Selective Control of Lead Halide Perovskite Microlasers.

The control of photoluminescence and absorption of lead halide perovskites plays a key role in their applications in micro- and nano-sized light emission devices and photodetectors. To date, the wavelength controls of lead halide perovskite microlasers are mostly realized by changing the halide mixture in solution. Herein, we report the postsynthetic and selective control of the optical properties of lead halide perovskites with conventional semiconductor technology. By selectively exposing a CH3NH3PbBr3 microstructure with chlorine in inductively coupled plasma, we find that the wavelengths of absorption, photoluminescence, and laser emissions of exposed structures are blue-shifted around 50 nm. Most importantly, the device characteristics such as the photoluminescence intensities and laser thresholds are well maintained during the reaction process. We believe our finding will significantly boost the practical applications of lead halide perovskite based optoelectronics.

The Role of Excitons on Light Amplification in Lead Halide Perovskites.

The role of excitons on the amplifications of lead halide perovskites has been explored. Unlike the photoluminescence, the intensity of amplified spontaneous emission is partially suppressed at low temperature. The detailed analysis and experiments show that the inhibition is attributed to the existence of exciton and a quantitative model has been built to explain the experimental observations.

Inversed Vernier effect based single-mode laser emission in coupled microdisks.

Recently, on-chip single-mode laser emissions in coupled microdisks have attracted considerable research attention due to their wide applications. While most of single-mode lasers in coupled microdisks or microrings have been qualitatively explained by either Vernier effect or inversed Vernier effect, none of them have been experimentally confirmed. Here, we studied the mechanism of single-mode laser operation in coupled microdisks. We found that the mode numbers had been significantly reduced to nearly single-mode within a large pumping power range from threshold to gain saturation. The detail laser spectra showed that the largest gain and the first lasing peak were mainly generated by one disk and the laser intensity was proportional to the wavelength detuning of two set of modes. The corresponding theoretical analysis showed that the experimental observations were dominated by internal coupling within one cavity, which was similar to the recently explored inversed Vernier effect in two coupled microrings. We believe our finding will be important for understanding the previous experimental findings and the development of on-chip single-mode laser.