Exploring foraging preference of local fish species towards non-indigenous fouling communities near marinas: Insights from Remote Video Foraging System (RVFS) trials.

Non-indigenous species (NIS) spread from marinas to natural environments is influenced by niche availability, habitat suitability, and local biotic resistance. This study explores the effect of indigenous fish feeding behaviour on NIS proliferation using fouling communities, pre-grown on settlement plates, as two distinct, representative models: one from NIS-rich marinas and the other from areas outside marinas with fewer NIS. These plates were mounted on a Remote Video Foraging System (RVFS) near three marinas on Madeira Island. After 24-h, NIS abundance was reduced by 3.5 %. Canthigaster capistrata's preference for marinas plates suggests potential biotic resistance. However, Sparisoma cretense showed equal biting frequencies for both plate types. The cryptogenic ascidian Trididemnum cereum was the preferred target for the fish. Our study introduces a global framework using RVFS for in-situ experiments, replicable across divers contexts (e.g., feeding behaviour, biotic resistance), which can be complemented by metabarcoding and isotopic analysis to confirm consumption patterns.

Acoustic fish community in the Madeira Archipelago (North Atlantic Ocean): Characterization of sound diversity and daily patterns.

Marine ecosystems are increasingly subjected to anthropogenic pressures, which demands urgent monitoring plans. Understanding soundscapes can offer unique insights into the ocean status providing important information and revealing different sounds and their sources. Fishes can be prominent soundscape contributors, making passive acoustic monitoring (PAM) a potential tool to detect the presence of vocal fish species and to monitor changes in biodiversity. The major goal of this research was to provide a first reference of the marine soundscapes of the Madeira Archipelago focusing on fish sounds, as a basis for a long-term PAM program. Based on the literature, 102 potentially vocal and 35 vocal fish species were identified. Additionally 43 putative fish sound types were detected in audio recordings from two marine protected areas (MPAs) in the Archipelago: the Garajau MPA and the Desertas MPA. The Garajau MPA exhibited higher fish vocal activity, a greater variety of putative fish sound types and higher fish sound diversity. Lower abundance of sounds was found at night at both MPAs. Acoustic activity revealed a clear distinction between diurnal and nocturnal fish groups and demonstrated daily patterns of fish sound activity, suggesting temporal and spectral partitioning of the acoustic space. Pomacentridae species were proposed as candidates for some of the dominant sound types detected during the day, while scorpionfishes (Scorpaena spp.) were proposed as sources for some of the dominant nocturnal fish sounds. This study provides an important baseline about this community acoustic behaviour and is a valuable steppingstone for future non-invasive and cost-effective monitoring programs in Madeira.

Surface integrity could limit the potential of concrete as a bio-enhanced material in the marine environment.

Coastal sprawl is among the main drivers of global degradation of shallow marine ecosystems. Among artificial substrates, quarry rock can have faster recruitment of benthic organisms compared to traditional concrete, which is more versatile for construction. However, the factors driving these differences are poorly understood. In this context, this study was designed to compare the intertidal and subtidal benthic and epibenthic assemblages on concrete and artificial basalt boulders in six locations of Madeira Island (northeastern Atlantic, Portugal). To assess the size of the habitat, the shorelines in the study area were quantified using satellite images, resulting in >34 % of the south coast of Madeira being artificial. Benthic assemblages differed primarily between locations and secondarily substrates. Generally, assemblages differed between substrates in the subtidal, with lower biomass and abundance in concrete than basalt. We conclude that these differences are not related to chemical effects (e.g., heavy metals) but instead to a higher detachment rate of calcareous biocrusts from concrete, as surface abrasion is faster in concrete than basalt. Consequently, surface integrity emerges as a factor of ecological significance in coastal constructions. This study advances knowledge on the impact and ecology of artificial shorelines, providing a baseline for future research towards ecological criteria for coastal protection and management.

Predation facilitates the abundance of biofouling non-indigenous species in estuarine marinas in NE Atlantic Portugal.

Harbours are highly modified habitats that differ from natural areas. They are hotspots of non-indigenous species (NIS) and act as stepping-stones in invasive processes. However, local communities can exert biotic resistance against biological invasions through trophic interactions and competition. This study assesses the biotic effects of predation on the recruitment of fouling assemblages in three marinas of NE Atlantic Portugal (Cascais, Setúbal and Sines), with particular emphasis on NIS, using predator exclusion experiments. Predation increased the relative abundance of NIS, mainly Watersipora subatra, in the estuarine marinas of Cascais and Setúbal, while no predation effects were registered in the coastal marina of Sines. Therefore, predation can increase the risk of NIS invasion (biotic facilitation). Furthermore, local ecosystems may have different effects and differ in vulnerability against NIS invasions. Finally, a better understanding of coastal invasive ecology and biotic effects in coastal artificial habitats will improve our capacity for NIS management.

Location and building material determine fouling assemblages within marinas: A case study in Madeira Island (NE Atlantic, Portugal).

Marinas are hubs for non-indigenous species (NIS) and constitute the nodes of a network of highly modified water bodies (HMWB) connected by recreational maritime traffic. Floating structures, such as pontoons, are often the surfaces with higher NIS abundance inside marinas and lead the risk for NIS introduction, establishment and spread. However, there is still little information on how the location within the marina and the substratum type can influence the recruitment of fouling assemblages depending on water parameters and substratum chemical composition. In this study, fouling recruitment was studied using an experimental approach with three materials (basalt, concrete and HDPE plastic) in two sites (close and far to the entrance) in two marinas of Madeira Island (NE Atlantic, Portugal). The structure of benthic assemblages after 6- and 12-months colonization, as well as biotic abundance, NIS abundance, richness, diversity, assemblages' volume, biomass and assemblages' morphology were explored. Differences between marinas were the main source of variation for both 6- and 12-month assemblages, with both marinas having different species composition and biomass. The inner and outer sites of both marinas varied in terms of structure and heterogeneity of assemblages and heterogeneity of morphological traits, but assemblages did not differ among substrata. However, basalt had a higher species richness and diversity while concrete showed a higher bioreceptivity in terms of total biotic coverage than the rest of materials. Overall, differences between and within marinas could be related to their structural morphology. This study can be valuable for management of urban ecosystems, towards an increase in the environmental and ecological status of existing marinas and their HMWB and mitigation coastal ecosystems degradation.

Drones for litter monitoring on coasts and rivers: suitable flight altitude and image resolution.

Multirotor drones can be efficiently used to monitor macro-litter in coastal and riverine environments. Litter on beaches, dunes and riverbanks, along with floating litter on coastal and river waters, can be spotted and mapped from aerial drone images. Items detection and classification are prone to image resolution, which is expressed in terms of Ground Sampling Distance (GSD). The GSD is determined by drone flight altitude and camera properties. This paper investigates what is a suitable GSD value for litter survey. Drone flight altitude and camera setup should be chosen to obtain a GSD between 0.5 cm/px and 1.25 cm/px. Within this range, the lowest GSD allows litter categorization and classification, whereas the highest value should be adopted for a coarser litter census. In the vision of drawing up a global protocol for drone-based litter surveys, this work sets the ground for homogenizing data collection and litter assessments.

Novel approach to enhance coastal habitat and biotope mapping with drone aerial imagery analysis.

Understanding the complex factors and mechanisms driving the functioning of coastal ecosystems is vital towards assessing how organisms, ecosystems, and ultimately human populations will cope with the ecological consequences of natural and anthropogenic impacts. Towards this goal, coastal monitoring programs and studies must deliver information on a range of variables and factors, from taxonomic/functional diversity and spatial distribution of habitats, to anthropogenic stress indicators such as land use, fisheries use, and pollution. Effective monitoring programs must therefore integrate observations from different sources and spatial scales to provide a comprehensive view to managers. Here we explore integrating aerial surveys from a low-cost Remotely Piloted Aircraft System (RPAS) with concurrent underwater surveys to deliver a novel approach to coastal monitoring. We: (i) map depth and substrate of shallow rocky habitats, and; (ii) classify the major biotopes associated with these environmental axes; and (iii) combine data from i and ii to assess the likely distribution of common sessile organismal assemblages over the survey area. Finally, we propose a general workflow that can be adapted to different needs and aerial platforms, which can be used as blueprints for further integration of remote-sensing with in situ surveys to produce spatially-explicit biotope maps.