RESUMEN
The raw materials of Poly(ethylene terephthalate) (PET) are derived from petroleum-based resources, which are no sustainable. Therefore, previous researchers introduced biomass-derived 2,5-tetrahydrofurfuryl dimethanol (THFDM) into PET. However, its heat resistance has decreased compared to PET. In this paper, a novel bio-based copolyester, poly(ethylene glycol-co-2,5-tetrahydrofuran dimethanol-co-isosorbide terephthalate) (PEIFT), is prepared by introducing biomass-derived isosorbide (ISB) and THFDM into the PET chains through melting copolymerization process. With the introduction of ISB content, copolyesters' hydrophilicity and rigidity improve. Compared to PET, glass transition temperature (Tg) increases by over 5 °C. In addition, the toughness and spinning performance of PEIFT have also been improved as a result of the addition of THFDM components. The hydrophobicity of PEIFTs electrospinning is greatly improved, with a contact angle exceeding 135°. Finally, due to the good hydrophobicity of PEIFTs nanofibers, they have potential application value in the manufacture of hydrophobic nanofiber and filter films. Given its biomass source and excellent performance, they make it easier to replace materials derived from petroleum.
Asunto(s)
Interacciones Hidrofóbicas e Hidrofílicas , Nanofibras , Poliésteres , Nanofibras/química , Poliésteres/química , Poliésteres/síntesis química , Isosorbida/química , Biomasa , Tereftalatos Polietilenos/química , Furanos/químicaRESUMEN
In this paper, the copolymerization of poly (p-dioxanone) (PPDO) and polylactide (PLA) was carried out via a Diels-Alder reaction to obtain a new biodegradable copolymer with self-healing abilities. By altering the molecular weights of PPDO and PLA precursors, a series of copolymers (DA2300, DA3200, DA4700 and DA5500) with various chain segment lengths were created. After verifying the structure and molecular weight by 1H NMR, FT-IR and GPC, the crystallization behavior, self-healing properties and degradation properties of the copolymers were evaluated by DSC, POM, XRD, rheological measurements and enzymatic degradation. The results show that copolymerization based on the DA reaction effectively avoids the phase separation of PPDO and PLA. Among the products, DA4700 showed a better crystallization performance than PLA, and the half-crystallization time was 2.8 min. Compared to PPDO, the heat resistance of the DA copolymers was improved and the Tm increased from 93 °C to 103 °C. Significantly, the rheological data also confirmed that the copolymer was self-healing and showed obvious self-repairing properties after simple tempering. In addition, an enzyme degradation experiment showed that the DA copolymer can be degraded by a certain amount, with the degradation rate lying between those of PPDO and PLA.
RESUMEN
With the excessive consumption of fossil energy, technologies that transform bio-based resources into materials have received more and more attention from researchers in recent decades. In this paper, a series of poly(ethylene 2,5-tetrahydrofuran dimethyl terephthalate; PEFTs) with different components were synthesized from 2,5-tetrahydrofuran dimethanol (THFDM), terephthalic acid (TPA), and ethylene glycol (EG). Their chemical structures and compositions were determined by FTIR, 1H NMR, and 13C NMR. With the increase in THFDM content, the crystallization, T m, and tensile strength of PEFTs gradually decrease because the introduced THFDM breaks the order of molecular chains, while the thermal stability and T g remain stable. PEFTs seem to present a significant shear thinning phenomenon, which was indicated by the rheological test. Electrospinning technology was used to explore the spinnability of PEFT; it was found that PEFTs have better spinning performance than PET. In addition, due to the good hydrophobicity and porosity of PEFT nanofiber films, they have potential application value in the manufacture of hydrophobic nanofiber and filter films.