Effect of high-energy mechanical milling on the physicochemical and rheological properties of chayotextle (Sechium edule Sw.) starch.

This work evaluates the effect of high-energy mechanical milling time (7 levels, 20-80 min) on amylose content, crystallinity pattern, temperature and gelatinization enthalpy, morphology, and rheological properties of chayotextle (Sechium edule Sw.) starch. After 30 min of milling, granular structure was affected, and amylose values were the highest while crystallinity and gelatinization enthalpy decreased significantly. These changes allowed to obtain gels with viscoelastic properties where the elastic character (Ç´) prevailed upon the viscous modulus (Ǵ́). Native starch showed Tan δ values of 0.6, increased significantly (0.9) after 30 min of milling due to the surge in linear chains (amylose) and loss of granular structure. Native and modified starches showed high dependence on cutting or shear speed, presenting a non-Newtonian behavior (reofluidizers). These results indicate that mechanical grinding is an alternative to obtain modified starches with applications in the food industry.

Functionality and characterization of modified starch films with pineapple leaf fibers.

The objective of this work was to modify banana starch with pineapple leaf fibers (PALF) and its production of biodegradable films. The reaction conditions of the starch modification were a Starch/PALF mass ratio of 50, a time of 1 h and a temperature of 140 °C, to obtain a yield of 41.18 %. Characterization by FTIR and NMR confirmed that the chemical reaction was carried out. XRD and TGA analysis showed that the crystalline zones of the starch were affected during the modification and the product obtained is thermally less stable compared to unmodified starch. The modified starch showed a lower pasting profile compared to the native starch; however, the modified starch showed the ability to form a film. The starch-PALF films were obtained by the casting method and partially characterized. These films presented better mechanical properties compared to the unmodified films. Also, these films could compete with conventional non-biodegradable plastics.

Thermal, morphological and structural characterization of a copolymer of starch and polyethylene.

The objective of this paper was to perform a copolymerization between polyethylene and starch in order to obtain new environmentally friendly materials. The copolymer obtained was characterized thermally, morphologically and structurally, including its pasting profile. The starch-g-PE copolymer showed lower thermal stability compared to the control materials. FTIR analysis determined that the chemical bond signal between the starch and polyethylene in the copolymer overlaps with the native starch signals. The signal from this chemical bond was assigned by proton NMR spectroscopy at δ 4.45 ppm. X-ray studies of the copolymer showed a material with more amorphous characteristics compared to native starch. SEM analysis demonstrated the presence of cracks in the starch granules which favored the chemical interaction between the polymers. The pasting behavior of the copolymer was less pronounced compared to native starch. Therefore, the copolymerization of both polymers could be an alternative to recycle polyethylene and make biodegradable materials.