RESUMEN
INTRODUCTION: The purpose of this study is to compare the clinical and radiological outcomes of patients undergoing open reduction and internal fixation (OR/IF) using a plate or patients undergoing an arthroscopic suture anchor fixation for the greater tuberosity (GT) fracture of the proximal humerus. The purpose of this study is to compare the clinical and radiological outcomes of patients undergoing OR/IF or an arthroscopic suture anchor fixation for the GT fracture. MATERIALS AND METHODS: Between January, 2010 and December, 2020, 122 patients with GT fracture underwent operative fixation. Either OR/IF using proximal humeral locking plate (50 patients) or arthroscopic suture anchor (72 patients) fixation was performed. Fourteen patients were lost to follow-up and finally, 108 patients were enrolled in this study. We divided these patients into two groups: (1) OR/IF group (Group I: 44 patients) and arthroscopic anchor fixation group (Group II: 64 patients). The primary outcome was subjective shoulder function (shoulder functional scale). Secondary outcomes were range of motion, and complications including GT fixation failure, fracture migration, or neurologic complication. Also, age, sex, BMI, operation time, shoulder dislocation, fracture comminution, AP (anteroposterior), SI (superoinferior) size and displacement were evaluated and compared between two groups. RESULTS: Both groups showed satisfactory clinical and radiological outcomes at mid-term follow-up. Between 2 groups, there were no significant differences in age, sex, BMI, presence of shoulder dislocation or comminution. Group II showed higher clinical scores except VAS score (p < 0.05) and longer surgical times (95.3 vs. 61.5 min). Largest fracture displacement (Group I vs. II: SI displacement: 40 vs. 13 mm, and AP displacement: 49 vs. 11 mm) and higher complication rate (p = 0.049) was found in Group I. CONCLUSIONS: Both arthroscopic anchor fixation and open plate fixation methods showed satisfactory outcomes at mid-term follow-up. Among them, OR/IF is preferred for larger fracture displacement (> 5 mm) and shorter operation time However, arthroscopic anchor fixation group showed better clinical outcomes and less complications than the OR/IF group. LEVEL OF EVIDENCE: Level 4, Case series with subgroup analysis.
Asunto(s)
Fracturas Conminutas , Luxación del Hombro , Fracturas del Hombro , Humanos , Hombro , Anclas para Sutura , Fijación Interna de Fracturas/efectos adversos , Fijación Interna de Fracturas/métodos , Húmero , Fracturas del Hombro/diagnóstico por imagen , Fracturas del Hombro/cirugía , Luxación del Hombro/cirugía , Placas Óseas , Resultado del Tratamiento , Estudios RetrospectivosRESUMEN
Background: This study sought to evaluate the effect of atelocollagen insertion into the bone-tendon interface of the repaired tendon after arthroscopic rotator cuff repair for high-grade partial articular supraspinatus tendon avulsion (PASTA) lesions. Purpose: To compare clinical and radiological outcomes of atelocollagen-inserted rotator cuff repair and atelocollagen-noninserted rotator cuff repair in the high-grade PASTA lesions. Study Design: Cohort study; Level of evidence, 3. Methods: The data from 301 consecutive patients who underwent arthroscopic rotator cuff repair of PASTA lesions between January 2017 and June 2020 were retrospectively reviewed. Patients with minimum 2-year follow-up data were included and divided into 2 groups: those treated with transtendon suture-bridge repair without additional augmentation (group 1) and those with atelocollagen-inserted transtendon suture-bridge repair (group 2). Patients in group 2 were matched 1:1 to patients in group 1 using propensity score matching (n = 68 per group); and pain visual analog scale, American Shoulder and Elbow Surgeons, University of California, Los Angeles, Korean Shoulder Scoring System, Simple Shoulder Test, and range of motion scores were compared between these groups. Also, repaired tendon integrity and thickness were compared immediately, 6 months, and 1 year after surgery on magnetic resonance imaging (MRI) using the vertical distance from the midpoint footprint of the greater tuberosity. Results: In most comparisons, there were no significant differences in outcome measures and range of motion between groups. However, less residual discomfort at the final follow-up was also documented in group 2 (P = .043). Also, the difference in forward flexion was 3.7° at 1 year and 5.4° at final follow-up, and the difference in abduction was 2.2° at final follow-up, which were all significantly greater in the experimental group. Group 2 showed significant greater tendon thickness of the repaired tendon immediately, 6 months, and 1 year after surgery on MRI (P≤ .001). Conclusion: Addition of atelocollagen did not improve outcome scores. However, there was slightly greater flexion and abduction at final follow-up. Also, there was less residual discomfort at final follow-up.
RESUMEN
Revision repair of retorn partial articular supraspinatus tendon avulsion (PASTA) lesion is difficult for poor tendon quality without tear completion and repair. Trans-tendon suture bridge repair with biceps tendon augmentation can preserve the intact bursal side cuff attachment and has shown satisfactory clinical outcomes. Moreover, trans-tendon suture bridge rotator cuff repair technique, along with biceps tendon augmentation, reinforces high-grade PASTA lesions by moving the tenotomized biceps tendon into the torn articular side cuff defect with added advantage of blood supply through the tenotomized biceps tendon graft. Retear after trans-tendon repair of high-grade PASTA lesions was rare, and its poor tendon quality cause the revision repair to be too difficult. Without tear completion and rotator cuff repair, this arthroscopic trans-tendon suture bridge rotator cuff repair with biceps tendon augmentation is a reliable procedure that could be expected to produce improved short-term functional and radiologic outcomes, along with improved tendon quality of repaired tendon.
RESUMEN
OBJECTIVE: This is a rare study comparing the radiological and functional outcomes of fixation after reduction with in situ fixation group using Femoral Neck System (FNS). The aim of this study was to introduce a simple, innovative, minimally invasive method to reduce valgus-impacted and tilted femoral neck fractures without soft tissue or cartilage injury. METHODS: A retrospective comparative analysis of 46 patients between May 2020 and February 2022 was performed. In the control group, 23 patients underwent in situ fixation without reduction. In the study group, another 23 patients were managed by fixation after reduction using a percutaneous pull-out technique with a full threaded Steinmann pin. Caput-collum-diaphysis (CCD) angle, tilt, and femoral neck shortenings were compared between the two groups. In addition, Harris Hip Score (HHS) was evaluated and compared at 1 year after surgery. Basically, independent samples t-test was used to compare radiological and functional results. RESULTS: Patients' initial valgus and tilt angles were not significantly different between the groups (n.s.). However, the CCD and tilt angles measured immediately and at one year postoperatively were significantly different between the groups (p < 0.05). Regarding femoral neck shortening, shortening in the three directions, the x, y, and z vectors, was significantly less in the reduction group immediately postoperatively and at 1 year post-surgery (p < 0.05). The mean HHS at 1 year postoperatively was 79.7 ± 8.4 in the in situ fixation group and 87.9 ± 6.6 in the reduction groups, and there was a significant difference (p < 0.05). CONCLUSION: The pull-out method with a threaded Steinmann pin to reduce valgus-impacted and tilted femoral neck fracture is safe and effective for accomplishing anatomical restoration. This may achieve successful bone union and maintain the femoral neck length and original tilt without nearby soft tissue or cartilage injury.
RESUMEN
BACKGROUND: Total shoulder arthroplasty (TSA) can fail for several reasons, such as component loosening, periprosthetic fracture, instability, infection, soft tissue failure, or joint overstuffing. Severe metallosis without loose glenoid components after TSA may result in the need for revision to reverse TSA. CASE PRESENTATION: Four years before the current presentation, an 86-year-old woman suffered from right shoulder pain and swelling. The initial diagnosis was osteoarthritis of the shoulder joint, for which she underwent TSA. Four years later, she complained of shoulder joint pain, swelling, and limited range of motion. On sonography, subscapularis and supraspinatus tendon tears were identified. Plain radiographs and computed tomography (CT) scans showed metallosis around the shoulder joint. Due to the rocking horse mechanism, wear of the upper portion of the glenoid component and bearing caused a foreign-body reaction and severe metallosis around the joint. Due to a massive rotator cuff tear combined with glenoid component wear, the patient eventually underwent reverse TSA (RTSA) and was satisfied with the final results. CONCLUSIONS: Severe metallosis due to glenoid component wear combined with a massive rotator cuff tear in TSA may cause the need for revision to RTSA.