Thermal Stability and Heat Transfer of Polyurethanes for Joints Applications of Wooden Structures.

Wood characterized by desired mechanical properties and wood joining material is essential for creating wooden structures. The polymer adhesives are suitable for such applications due to the possibility of energy dissipation from stresses generated by wooden structures and the elimination of thermal bridging, which are common problems in metal joining materials. This research focuses on the thermophysical properties of the laboratory-prepared flexible and rigid polyurethanes to select an appropriate polymer adhesive. Our results showed that the highest thermal stability was in the case of the new PSTF-S adhesive, which reached 230 °C, but the lowest mass loss in the air environment was around 54% for the PS material. The mean thermal expansion coefficient for F&R PU adhesives was 124-164∙10-6 K-1. The thermal diffusivity of examined adhesives varied between 0.100 and 0.180 mm2s-1. The thermal conductivity, depending on the type of polyurethane, was in the 0.13-0.29 W∙m-1∙K-1 range. The relative decrease in thermal diffusivity after heating the adhesives to 150 °C was from 2% for materials with the lowest diffusivity to 23% for the PU with the highest value of heat transfer. It was found that such data can be used to simulate wooden construction joints in future research.

Stabilization of Fish Protein-Based Adhesive by Reduction of Its Hygroscopicity.

Protein-based fish adhesives have historically been used in various bonding applications; however, due to the protein's high affinity for water absorption, these adhesives become destabilized in high-moisture environments, resulting in reduced bondline strength and early failure. This limitation makes them unsuitable for industrial applications with higher demands. To address this issue, water-insoluble raw powder materials such as iron, copper, or zeolite were incorporated into natural fish adhesives. In this study, the hygroscopicity, dry matter content, thermal analysis (TGA/DSC), FT-IR spectroscopy, surface tension measurements, vapour permeability, and scanning electron microscope (SEM) of the modified adhesives were determined. In addition, the bonding properties of the modified adhesives were evaluated by the tensile shear strength of the lap joints, and mould growth was visually inspected. The resulting modified protein-based adhesives demonstrated improved stability in high humidity environments. Enhancing the hygroscopic properties of protein-based fish adhesives has the potential to unlock new opportunities and applications, providing a healthier and more environmentally sustainable alternative to petroleum-based adhesives.

Utilization of Torrefied and Non-Torrefied Short Rotation Willow in Wood-Plastic Composites.

The torrefaction process is widely used in the energy field, but the characteristics of the torrefied wood also have positive effects on the production of wood plastic composites. In this study, short-rotation shrub willow was torrefied at 225 and 300 °C and incorporated into polypropylene composites filled with changing levels of weight percent (wt%) of non-torrefied and torrefied (5, 15, 25, and 40 wt%) wood. Nine different formulations were extruded for mechanical, thermal, and water absorption properties. The tensile properties of composites were not affected by any level of torrefaction, while higher flexure properties were in favor of lower wt% of torrefied wood. The slowest rate of thermal degradation was confirmed for the highest wt% of torrefied wood with a torrefaction temperature of 300 °C. In contrast, the presence of torrefied wood in composites did not show a difference in crystallization or melting temperatures. The most noticeable contribution of torrefaction temperature and wt% was found for water-absorbing properties, where the higher torrefaction temperature and largest wt% of torrefied wood in the composite resulted in decreased water uptake.