RESUMEN
A new technology is described that enables us to completely exclude liquid discharges during production of drinking water from surface sources. The proposed described technological scheme separates the natural water into a stream of purified drinking water and dewatered sludge. The sludge moisture has a value of 80 percent. The experimental program is described to treat the natural water with nanofiltration membranes and to produce a drinking-quality water with recovery value of 0.99 and higher. Concentrate of membrane plant is mixed with the wet sludge and the reject effluent after sludge dewatering is again treated by reverse osmosis membranes and returned back to the sludge thickening tank. Results of experiments to treat reject water after sludge dewatering are presented. The use of nanofiltration membranes provides reduction in the Total Dissolved Solids content (TDS), aluminum, color and oxidation to meet drinking water standards. Experimental plots are presented that can be used to select membrane characteristics and to predict product water chemical composition at each stage of the membrane treatment scheme. Concentrate of membrane treatment plant is mixed with the wet sludge in the thickening tank. The sludge, after the thickening tank, is dewatered using either filter-press or centrifugal equipment. The reject (or fugate), after sludge dewatering, is treated by membrane facility to separate it into deionized water stream and concentrate stream. The deionized water can be mixed with the feed water or drinking water and the concentrate stream is returned back to the thickening tank. Thus, the salt balance is maintained in the thickening tank, whereby all dissolved salts and impurities that are rejected by membranes are collected in the thickening tank, and then are withdrawn together with the dewatered sludge. Based on the results of experimental data processing, balance diagrams of the sludge dehydration process with waste water purification at the membrane plant and with the addition of the membrane plant concentrate to the sludge thickener are presented, according to which all contaminants removed by the membranes are removed together with the sludge.
RESUMEN
Adsorption of polymeric inhibitor molecules to calcium carbonate crystal surface was investigated. Inhibiting efficiencies of phosphonic acid-based antiscalants are dependent on the amount of adsorbed material on the growing crystal surface. A strong antiscalant even at a small dose provides the necessary rate of adsorption. Comparison of two phosphonic-based antiscalants was made both in laboratory and industrial conditions. A distinguishing feature of the strong antiscalant is the presence of aminotris (metylene-diphosphonic acid) ATMP. Experimental dependencies of antiscalant adsorption rates on the antiscalant dosage values were determined. Emphasis is given to the use of nanofiltration membranes that possess lower scaling propensities. Modernization is presented to reduce operational costs due to antiscalant and nanofiltration membranes. The main conclusion is that control of scaling should be implemented together with the use of nanofiltration membranes.
RESUMEN
Mine water usually contains heavy metals and other inorganic and organic pollutants that contaminate water bodies. Reverse osmosis (RO) techniques are capable of producing purified water that meets discharge regulations. However, the problem of RO concentrate disposal and utilization is still not solved. The well-known zero liquid discharge (ZLD) process provides total concentrate utilization at the power industries but seems unreasonably expensive for the treatment of large amounts of mine water due to required chemical softening and the evaporation of concentrate. In the present article, a new approach to increase the recovery of reverse osmosis and to avoid high operational costs is demonstrated and discussed. The new technique involves radical RO concentrate flow reduction and withdrawal, together with dewatered sludge. The idea to "hide" concentrate in dewatered sludge is proposed and demonstrated during experiments. The article demonstrates results of the conducted experimental program aimed at reduction of volumes of all liquid wastes produced during mine water treatment using a new approach to concentrate it with a cascade of nanofiltration membranes and to reach a TDS value of 110-120 g per liter. The obtained concentrate is mixed with the wet sludge, which is further dewatered and withdrawn together with the dewatered sludge. Experiments are conducted that demonstrate a reduction in calcium in the concentrate due to deposition of calcium carbonate on the "seed crystals" in the circulation mode. Another distinguishing feature of the new technique is the separation of concentrate into two streams containing high concentrations of monovalent ions (sodium and ammonium chlorides) and divalent ions (calcium, magnesium and copper sulphates). Flow diagrams of the processes are presented to demonstrate the water treatment technique used to produce deionized water and two types of sludges: sludge after clarification and sludge after calcium carbonate deposition.
RESUMEN
Understanding of crystal formation and growth conditions in reverse osmosis membrane channels enables us to develop efficient tools to control scaling in membrane facilities and increase their recoveries. Crystals are formed in "dead areas" and subsequently get out of them and sediment on membrane surface. Adsorption of polymeric inhibitor molecules to crystal surface was investigated as well as antiscalant behaviour throughout nucleation in "dead areas" and growth of crystals sedimented on membrane surface. Experimental dependencies of antiscalant adsorption rates on the antiscalant dosage values were determined. Examination of SEM images of crystals demonstrated that their size and amount depend on the supersaturation value reached in the "dead areas". More efficient antiscalants delay the beginning of nucleation and reduce the rate of crystal growth due to adsorption and blockage of crystal growth process. Antiscaling property of inhibitors is also attributed to their ability to provide certain amount of adsorbent to block crystal growth during nucleation. A test procedure is described that enables us to predict concentrate composition in the "dead areas" and calculate supersaturation values that correspond to beginning of nucleation.
RESUMEN
Calcium carbonate scaling in reverse osmosis (RO) desalination process is studied in the presence of two novel fluorescent-tagged scale inhibitors 1,8-naphthalimide-tagged polyacrylate (PAA-F1) and 1-hydroxy-7-(6-methoxy-1,3-dioxo-1H-benzo[de]isoquinolin-2(3H)-yl)heptane-1,1-diyl-bis(phosphonic acid) (HEDP-F) by fluorescent microscopy (FM) and scanning electron microscopy (SEM). Both antiscalants diminished the mean size of calcite crystals relative to the blank experiment. The behavior and localization of HEDP-F and PAA-F1 during calcite scale formation on membrane surface was found to be significantly different from the distribution in similar RO experiments with gypsum, reported earlier. In the former case, both antiscalants are concentrated exactly on the surface of calcium carbonate crystals, while in the latter one they form their own phases (Ca-HEDP-F and Ca-PAA-F1) and are not detected on gypsum scale. The difference is interpreted in terms of interplay between background calcium concentration and sparingly soluble calcium salts' solubility. HEDP-F reveals slightly higher efficiency than PAA-F1 against calcite scale formation, while PAA-F exhibits a higher ability to change calcite morphology. It is demonstrated that there is a lack of correlation between antiscaling efficacy and ability of antiscalant to change calcium carbonate morphology in a particular case study. An application of fluorescent-tagged antiscalants in RO experiments provides a unique possibility to track the scale inhibitor molecules' localization during calcite scale formation. Fluorescent-tagged antiscalants are presumed to become a very powerful tool in membrane scaling inhibition studies.