Single wire radial junction photovoltaic devices fabricated using aluminum catalyzed silicon nanowires.

Single nanowire radial junction solar cell devices were fabricated using Si nanowires synthesized by Al-catalyzed vapor-liquid-solid growth of the p(+) core (Al auto-doping) and thin film deposition of the n(+)-shell at temperatures below 650 °C. Short circuit current densities of 11.7 mA cm(-2) were measured under 1-sun AM1.5G illumination, showing enhanced optical absorption. The power conversion efficiencies were limited to < 1% by the low open circuit voltage and fill factor of the devices, which was attributed to junction shunt leakage promoted by the high p(+)/n(+) doping. This demonstration of a radial junction device represents an important advance in the use of Al-catalyzed Si nanowire growth for low cost photovoltaics.

Large anisotropic normal-state magnetoresistance in clean MgB2 thin films.

We report a large normal-state magnetoresistance with temperature-dependent anisotropy in very clean epitaxial MgB2 thin films (residual resistivity much smaller than 1 microOmega cm) grown by hybrid physical-chemical vapor deposition. The magnetoresistance shows a complex dependence on the orientation of the applied magnetic field, with a large magnetoresistance (Delta(rho)/(rho)0=136%) observed for the field H perpendicular ab plane. The angular dependence changes dramatically as the temperature is increased, and at high temperatures the magnetoresistance maximum changes to H||ab. We attribute the large magnetoresistance and the evolution of its angular dependence with temperature to the multiple bands with different Fermi surface topology in MgB2 and the relative scattering rates of the sigma and pi bands, which vary with temperature due to stronger electron-phonon coupling for the sigma bands.

Enhancement of the superconducting transition temperature of MgB2 by a strain-induced bond-stretching mode softening.

We report a systematic increase of the superconducting transition temperature T(c) with a biaxial tensile strain in MgB2 films to well beyond the bulk value. The tensile strain increases with the MgB2 film thickness, caused primarily by the coalescence of initially nucleated discrete islands (the Volmer-Weber growth mode.) The T(c) increase was observed in epitaxial films on SiC and sapphire substrates, although the T(c) values were different for the two substrates due to different lattice parameters and thermal expansion coefficients. We identified, by first-principles calculations, the underlying mechanism for the T(c) increase to be the softening of the bond-stretching E(2g) phonon mode, and we confirmed this conclusion by Raman scattering measurements. The result suggests that the E(2g) phonon softening is a possible avenue to achieve even higher T(c) in MgB2-related material systems.