Enhanced Power Conversion Efficiency of Graphene/Silicon Heterojunction Solar Cells Through NiO Induced Doping.

We report a doping strategy, where nickel oxide (NiO) nanoparticle film coating is employed for graphene/Si heterojunction solar cells to improve the power conversion efficiency (PCE). NiO doping has been shown to improve the short circuit current (J(SC)) by 12%, open circuit voltage (V(OC)) by 25% and fill factor (FF) by 145% of the cells, in turn increasing the PCE from 1.37% to 4.91%. Furthermore, NiO doped graphene/Si solar cells don't show any significant performance degradation over 10 days revealing that NiO doping can be a promising approach for practical applications of graphene in solar cells.

Liquefied gas electrolytes for electrochemical energy storage devices.

Electrochemical capacitors and lithium-ion batteries have seen little change in their electrolyte chemistry since their commercialization, which has limited improvements in device performance. Combining superior physical and chemical properties and a high dielectric-fluidity factor, the use of electrolytes based on solvent systems that exclusively use components that are typically gaseous under standard conditions show a wide potential window of stability and excellent performance over an extended temperature range. Electrochemical capacitors using difluoromethane show outstanding performance from -78° to +65°C, with an increased operation voltage. The use of fluoromethane shows a high coulombic efficiency of ~97% for cycling lithium metal anodes, together with good cyclability of a 4-volt lithium cobalt oxide cathode and operation as low as -60°C, with excellent capacity retention.

Solution-Processed CoFe2O4 Nanoparticles on 3D Carbon Fiber Papers for Durable Oxygen Evolution Reaction.

We report CoFe2O4 nanoparticles (NPs) synthesized using a facile hydrothermal growth and their attachment on 3D carbon fiber papers (CFPs) for efficient and durable oxygen evolution reaction (OER). The CFPs covered with CoFe2O4 NPs show orders of magnitude higher OER performance than bare CFP due to high activity of CoFe2O4 NPs, leading to a small overpotential of 378 mV to get a current density of 10 mA/cm(2). Significantly, the CoFe2O4 NPs-on-CFP electrodes exhibit remarkably long stability evaluated by continuous cycling (over 15 h) and operation with a high current density at a fixed potential (over 40 h) without any morphological change and with preservation of all materials within the electrode. Furthermore, the CoFe2O4 NPs-on-CFP electrodes also exhibit hydrogen evolution reaction (HER) performance, which is considerably higher than that of bare CFP, acting as a bifunctional electrocatalyst. The achieved results show promising potential for efficient, cost-effective, and durable hydrogen generation at large scales using earth-abundant materials and cheap fabrication processes.

Dye-sensitized solar cell constructed with titanium mesh and 3-D array of TiO2 nanotubes.

We have designed and constructed dye sensitized solar cells based on new, 3-D configurations of TiO(2) nanotubes. The overall efficiency of our best cells is 5.0% under standard air mass 1.5 global (AM 1.5 G) solar conditions, and the incident photon-to-current efficiency exceeds 60% over a broad part of the visible spectrum. Unlike prior nanotube-based cells where tubes are grown vertically in a 2-D array, the anodes of the present cells consist of tubes that extend radially in a 3-D array from a grid of fine titanium wires. The nanotubes are tens of micrometers in length, and the radial nature of the anode allows the photon absorption path length to exceed the electron transport distance (nanotube length). The cells are front-illuminated and do not require a transparent conductive oxide substrate at either the anode or cathode. The use of 3-D configured nanotubes and low-resistance titanium metal substrates are expected to enhance the performance and simplify the construction of large area dye-sensitized solar cells.