Formulation of sumatriptan succinate orodispersible tablets using chitosan and sodium starch glycolate for immediate migraine relief.

Migraine is one of the common neurological disease affecting around 23% of the Pakistani population. Prompt treatment is required to regain the functional ability of patients. The present study was designed to develop sumatriptan succinate orodispersible tablets that would quickly overcome acute migraine episodes using 22 full-factorial design. The chitosan and sodium starch glycolate were taken as independent variables; friability, disintegration, dispersion time and water absorption ratio as response variables. Eight trial formulations were generated by Design Expert® software. The main effect plots were used to check the interaction of formulations with response variables. All trial formulations showed good micromeritic properties in terms of angle of repose (19.59o-24.57°), Carr's index (17.08-24.90%) and Hausner's ratio (1.20-1.33). The tablets wetted quickly (17.1- 39 sec) in dispersion medium, showed higher water absorption ratio (188-341 sec) and disintegrated quickly (13-20 sec) with an excellent dissolution rate (94-99%). The main effect plots show interactions between the independent variables against most of the study responses. A 22 full-factorial model was found to be effective in studying the influence of formulation variables on response parameters. Both chitosan and sodium starch glycolate can be used in combination to fabricate an effective orodispersible formulation of sumatriptan succinate.

Development and evaluation of a cream containing solid lipid nanoparticles loaded with Vitamin E.

Solid lipid nanoparticles (SLNs) have several potential applications in the topical drug delivery. The current project aimed to prepare and characterize SLNs loaded with vitamin E for topical administration and incorporating the prepared SLNs in a cream base. Further, the permeation of prepared SLNs was studied through a synthetic membrane and the release profiles were compared with vitamin E cream. The prepared SLNs were subjected to stability studies at two different temperatures. Hot homogenization followed by dilution technique was used for the preparation of SLNs. In this project, PDMS membrane was used to mimic the skin for permeation studies. From the results of this study, it can be concluded that prepared SLNs had enhanced the permeation of vitamin E as compared to vitamin E cream.

Biowaiver studies of Metronidazole tablets (400mg): An alternative to In-vivo bioequivalence Studies.

The aim of the study was to investigate the dissolution behavior of commercially available brands of metronidazole and to provide basic tool to evaluate the comparative effectiveness and interchangeability of generic brands under biowaiver conditions. The dissolution test for six brands of metronidazole 400mg tablets was performed and physical controls were analyzed. Basket Rack methods at 100rpm were used to estimate release pattern of drug. Pharmaceutical parameters of tablets were analyzed. In order to evaluate dissolution profiles, multiple point dissolution were performed and calculated 85.96±0.41 to 90.56±0.93 % within 15 minutes in pH 1.2,85.50±1.40 to 88.99±0.80% in pH 4.5 and 85.37±1.94 to 92.79±0.89% in pH 6.8 dissolution medium respectively. Five different kinetics have been studied to predict and evaluate the acceptability level of drug release. The results show that Hixson-Crowell, first-order and Weibull demonstrated the drug release with R2> 0.95 that predicted the tablets were pharmaceutically equivalent. One-way ANOVA at p >0.05 level and similarity factors (f2) were used to estimate the discrepancy and intimacy among the brands. It is a need of time to constantly monitor the marketed generic drugs products and their release profiles to confirm their in vitro bioequivalence which can help to reduce the time, cost and unnecessary exposure of healthy subjects to medicines.

Development and validation of HPLC analytical method for nepafenac in ophthalmic dosage form (suspension).

The aim of the present study was to develop and validate an analytical method for the estimation of nepafenac as a raw material as well as in dosage form (suspension) by using reverse phase high performance liquid chromatographic (RP-HPLC). The target was to obtain an easy, rapid, reproducible as well as a rugged method. The HPLC system that was used in the proposed study was LC-20AD liquid chromatograph equipped with SPD-20A UV-VIS detector. The separation was performed on C18 column which was attached with loop 20 ß l. Elution was done at ambient temperature with a mobile phase consisting of acetonitrile: Water (40: 60v/v) at a flow rate of 1ml/min and at a wavelength of 254 nm. The proposed method was validated as per the ICH guidelines. The retention time for nepafenac was 7.49 minutes (% CV=0.0076). The percentage coefficient variation (CV) of six consecutive peak areas of injections was 0.34% with tailing factor 1.76. The peak area responses were linear within the concentration range of 0.078-20.0 ßg/ml (R(2)=0.9993). The sensitivity of the method could be evaluated by limits of detection (LOD) (0.0195 ß g/ml) and limits of quantitation (LOQ) (0.039 ß g/ml). Nepafenac drug is s in its diluent that could see by intra-day (% CV =0.45-1.96) and inter-day variation (%CV=0.173-1.898%). The accuracy and recovery results of 80%, 100% and 120% were 97.40% to 102.10% with % CV of 0.3201% to 1.3496%. The robustness and ruggedness of the method are significantly broader and is reproducible. It could be used as a more convenient, efficient, easy and time saving method for the analysis of drug in raw material as well as in dosage form (ophthalmic suspension).

Development and assessment of immediate-release tablets containing clopidogrel bisulphate & aspirin-strategy for optimizing the combination formulation.

The main goal of the study was to improve the compliance and convenience of patients by designing and development of an immediate release (IR) fixed-dose combination (Clopidogrel bisulphate and Aspirin) tablets. The proposed combination product utilizes Clopidogrel to protect the moisture-sensitive aspirin component, enhancing its stability against atmospheric conditions. Response-surface approach (Design Expert vs. 13) was used to generate this IR tablet by calculating the right composition of independent variables such as Microcrystalline cellulose 102, pregelatinized starch and Hydroxypropyl cellulose. 32 factorial design was used to estimate the effects of these independent variables on the responses of dependent variables (disintegration & friability) and constructed a total of nine (9) formulations. Pre and Post formulation, quality control parameters were investigated as per pharmacopeia. A systematic approach was used for the optimization process and a prototype checkpoint batch (CPB) based on the better contrast of independent variables was prepared. In vitro analysis of formulations was carried out to estimate the responses. Friability was found in the range of 0.088-1.076%w/w, except F1 = 1.076 all are within limits (NMT 1.0%). Disintegration time was recorded 7.3 ± 1.20 as lower and 24.5 ± 1.63 min was the highest. The release of drugs from their dosage form was fast and rapid, for clopidogrel after 15min was 70.42-96.82% with SD ± 8.71 and aspirin was 69.88-91.49% in 15 min with SD ± 6.41, all the tablets were released more than 80% in 20 min. The stability outcomes of CPB tablets after 15 days of stress study (60 ± 2°C and 75 ± 5%) indicated good compatibility and stability of APIs with excipients. It was concluded that the direct compression method can be preferred to prepare a combination product with cost-effectiveness. It was also concluded that the proposed methodology could increase Aspirin's stability and allow for an aqueous coating system to finish the product with a film coating. By using Design Expert software, the best composition of the formulation can be selected and optimized in a short period of time with minimum trial and errors. The results also demonstrated that the use of a fixed-dose combination tablet instead of the individual is expected to be more convenient to patients and thus improves patient compliance and decreases the occurrence of adverse effects and side effects.

Predictors of Successful First-Line Helicobacter pylori Eradication with Fluoroquinolones in Pakistan: A Prospective Exploration of Demographic and Clinical Factors.

Growing antibiotic resistance complicates H. pylori eradication, posing a public health challenge. Inconclusive research on sociodemographic and clinical factors emphasizes the necessity for further investigations. Hence, this study aims to evaluate the correlation between demographic and clinical factors and the success rates of H. pylori eradication. A group of 162 H. pylori-positive patients were allocated randomly to receive either a ten-day moxifloxacin-based triple therapy or a levofloxacin-based sequential therapy. Eradication success was determined through the stool antigen test. Logistic regression analysis was utilized to figure out potential factors that contribute to H. pylori eradication success. Significantly higher H. pylori eradication rates were observed in the middle age group (COR: 3.671, p = 0.007), among females (p = 0.035), those with BMI ≥ 25 (COR: 2.011, p = 0.045), and non-smokers (COR: 2.718, p = 0.018). In multivariate analysis, age and smoking emerged as significant predictors (p < 0.05). Patients with comorbidities, excluding diabetes and hypertension (COR: 4.432, p = 0.019), dyspepsia (COR: 0.178, p < 0.001), and moxifloxacin triple therapy (COR: 0.194, p = 0.000), exhibited higher chances of eradication (p < 0.05). Further research is vital for tailored approaches to enhance eradication success.

Incidence of multidrug resistance and extended-spectrum beta-lactamase expression in community-acquired urinary tract infection among different age groups of patients.

OBJECTIVES: Urinary tract infection (UTI) is a frequent disorder and depends on age and gender. Ineffective empiric treatment of UTI is common when associated with extended-spectrum beta-lactamase (ESBL)-producing Escherichia coli and Klebsiella pneumoniae. The aim of the study was to investigate the prevalence of Gram-negative uropathogens of E. coli and K. pneumoniae in different age groups along with the identification of ESBL-producing uropathogens and antimicrobial susceptibility profiles. MATERIALS AND METHODS: A total of 247 uropathogens of E. coli and K. pneumoniae were collected over a period of 1 year (January-December 2015) from various diagnostic centers of Karachi city (Pakistan). Antimicrobial susceptibility analysis was performed by disc diffusion method, and identification of ESBL was performed by double disc synergy test. Categorical data of ESBL and non-ESBL uropathogens were analyzed by Pearson's Chi-square test. RESULTS: The study of 247 patients with community-acquired UTI comprised 72% females and 28% males, illustrating an increased prevalence of UTIs among females. It was also revealed that 90% belonged to the age group of 16-30 years whereas 78% related to the age group of 46-60 years. ESBL was found positive in 33.5% (63/188) of E. coli and 15.25% (9/59) in K. pneumonia, with a significant association i.e., (p =0.007). Amikacin, fosfomycin, imipenem, and tazobactam/piperacillin were found to be the effective treatment options. A significant association was found between ESBL-producing uropathogens against ciprofloxacin, enoxacin, and amoxicillin/clavulanic acid resistance (P < 0.05). CONCLUSIONS: It was concluded that for effective treatment of UTIs, appropriate screening of ESBL and culture sensitivity must be employed instead of empiric treatment.