Comparative biochemical analysis after steam pretreatment of lignocellulosic agricultural waste biomass from Williams Cavendish banana plant (Triploid Musa AAA group).

The accessibility of fermentable substrates to enzymes is a limiting factor for the efficient bioconversion of agricultural wastes in the context of sustainable development. This paper presents the results of a biochemical analysis performed on six combined morphological parts of Williams Cavendish Lignocellulosic Biomass (WCLB) after steam cracking (SC) and steam explosion (SE) pretreatments. Solid (S) and liquid (L) fractions (Fs) obtained from SC pretreatment performed at 180°C (SLFSC180) and 210°C (SLFSC210) generated, after diluted acid hydrolysis, the highest proportions of neutral sugar (NS) contents, specifically 52.82 ± 3.51 and 49.78 ± 1.39%w/w WCLB dry matter (DM), respectively. The highest proportions of glucose were found in SFSC210 (53.56 ± 1.33%w/w DM) and SFSC180 (44.47 ± 0.00%w/w DM), while the lowest was found in unpretreated WCLB (22.70 ± 0.71%w/w DM). Total NS content assessed in each LF immediately after SC and SE pretreatments was less than 2%w/w of the LF DM, thus revealing minor acid autohydrolysis consequently leading to minor NS production during the steam pretreatment. WCLB subjected to SC at 210 °C (SC210) generated up to 2.7-fold bioaccessible glucan and xylan. SC and SE pretreatments showed potential for the deconstruction of WCLB (delignification, depolymerization, decrystallization and deacetylation), enhancing its enzymatic hydrolysis. The concentrations of enzymatic inhibitors, such as 2-furfuraldehyde and 5-(hydroxymethyl)furfural from LFSC210, were the highest (41 and 21 µg ml(-1), respectively). This study shows that steam pretreatments in general and SC210 in particular are required for efficient bioconversion of WCLB. Yet, biotransformation through biochemical processes (e.g., anaerobic digestion) must be performed to assess the efficiency of these pretreatments.

Comparative biochemical analysis during the anaerobic digestion of lignocellulosic biomass from six morphological parts of Williams Cavendish banana (Triploid Musa AAA group) plants.

We studied banana lignocellulosic biomass (BALICEBIOM) that is abandoned after fruit harvesting, and assessed its biochemical methane potential, because of its potential as an energy source. We monitored biogas production from six morphological parts (MPs) of the "Williams Cavendish" banana cultivar using a modified operating procedure (KOP) using KOH. Volatile fatty acid (VFA) production was measured using high performance liquid chromatography. The bulbs, leaf sheaths, petioles-midribs, leaf blades, rachis stems, and floral stalks gave total biogas production of 256, 205, 198, 126, 253, and 221 ml g⁻¹ dry matter, respectively, and total biomethane production of 150, 141, 127, 98, 162, and 144 ml g⁻¹, respectively. The biogas production rates and yields depended on the biochemical composition of the BALICEBIOM and the ability of anaerobic microbes to access fermentable substrates. There were no significant differences between the biogas analysis results produced using KOP and gas chromatography. Acetate was the major VFA in all the MP sample culture media. The bioconversion yields for each MP were below 50 %, showing that these substrates were not fully biodegraded after 188 days. The estimated electricity that could be produced from biogas combustion after fermenting all of the BALICEBIOM produced annually by the Cameroon Development Corporation-Del Monte plantations for 188 days is approximately 10.5 × 106 kW h (which would be worth 0.80-1.58 million euros in the current market). This bioenergy could serve the requirements of about 42,000 people in the region, although CH4 productivity could be improved.

Effect of physicochemical characteristics of cellulosic substrates on enzymatic hydrolysis by means of a multi-stage process for cellobiose production.

The effect of two types of cellulose, microcrystalline cellulose and paper pulp, on enzymatic hydrolysis for cellobiose production was investigated. The particle size, the relative crystallinity index and the water retention value were determined for both celluloses. A previously studied multistage hydrolysis process that proved to enhance the cellobiose production was studied with both types of celluloses. The cellobiose yield exhibited a significant improvement (120% for the microcrystalline cellulose and 75% for the paper pulp) with the multistage hydrolysis process compared to continuous hydrolysis. The conversion of cellulose to cellobiose was greater for the microcrystalline cellulose than for the paper pulp. Even with high crystallinity, microcrystalline cellulose achieved the highest cellobiose yield probably due to its highest specific surface area accessible to enzymes and quantity of adsorbed protein.

Evaluation of matrix-assisted laser desorption/ionization mass spectrometry for second-generation lignin analysis.

Matrix-Assisted Laser Desorption/Ionization time-of-flight (MALDI-TOF) mass spectrometry is evaluated as an elucidation tool for structural features and molecular weights estimation of some extracted herbaceous lignins. Optimization of analysis conditions, using a typical organic matrix, namely α-cyano-4-hydroxycinnamic acid (CHCA), in combination with α-cyclodextrin, allows efficient ionization of poorly soluble lignin materials and suppression of matrix-related ions background. Analysis of low-mass fragments ions (m/z 100-600) in the positive ion mode offers a "fingerprint" of starting lignins that could be a fine strategy to qualitatively identify principal inter-unit linkages between phenylpropanoid units. The molecular weights of lignins are estimated using size exclusion chromatography and compared to MALDI-TOF-MS profiles. Miscanthus (Miscanthus x giganteus) and Switchgrass (Panicum Virgatum L.) lignins, recovered after a formic acid/acetic acid/water process or aqueous ammonia soaking, are selected as benchmarks for this study.

A multistage process to enhance cellobiose production from cellulosic materials.

Cellobiose, a disaccharide, is a valuable product that can be obtained from cellulose hydrolysis. In this study, a simple methodology is presented to enhance the production and improve the selectivity of cellobiose during enzymatic hydrolysis of cellulose. The approach consisted of a multistage removal of filtrate via vacuum filtration and resuspension of the retentate. By this process, the remaining solid was further hydrolyzed without additional enzyme loading. Compared to the continuous hydrolysis process, the production of cellobiose increased by 45%. Increased selectivity of cellobiose is due to the loss of beta-glucosidases in the filtrate, while enhanced productivity is likely due to mitigated product inhibition.