RESUMEN
The influence of nanowire (NW) surface states increases rapidly with the reduction of diameter and hence severely degrades the optoelectronic performance of narrow-diameter NWs. Surface passivation is therefore critical, but it is challenging to achieve long-term effective passivation without significantly affecting other qualities. Here, we demonstrate that an ultrathin InP passivation layer of 2-3 nm can effectively solve these challenges. For InAsP nanowires with small diameters of 30-40 nm, the ultrathin passivation layer reduces the surface recombination velocity by at least 70% and increases the charge carrier lifetime by a factor of 3. These improvements are maintained even after storing the samples in ambient atmosphere for over 3 years. This passivation also greatly improves the performance thermal tolerance of these thin NWs and extends their operating temperature from <150 K to room temperature. This study provides a new route toward high-performance room-temperature narrow-diameter NW devices with long-term stability.
RESUMEN
Axially stacked quantum dots (QDs) in nanowires (NWs) have important applications in nanoscale quantum devices and lasers. However, there is lack of study of defect-free growth and structure optimization using the Au-free growth mode. We report a detailed study of self-catalyzed GaAsP NWs containing defect-free axial GaAs QDs (NWQDs). Sharp interfaces (1.8-3.6 nm) allow closely stack QDs with very similar structural properties. High structural quality is maintained when up to 50 GaAs QDs are placed in a single NW. The QDs maintain an emission line width of <10 meV at 140 K (comparable to the best III-V QDs, including nitrides) after having been stored in an ambient atmosphere for over 6 months and exhibit deep carrier confinement (â¼90 meV) and the largest reported exciton-biexciton splitting (â¼11 meV) for non-nitride III-V NWQDs. Our study provides a solid foundation to build high-performance axially stacked NWQD devices that are compatible with CMOS technologies.
RESUMEN
Quantum structures designed using nanowires as a basis are excellent candidates to achieve novel design architectures. Here, triplets of quantum wires (QWRs) that form at the core-shell interface of GaAsP-GaAsP nanowires are reported. Their formation, on only three of the six vertices of the hexagonal nanowire, is governed by the three-fold symmetry of the cubic crystal on the (111) plane. In twinned nanowires, the QWRs are segmented, to alternating vertices, forming quantum dots (QDs). Simulations confirm the possibility of QWR and QD-like behavior from the respective regions. Optical measurements confirm the presence of two different types of quantum emitters in the twinned individual nanowires. The possibility to control the relative formation of QWRs or QDs, and resulting emission wavelengths of the QDs, by controlling the twinning of the nanowire core, opens up new possibilities for designing nanowire devices.
RESUMEN
An avalanche photodiode with a ratio of hole-to-electron ionization coefficients, k = 0, is known to produce negligible excess noise irrespective of the avalanche gain. The low noise amplification process can be utilized to detect very low light levels. In this work, we demonstrated InAs avalanche photodiodes with high external quantum efficiency of 60% (achieved without antireflection coating) at the peak wavelength of 3.48 µm. At 77 K, our InAs avalanche photodiodes show low dark current (limited by 300 K blackbody background radiation), high avalanche gain and negligible excess noise, as InAs exhibits k = 0. They were therefore able to detect very low levels of light, at 15-31 photons per 50 µs laser pulse at 1550 nm wavelength. These correspond to the lowest detected average power by InAs avalanche photodiodes, ranging from 19 to 40 fW. The measurement system's noise floor was dominated by the pre-amplifier. Our results suggest that, with a lower system noise, InAs avalanche photodiodes have high potential for optical detection of single or few-photon signal levels at wavelengths of 1550 nm or longer.
RESUMEN
Self-catalyzed AlGaAs nanowires (NWs) and NWs with a GaAs quantum dot (QD) were monolithically grown on Si(111) substrates via solid-source molecular beam epitaxy. This growth technique is advantageous in comparison to the previously employed Au-catalyzed approach, as it removes Au contamination issues and renders the structures compatible with complementary metal-oxide-semiconductor (CMOS) technology applications. Structural studies reveal the self-formation of an Al-rich AlGaAs shell, thicker at the NW base and thinning towards the tip, with the opposite behavior observed for the NW core. Wide alloy fluctuations in the shell region are also noticed. AlGaAs NW structures with nominal Al contents of 10, 20, and 30% have strong room temperature photoluminescence, with emission in the range of 1.50-1.72 eV. Individual NWs with an embedded 4.9 nm-thick GaAs region exhibit clear QD behavior, with spatially localized emission, both exciton and biexciton recombination lines, and an exciton line width of 490 µeV at low temperature. Our results demonstrate the properties and behavior of the AlGaAs NWs and AlGaAs/GaAs NWQDs grown via the self-catalyzed approach for the first time and exhibit their potential for a range of novel applications, including nanolasers and single-photon sources.
RESUMEN
Coaxial quantum wells (QWs) are ideal candidates for nanowire (NW) lasers, providing strong carrier confinement and allowing close matching of the cavity mode and gain medium. We report a detailed structural and optical study and the observation of lasing for a mixed group-V GaAsP NW with GaAs QWs. This system offers a number of potential advantages in comparison to previously studied common group-V structures ( e. g., AlGaAs/GaAs) including highly strained binary GaAs QWs, the absence of a lower band gap core region, and deep carrier potential wells. Despite the large lattice mismatch (â¼1.7%), it is possible to grow defect-free GaAs coaxial QWs with high optical quality. The large band gap difference results in strong carrier confinement, and the ability to apply a high degree of compressive strain to the GaAs QWs is also expected to be beneficial for laser performance. For a non-fully optimized structure containing three QWs, we achieve low-temperature lasing with a low external (internal) threshold of 20 (0.9) µJ/cm2/pulse. In addition, a very narrow lasing line width of â¼0.15 nm is observed. These results extend the NW laser structure to coaxial III-V-V QWs, which are highly suitable as the platform for NW emitters.