Mechanisms of NFATc3 activation by increased superoxide and reduced hydrogen peroxide in pulmonary arterial smooth muscle.

We recently demonstrated increased superoxide (O2(·-)) and decreased H2O2 levels in pulmonary arteries of chronic hypoxia-exposed wild-type and normoxic superoxide dismutase 1 (SOD1) knockout mice. We also showed that this reciprocal change in O2(·-) and H2O2 is associated with elevated activity of nuclear factor of activated T cells isoform c3 (NFATc3) in pulmonary arterial smooth muscle cells (PASMC). This suggests that an imbalance in reactive oxygen species levels is required for NFATc3 activation. However, how such imbalance activates NFATc3 is unknown. This study evaluated the importance of O2(·-) and H2O2 in the regulation of NFATc3 activity. We tested the hypothesis that an increase in O2(·-) enhances actin cytoskeleton dynamics and a decrease in H2O2 enhances intracellular Ca(2+) concentration, contributing to NFATc3 nuclear import and activation in PASMC. We demonstrate that, in PASMC, endothelin-1 increases O2(·-) while decreasing H2O2 production through the decrease in SOD1 activity without affecting SOD protein levels. We further demonstrate that O2(·-) promotes, while H2O2 inhibits, NFATc3 activation in PASMC. Additionally, increased O2(·-)-to-H2O2 ratio activates NFATc3, even in the absence of a Gq protein-coupled receptor agonist. Furthermore, O2(·-)-dependent actin polymerization and low intracellular H2O2 concentration-dependent increases in intracellular Ca(2+) concentration contribute to NFATc3 activation. Together, these studies define important and novel regulatory mechanisms of NFATc3 activation in PASMC by reactive oxygen species.

Parallel scanning near-field photolithography: the snomipede.

The "Millipede", developed by Binnig and co-workers (Bining, G. K.; et al. IBM J. Res. Devel. 2000, 44, 323.), elegantly solves the problem of the serial nature of scanning probe lithography processes, by deploying massive parallelism. Here we fuse the "Millipede" concept with scanning near-field photolithography to yield a "Snomipede" that is capable of executing parallel chemical transformations at high resolution over macroscopic areas. Our prototype has sixteen probes that are separately controllable using a methodology that is, in principle, scalable to much larger arrays. Light beams generated by a spatial modulator or a zone plate array are coupled to arrays of cantilever probes with hollow, pyramidal tips. We demonstrate selective photodeprotection of nitrophenylpropyloxycarbonyl-protected aminosiloxane monolayers on silicon dioxide and subsequent growth of nanostructured polymer brushes by atom-transfer radical polymerization, and the fabrication of 70 nm structures in photoresist by a Snomipede probe array immersed under water. Such approaches offer a powerful means of integrating the top-down and bottom-up fabrication paradigms, facilitating the reactive processing of materials at nanometer resolution over macroscopic areas.

Heat shock protein 90α increases superoxide generation from neuronal nitric oxide synthases.

Neuronal nitric oxide synthase (nNOS) generates superoxide, particularly at sub-optimal l-arginine (l-Arg) substrate concentrations. Heat shock protein 90 (Hsp90) was reported to inhibit superoxide generation from nNOS protein. However, commercially available Hsp90 product from bovine brain tissues with unspecified Hsp90α and Hsp90ß contents and an undefined Hsp90 protein oligomeric state was utilized. These two Hsp90s can have opposite effect on superoxide production by NOS. Importantly, emerging evidence indicates that nNOS splice variants are involved in different biological functions by functioning distinctly in redox signaling. In the present work, purified recombinant human Hsp90α, in its native dimeric state, was used in electron paramagnetic resonance (EPR) spin trapping experiments to study the effects of Hsp90α on superoxide generation from nNOS splice variants nNOSµ and nNOSα. Human Hsp90α was found to significantly increase superoxide generation from nNOSµ and nNOSα proteins under l-Arg-depleted conditions and Hsp90α influenced superoxide production by nNOSµ and nNOSα at varying degrees. Imidazole suppressed the spin adduct signal, indicating that superoxide was produced at the heme site of nNOS in the presence of Hsp90α, whereas l-Arg repletion diminished superoxide production by the nNOS-Hsp90α. Moreover, NADPH consumption rate values exhibited a similar trend/difference as a function of Hsp90α and l-Arg. Together, these EPR spin trapping and NADPH oxidation kinetics results demonstrated noticeable Hsp90α-induced increases in superoxide production by nNOS and a distinguishable effect of Hsp90α on nNOSµ and nNOSα proteins.

In vivo electron paramagnetic resonance oximetry and applications in the brain.

Molecular oxygen (O2) is essential to brain function and mechanisms necessary to regulate variations in delivery or utilization of O2 are crucial to support normal brain homeostasis, physiology and energy metabolism. Any imbalance in cerebral tissue partial pressure of O2 (pO2) levels may lead to pathophysiological complications including increased reactive O2 species generation leading to oxidative stress when tissue O2 level is too high or too low. Accordingly, the need for oximetry methods, which assess cerebral pO2in vivo and in real time, is imperative to understand the role of O2 in various metabolic and disease states, including the effects of treatment and therapy options. In this review, we provide a brief overview of the common in vivo oximetry methodologies for measuring cerebral pO2. We discuss the advantages and limitations of oximetry methodologies to measure cerebral pO2in vivo followed by a more in-depth review of electron paramagnetic resonance oximetry spectroscopy and imaging using several examples of current electron paramagnetic resonance oximetry applications in the brain.

Ozone Inhalation Impairs Coronary Artery Dilation via Intracellular Oxidative Stress: Evidence for Serum-Borne Factors as Drivers of Systemic Toxicity.

Ambient ozone (O3) levels are associated with cardiovascular morbidity and mortality, but the underlying pathophysiological mechanisms driving extrapulmonary toxicity remain unclear. This study examined the coronary vascular bed of rats in terms of constrictive and dilatory responses to known agonists following a single O3 inhalation exposure. In addition, serum from exposed rats was used in ex vivo preparations to examine whether bioactivity and toxic effects of inhaled O3 could be conveyed to extrapulmonary systems via the circulation. We found that 24 h following inhalation of 1 ppm O3, isolated coronary vessels exhibited greater basal tone and constricted to a greater degree to serotonin stimulation. Vasodilation to acetylcholine (ACh) was markedly diminished in coronary arteries from O3-exposed rats, compared with filtered air-exposed controls. Dilation to ACh was restored by combined superoxide dismutase and catalase treatment, and also by NADPH oxidase inhibition. When dilute (10%) serum from exposed rats was perfused into the lumen of coronary arteries from unexposed, naïve rats, the O3-induced reduction in vasodilatory response to ACh was partially recapitulated. Furthermore, following O3 inhalation, serum exhibited a nitric oxide scavenging capacity, which may partially explain blunted ACh-mediated vasodilatory responses. Thus, bioactivity from inhalation exposures may be due to compositional changes of the circulation. These studies shed light on possible mechanisms of action that may explain O3-associated cardiac morbidity and mortality in humans.

A suspended membrane nanocalorimeter for ultralow volume bioanalysis.

A nanocalorimetric suspended membrane sensor for pL volumes of aqueous media was fabricated by bulk silicon micromachining using anisotropic wet etching and photo and electron beam lithographic techniques. A high-temperature sensitivity of 125 microK and a rapid unfiltered time constant of 12 ms have been achieved by integrating a miniaturized reaction vessel of 0.7-nL volume on a 800-nm-thick and 300 x 300- microm2-large silicon nitride membrane, thermally insulated from the surrounding bulk silicon. The combination of a ten-junction gold and nickel thermoelectric sensor with an integrated ultralow noise preamplifier has enabled the resolution of 15-nW power in a single measurement, a result confirmed by electrical calibration. The combination of a high sensitivity and rapid response time is a consequence of miniaturization. The choice of gold and nickel as sensor material provided the maximum thermal sensitivity in the context of ease of fabrication and cost. The nanocalorimetric sensor has the potential for integration in an ultralow-volume high-density array format for the characterization of processes in which there is an exchange of heat.

Electron beam lithographically-defined scanning electrochemical-atomic force microscopy probes: fabrication method and application to high resolution imaging on heterogeneously active surfaces.

This paper describes in detail the use of electron beam lithography (EBL) to successfully batch microfabricate combined scanning electrochemical-atomic force microscopy (SECM-AFM) probes. At present, the process produces sixty probes at a time, on a 1/4 of a three-inch wafer. Using EBL, gold triangular-shaped electrodes can be defined at the tip apex, with plasma enhanced chemical vapor deposited silicon nitride serving as an effective insulating layer, at a thickness of 75 nm. The key features of the fabrication technique and the critical steps are discussed. The capability of these probes for SECM-AFM imaging in both tapping and constant distance mode is illustrated with dual topographical-electrochemical scans over an array of closely-spaced 1 microm diameter Pt disc electrodes, held at a suitable potential to generate an electroactive species at a transport-limited rate. As highlighted herein, understanding diffusion to heterogeneous electrode surfaces, including array electrodes, is currently topical and we present preliminary data highlighting the use of SECM-AFM as a valuable tool for the investigation of diffusion and reactivity at high spatial resolution.

Nanowire probes for high resolution combined scanning electrochemical microscopy - atomic force microscopy.

We describe a method for the production of nanoelectrodes at the apex of atomic force microscopy (AFM) probes. The nanoelectrodes are formed from single-walled carbon nanotube AFM tips which act as the template for the formation of nanowire tips through sputter coating with metal. Subsequent deposition of a conformal insulating coating, and cutting of the probe end, yields a disk-shaped nanoelectrode at the AFM tip apex whose diameter is defined by the amount of metal deposited. We demonstrate that these probes are capable of high-resolution combined electrochemical and topographical imaging. The flexibility of this approach will allow the fabrication of nanoelectrodes of controllable size and composition, enabling the study of electrochemical activity at the nanoscale.

Characterization of batch-microfabricated scanning electrochemical-atomic force microscopy probes.

A procedure for the batch microfabrication of scanning electrochemical-atomic force microscopy (SECM-AFM) probes is described. The process yields sharp AFM tips, incorporating a triangular-shaped electrode (base width 1 microm, height 0.65 microm) at the apex. Microfabrication was typically carried out on (1)/(4) 3-in. wafers, yielding 60 probes in each run. The measured spring constant of the probes was in the range 1-1.5 N m(-1). To date, processing has been carried out twice successfully, with an estimated success rate for the fabrication process in excess of 80%, based on field emission-scanning electron microscopy imaging of all probes and current-voltage measurements on a random selection of approximately 30 probes. Steady-state voltammetric measurements for the reduction of Ru(NH(3))(6)(3+) in aqueous solution indicate that the electrode response is well-defined, reproducible, and quantitative, based on a comparison of the experimental diffusion-limited current with finite element simulations of the corresponding mass transport (diffusion) problem. Topographical imaging of a sputtered Au film with the SECM-AFM probes demonstrates lateral resolution comparable to that of conventional Si(3)N(4) AFM probes. Combined electrochemical-topographical imaging studies have been carried out on two model substrates: a 10-microm-diameter disk ultramicroelectrode (UME) and an array of 1-microm-diameter UMEs, spaced 12.5 microm apart (center to center). In both cases, an SECM-AFM probe was first employed to image the topography of the substrates. The tip was then moved back a defined distance from the surface and use to detect Ru(NH(3))(6)(2+) produced at the substrate, biased at a potential to reduce Ru(NH(3))(6)(3+), present in bulk solution, at a diffusion-controlled rate (substrate generation-tip collection mode). These studies establish the success of the batch process for the mass microfabrication of SECM-AFM tips.

Micromachined nanocalorimetric sensor for ultra-low-volume cell-based assays.

Current strategies for cell-based screening generally focus on the development of highly specific assays, which require an understanding of the nature of the signaling molecules and cellular pathways involved. In contrast, changes in temperature of cells provides a measure of altered cellular metabolism that is not stimulus specific and hence could have widespread applications in cell-based screening of receptor agonists and antagonists, as well as in the assessment of toxicity of new lead compounds. Consequently, we have developed a micromachined nanocalorimetric biological sensor using a small number of isolated living cells integrated within a subnanoliter format, which is capable of detecting 13 nW of generated power from the cells, upon exposure to a chemical or pharmaceutical stimulus. The sensor comprises a 10-junction gold and nickel thermopile, integrated on a silicon chip which was back-etched to span a 800-nm-thick membrane of silicon nitride. The thin-film membrane, which supported the sensing junctions of the thermoelectric transducer, gave the system a temperature resolution of 0.125 mK, a low heat capacity of 1.2 nJ mK(-1), and a rapid (unfiltered) response time of 12 ms. The application of the system in ultra-low-volume cell-based assays could provide a rapid endogenous screen. It offers important additional advantages over existing methods in that it is generic in nature, it does not require the use of recombinant cell lines or of detailed assay development, and finally, it can enable the use of primary cell lines or tissue biopsies.