In-MIL-68 derived In2O3/Fe2O3 shuttle-like structures with n-n heterojunctions to improve ethanol sensing performance.

Metal-organic frameworks (MOFs) have a variety of structures and unique properties that make them suitable for use in gas sensors. Herein, In2O3/Fe2O3 was successfully synthesized using simple solvothermal and impregnation methods. The response to 100 ppm of ethanol gas reached 67.5 at an optimum working temperature of 200 °C, and the response/recovery time was 9 s/236 s. The composite also exhibited excellent selectivity, repeatability, and long-term stability. SEM, TEM, XRD, and XPS were used for the characterization of materials. The excellent sensing performance of the sensors is attributed to the construction of n-n heterojunctions, an increase in oxygen vacancies, and the unique structural characteristics of MOFs. The above experimental results indicate that In-MIL-68-derived In2O3/Fe2O3 is a promising ethanol sensing material.

Opposite Sensing Response of Heterojunction Gas Sensors Based on SnO2-Cr2O3 Nanocomposites to H2 against CO and Its Selectivity Mechanism.

Metal oxide semiconductor (MOS) gas sensors show poor selectivity when exposed to mixed gases. This is a challenge in gas sensors and limits their wide applications. There is no efficient way to detect a specific gas when two homogeneous gases are concurrently exposed to sensing materials. The p-n nanojunction of xSnO2-yCr2O3 nanocomposites (NCs) are prepared and used as sensing materials (x/y shows the Sn/Cr molar ratio in the SnO2-Cr2O3 composite and is marked as SnxCry for simplicity). The gas sensing properties, crystal structure, morphology, and chemical states are characterized by employing an electrochemical workstation, an X-ray diffractometer, a transmission electron microscope, and an X-ray photoelectron spectrometer, respectively. The gas sensing results indicate that SnxCry NCs with x/y greater than 0.07 demonstrate a p-type behavior to both CO and H2, whereas the SnxCry NCs with x/y < 0.07 illustrate an n-type behavior to the aforementioned reduced gases. Interestingly, the SnxCry NCs with x/y = 0.07 show an n-type behavior to H2 but a p-type to CO. The effect of the operating temperature on the opposite sensing response of the fabricated sensors has been investigated. Most importantly, the mechanism of selectivity opposite sensing response is proposed using the aforementioned characterization techniques. This paper proposes a promising strategy to overcome the drawback of low selectivity of this type of sensor.

Conductivity and aging behavior of Sr(Ti0.6Fe0.4)1-x O3-δ mixed conductor materials.

Perovskite materials play a significant role in oxygen sensors due to their fascinating electrical and ionic conductivities. The sol-gel technique was employed to prepare various compositions of B-site-deficient Fe-doped SrTiO3 (iron-doped strontium titanate) or Sr(Ti0.6Fe0.4)1-x O3-δ , where x = 0.01, 0.02, and 0.03. The XRD results revealed that the principle crystalline phase of the samples was the cubic perovskite structure. The B-site deficiency improved the ionic and total conductivities of Sr(Ti0.6Fe0.4)1-x O3-δ . A small polaron conduction behavior occurred in the total electrical conductivity. The XPS results showed that the oxygen vacancy value decreased with the rise in the amount of B-site deficiencies. A lower B-site deficiency amount could produce more oxygen vacancies in the lattice but resulted in the ordering of vacancies and then lower ionic conductivity. The aging behavior was caused by the ordering of oxygen vacancies and resulted in a degeneration of electrical features under a long service time. Conversely, augmentation of the B-site deficiency amount inhibited the tendency for the ordering of oxygen vacancies and then promoted the electrical performance under a long usage time. The conduction mechanism of oxygen ions through oxygen vacancies was thoroughly investigated and discussed. The current study presents a feasible approach to ameliorate the physical features of conductors through doping the B-site of the perovskite layer with Fe, which would be a fruitful approach for numerous applications, including oxygen sensors and fuel cells anodes.

Hydrothermal synthesis of a bimetallic metal-organic framework (MOF)-derived Co3O4/SnO2 composite as an effective material for ethanol detection.

This study utilized a hydrothermal method and air calcination to prepare a bimetallic metal-organic framework (MOF) derived Co3O4/SnO2 nanocomposite material, which was employed as a sensing material for ethanol detection. The structure, elemental composition, and surface morphology of Co3O4/SnO2 nanocomposite materials were defined using X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Compared to SnO2 nanoparticles derived from metal-organic frameworks, the bimetallic metal-organic framework-derived Co3O4/SnO2 nanocomposite material exhibits significantly superior ethanol sensing performance. At 225 °C, the response value (R = Ra/Rg) to 100 ppm ethanol is 135, demonstrating excellent repeatability, selectivity and stability. Gas sensitivity assessment findings indicate that the 3 at% (Co/Sn) Co3O4/SnO2 nanocomposite is an excellent gas sensing material, providing strong technical support for ethanol detection and environmental monitoring.

New Analysis Method for Adsorption in Gas (H2, CO)-Solid (SnO2) Systems Based on Gas Sensing.

The chemisorption phenomenon is widely used in the explanation of catalysis, gas-solid reactions, and gas sensing mechanisms. Generally, some properties of adsorbents, such as adsorption sites and dispersion, can be predicted by traditional methods through the variation of the chemisorption capacity with the temperature, pressure, and gas-solid interaction potential. However, these methods could not capture the information of the interaction between adsorbents, the adsorption rate, and the competitive adsorption relationship between adsorbents. In this paper, metal oxide semiconductors (MOSs) are employed to study the adsorption behavior. The gas sensing responses (GSRs) of MOSs caused by the gas adsorption process are measured as a new method to capture some adsorption behaviors, which are impossible for the traditional methods to obtain. The following adsorption behaviors characterized by this new method are presented for the first time: (1) distinguishing the adsorption type using an example of two reducing gases: the adsorption type of the two gases is single-molecular layer adsorption in this work; (2) detecting the interaction between different gases: this will be a promising method to provide original characterization data in the fields of gas-solid reaction mechanisms and heterogeneous catalysis; and (3) measuring the adsorption rate based on the GSR.

Y-doped CaZrO3/Co3O4 as novel dense diffusion barrier materials for a limiting current oxygen sensor.

Herein, we illustrate a feasible strategy to strengthen the gas sensing of Y-doped CaZrO3 (YxCa1-xZr0.7O3-δ (x = 0.05, 0.06, and 0.07))/0.1Co3O4 used as sensing materials. This compound was prepared via a solid-state reaction technique. The structural, morphological, electrical, and sensing features such as phase identification, microstructure, ionic conductivity, total conductivity and sensitivity of the fabricated sensors were evaluated via X-ray diffraction, scanning electron microscopy, electron-blocking method, electrochemical impedance spectroscopy and cyclic voltammetry. In addition, the influence of the Y-dopant on the properties of YxCa1-xZr0.7O3-δ/Co3O4 was thoroughly studied. XRD results revealed the formation of the orthorhombic perovskite phase of YxCa1-xZr0.7O3-δ. Moreover, the obtained results from the electrical properties elucidated high electronic and low ionic conductivities, and small polaron conduction of YxCa1-xZr0.7O3-δ/Co3O4. Furthermore, the results confirmed an excellent limiting current plateau for the fabricated oxygen sensor based on YxCa1-xZr0.7O3-δ/Co3O4. In particular, experimental observation indicates that Y-doping at the Ca site and/or Zr site might be difficult.

Discriminable Sensing Response Behavior to Homogeneous Gases Based on n-ZnO/p-NiO Composites.

Metal oxide semiconductor (MOS) gas sensors have the advantages of high sensitivity, short response-recovery time and long-term stability. However, the shortcoming of poor discriminability of homogeneous gases limits their applications in gas sensors. It is well-known that the MOS materials have similar gas sensing responses to homogeneous gases such as CO and H2, so it is difficult for these gas sensors to distinguish the two gases. In this paper, simple sol-gel method was employed to obtain the ZnO-xNiO composites. Gas sensing performance results illustrated that the gas sensing properties of composites with x > 0.425 showed a p-type response to both CO and H2, while the gas sensing properties of composites with x < 0.425 showed an n-type response to both CO and H2. However, it was interesting that ZnO-0.425NiO showed a p-type response to CO but an discriminable response (n-type) to H2, which indicated that modulating the p-type or n-type semiconductor concentration in p-n composites could be an effective method with which to improve the discriminability of this type of gas sensor regarding CO and H2. The phenomenon of the special gas sensing behavior of ZnO-0.425NiO was explained based on the experimental observations and a range of characterization techniques, including XRD, HRTEM and XPS, in detail.

Conductivity and mixed conductivity of a novel dense diffusion barrier and the sensing properties of limiting current oxygen sensors.

First-principles calculations were used to explore the effect of various Y-doping levels on the electrical conductivity of SrTiO3. Herein, we prepared ((Y0.07Sr0.93Ti0.6Fe0.4-xO3-δ)/x/3Co3O4 (x = 0.1, 0.2, 0.3)) composites using a solid state reaction method. The properties of these sensing materials and the fabricated sensors including crystal phase composition, microstructures, oxygen ionic conductivity, total conductivity and sensor performance were investigated in detail. XRD demonstrates the formation of a highly cubic perovskite structure. The introduction of Co3O4 promotes remarkably the electronic conductivity of the Y0.07Sr0.93Ti0.6Fe0.4-xO3-δ/x/3Co3O4 composites due to the formation of n-type CoO and p-type Co2O3. A limiting current oxygen sensor based on (Y0.07Sr0.93Ti0.6Fe0.4-xO3-δ)/x/3Co3O4 as a dense diffusion barrier shows excellent sensing performance. The recovery time is less than the response time, indicating that Co2O3 promotes the gas desorption reaction which results in a shorter recovery time. The obtained results demonstrate a direct relationship between limiting current (IL) and oxygen content.

Facile Synthesis of SnO2/LaFeO3-XNX Composite: Photocatalytic Activity and Gas Sensing Performance.

Here SnO2/LaFeO3-XNX composite was fabricated using a wet chemical method and was applied to pollutants degradation and gas sensing for the first time. The composite exhibits high performance for photocatalytic degradation of Rhodamine B (RhB) dye and selectivity sensing of various gases. On the basis of the completed experiments, the improved RhB degradation and selective gas sensing performance resulted from the extended optical absorption via N2 incorporated surface states and enhanced charge separation via coupling SnO2. Using the scavengers trapping experiments, the superoxide radical (O2•-) was investigated as the major scavenger involved in the degradation of RhB over SnO2/LaFeO3-XNX composite. In this paper, the probable reaction steps involved in the RhB dye degradation over SnO2/LaFeO3-XNX composite are proposed. This work will provide reasonable strategies to fabricate LaFeO3-based proficient and stable catalysts for environmental purification. In addition, the result of the selectivity of gas performance is also presented.