RESUMEN
Device configurations that enable a unidirectional propagation of carriers in a semiconductor are fundamental components for electronic and optoelectronic applications. To realize such devices, however, it is generally required to have complex processes to make p-n or Schottky junctions. Here we report on a unidirectional propagation effect due to a self-induced compositional variation in GaAsSb nanowires (NWs). The individual GaAsSb NWs exhibit a highly reproducible rectifying behavior, where the rectifying direction is determined by the NW growth direction. Combining the results from confocal micro-Raman spectroscopy, electron microscopy, and electrical measurements, the origin of the rectifying behavior is found to be associated with a self-induced variation of the Sb and the carrier concentrations in the NW. To demonstrate the usefulness of these GaAsSb NWs for device applications, NW-based photodetectors and logic circuits have been made.
RESUMEN
The combination of quantum Hall conductance and charge-trap memory operation was qualitatively examined using a graphene field-effect transistor. The characteristics of two terminal quantum Hall conductance appeared clearly on the background of a huge conductance hysteresis during a gate-voltage sweep for a device using monolayer graphene as a channel,hexagonal boron-nitride flakes as a tunneling dielectric and defective silicon oxide as the charge storage node. Even though there was a giant shift of the charge neutrality point, the deviation of quantized resistance value at the state of filling factor 2 was less than 1.6% from half of the von Klitzing constant. At high Landau level indices, the behaviors of quantum conductance oscillation between the increasing and the decreasing electron densities were identical in spite ofa huge memory window exceeding 100 V. Our results indicate that the two physical phenomena, two-terminal quantum Hall conductance and charge-trap memory operation, can be integrated into one device without affecting each other.
RESUMEN
A periodically modulated graphene (PMG) generated by nanopatterned surfaces is reported to profoundly modify the intrinsic electronic properties of graphene. The temperature dependence of the sheet resistivity and gate response measurements clearly show a semiconductor-like behavior. Raman spectroscopy reveals significant shifts of the G and the 2D modes induced by the interaction with the underlying grid-like nanostructure. The influence of the periodic, alternating contact with the substrate surface was studied in terms of strain caused by bending of graphene and doping through chemical interactions with underlying substrate atoms. Electronic structure calculations performed on a model of PMG reveals that it is possible to tune a band gap within 0.14-0.19 eV by considering both the periodic mechanical bending and the surface coordination chemistry. Therefore, the PMG can be regarded as a further step toward band gap engineering of graphene devices.
RESUMEN
Coherent motion of electrons in Bloch states is one of the fundamental concepts of charge conduction in solid-state physics. In layered materials, however, such a condition often breaks down for the interlayer conduction, when the interlayer coupling is significantly reduced by, e.g., a large interlayer separation. We report that complete suppression of coherent conduction is realized even in an atomic length scale of layer separation in twisted bilayer graphene. The interlayer resistivity of twisted bilayer graphene is much higher than the c-axis resistivity of Bernal-stacked graphite and exhibits strong dependence on temperature as well as on external electric fields. These results suggest that the graphene layers are significantly decoupled by rotation and incoherent conduction is a main transport channel between the layers of twisted bilayer graphene.
RESUMEN
Novel field effect transistors with suspended graphene gates are demonstrated. By incorporating mechanical motion of the gate electrode, it is possible to improve the switching characteristics compared to a static gate, as shown by a combination of experimental measurements and numerical simulations. The mechanical motion of the graphene gate is confirmed by using atomic force microscopy to directly measure the electrostatic deflection. The device geometry investigated here can also provide a sensitive measurement technique for detecting high-frequency motion of suspended membranes as required, e.g., for mass sensing.
Asunto(s)
Grafito/química , Nanotecnología/métodos , Nanotubos de Carbono/química , Conductividad Eléctrica , Electrodos , Microscopía de Fuerza Atómica/métodos , Electricidad Estática , TemperaturaRESUMEN
We developed a new technique to fabricate single nanowire devices with reliable graphene/nanowire contacts using a position-controlled microtransfer and an embedded nanowire structure in a planar junction configuration. A thorough study of electrical properties and fabrication challenges of single p-GaAs nanowire/graphene devices was carried out in two different device configurations: (1) a graphene bottom-contact device where the nanowire-graphene contact junction is formed by transferring a nanowire on top of graphene and (2) a graphene top-contact device where the nanowire-graphene contact junction is formed by transferring graphene on top of an embedded nanowire. For the graphene top-contact devices, graphene-nanowire-metal devices, where graphene is used as one electrode and metal is the other electrode to a nanowire, and graphene-nanowire-graphene devices, where both electrodes to a nanowire are graphene, were investigated and compared with conventional metal/p-GaAs nanowire devices. Conventional metal/p-GaAs nanowire contact devices were further investigated in embedded and nonembedded nanowire device configurations. A significantly improved current in the embedded device configuration is explained with a "parallel resistors model" where the high-resistance parts with the metal-semiconductor Schottky contact and the low-resistance parts with noncontacted facets of the hexagonal nanowires are taken into consideration. Consistently, the nonembedded nanowire structure is found to be depleted much easier than the embedded nanowires from which an estimation for a fully depleted condition has also been established.
RESUMEN
We report a method of small molecule analysis using a converted graphene-like monolayer (CGM) plate and laser desorption/ionization time-of-flight mass spectrometry (LDI-TOF MS) without organic matrices. The CGM plate was prepared from self-assembled monolayers of biphenyl-4-thiol on gold using electron beam irradiation followed by an annealing step. The above plate was utilized for the LDI-TOF MS analyses of various small molecules and their mixtures, e.g., amino acids, sugars, fatty acids, oligoethylene glycols, and flavonoids. The CGM plate afforded high signal-to-noise ratios, good limits of detection (1pmol to 10fmol), and reusability for up to 30 cycles. As a practical application, the enzymatic activity of the cytochrome P450 2A6 (CYP2A6) enzyme in human liver microsomes was assessed in the 7-hydroxylation of coumarin using the CGM plate without other purification steps. We believe that the prepared CGM plate can be practically used with the advantages of simplicity, sensitivity, and reusability for the matrix-free analysis of small biomolecules.
Asunto(s)
Aminoácidos/análisis , Carbohidratos/análisis , Cumarinas/metabolismo , Ácidos Grasos/análisis , Flavonoides/análisis , Grafito/química , Espectrometría de Masa por Láser de Matriz Asistida de Ionización Desorción/métodos , Citocromo P-450 CYP2A6/metabolismo , Oro/química , Humanos , Hidroxilación , Nanopartículas del Metal/química , Microsomas Hepáticos/enzimología , Propiedades de SuperficieRESUMEN
In this work, graphene field effect transistors (FETs) were fabricated on a trench structure made by carbonized poly(methylmethacrylate) to modify the graphene surface. The trench-structured devices showed different characteristics depending on the channel orientation and the pitch size of the trenches as well as channel area in the FETs. Periodic corrugations and barriers of suspended graphene on the trench structure were measured by atomic force microscopy and electrostatic force microscopy. Regular barriers of 160 mV were observed for the trench structure with graphene. To confirm the transfer mechanism in the FETs depending on the channel orientation, the ratio of experimental mobility (3.6-3.74) was extracted from the current-voltage characteristics using equivalent circuit simulation. It is shown that the number of barriers increases as the pitch size decreases because the number of corrugations increases from different trench pitches. The noise for the 140 nm pitch trench is 1 order of magnitude higher than that for the 200 nm pitch trench.
RESUMEN
A stencil lithography technique has been developed to fabricate organic-material-based electronic devices with sub-micron resolution. Suspended polymethylmethacrylate (PMMA) membranes were used as shadow masks for defining organic channels and top electrodes. Arrays of pentacene field effect transistors (FETs) with various channel lengths from 50 µm down to 500 nm were successfully produced from the same batch using this technique. Electrical transport measurements showed that the electrical contacts of all devices were stable and the normalized contact resistances were much lower than previously studied organic FETs. Scaling effects, originating from the bulk space charge current, were investigated by analyzing the channel-length-dependent mobility and hysteresis behaviors. This novel lithography method provides a reliable means for studying the fundamental transport properties of organic materials at the nanoscale as well as enabling potential applications requiring the fabrication of integrated organic nanoelectronic devices.