Mechanical properties of fibroblasts depend on level of cancer transformation.

Recently, it was revealed that tumor cells are significantly softer than normal cells. Although this phenomenon is well known, it is connected with many questions which are still unanswered. Among these questions are the molecular mechanisms which cause the change in stiffness and the correlation between cell mechanical properties and their metastatic potential. We studied mechanical properties of cells with different levels of cancer transformation. Transformed cells in three systems with different transformation types (monooncogenic N-RAS, viral and cells of tumor origin) were characterized according to their morphology, actin cytoskeleton and focal adhesion organization. Transformation led to reduction of cell spreading and thus decreasing the cell area, disorganization of actin cytoskeleton, lack of actin stress fibers and decline in the number and size of focal adhesions. These alterations manifested in a varying degree depending on type of transformation. Force spectroscopy by atomic force microscopy with spherical probes was carried out to measure the Young's modulus of cells. In all cases the Young's moduli were fitted well by log-normal distribution. All the transformed cell lines were found to be 40-80% softer than the corresponding normal ones. For the cell system with a low level of transformation the difference in stiffness was less pronounced than for the two other systems. This suggests that cell mechanical properties change upon transformation, and acquisition of invasive capabilities is accompanied by significant softening.

[The effect of poly(3-hydroxybutyrate) modification by poly(ethylene glycol) on the viability of cells grown on the polymer films].

A biodegradable polymer of bacterial origin, poly(3-hydroxybutyrate) (PHB), is intensively studied as biomaterial for tissue engineering. However, factors determining its biocompatibility still require better understanding. To analyze the PHB films biocompatibility, the polymer material was modified by hydrophilic polymer, poly(ethylene glycol) 300 (PEG). The blends PHB/PEG with different PEG content (10, 20, 30 and 50%) were produced by subsequent incubation in water resulted in removal of 95% PEG. The surface roughness and hydrophilicity were studied by atomic force microscopy (AFM) and contact angle "water-polymer" measurement, respectively. The film biocompatibility on cell culture of COS-1 fibroblasts was studied in vitro. It was shown that both roughness and hydrophobicity are directly proportional to initial PEG content in the PHB/PEG blends. The growth rate of COS-1 fibroblasts on polymer films is determined by combination of two basic physicochemical properties of the polymer surface: the roughness and hydrophilicity. The optimal roughness requred for COS-1 cells growth is the average roughness more than 25 nm, whereas the limit values of the contact angle "water-polymer" that was responsible for relatively high cell viability were not found. These data indicate that the film surface roughness had the greatest effect on the cell growth, whereas the increase in the polymer surface hydrophilicity caused the additional positive effect on viability of attached cells. Thus, the modification of PHB polymer material by PEG resulted in the improved viability of cells cultivated on the polymer films in vitro. The obtained data can be used for development of such medical devices as surgeon patches and periodontal membranes.

[Atomic force microscopy of living cells: advances and future outlooks].

The advances of the method of atomic force microscopy for investigating the animal cells and an analysis of its development have been reviewed, with much attention being given to studies of living cells. The features and problems of the method have been considered, and a number of special methods based on the use of atomic force microscopy have been analyzed. The problems of choosing the geometry of probes for studies of animal cells, determination of cell adhesion on substrate, mapping of the cell surface using chemically modified cantilevers, and the distribution of molecular components inside the cell with the use of micro- and nanosurgical approaches have been discussed. The problems of combining the atomic force microscopy with optical and laser scanning confocal microscopy have been considered. Possible applications of the method in biotechnology and medicine are discussed.