Fabrication of 3D PCL/PVP scaffolds using monosodium glutamate as porogen by solvent casting/particulate leaching method for oral and maxillofacial bone tissue engineering.

The design of three-dimensional (3D) scaffolds should focus on creating highly porous, 3D structures with an interconnected pore network that supports cell growth. The scaffold's pore interconnectivity is directly linked to vascularization, cell seeding, guided cell migration, and transportation of nutrients and metabolic waste. In this study, different types of food flavors including monosodium glutamate, sugar, and sodium chloride were used as the porogens along with PCL/PVP blend polymer for solvent casting/particulate leaching method. The morphology, porosity, interconnectivity, chemical composition, water absorption, and mechanical properties of the fabricated scaffolds are carefully characterized. The scaffolds are biocompatible in bothin vitroandin vivoexperiments and do not trigger any inflammatory response while enhancing new bone formation and vascularization in rabbit calvaria critical-sized defects. The new bone merges and becomes denser along with the experiment timeline. The results indicate that the 3D PCL/PVP scaffolds, using monosodium glutamate as porogen, exhibited suitable biological performance and held promise for bone tissue engineering in oral and maxillofacial surgery.

Antibacterial Property of Cellulose Acetate Composite Materials Reinforced with Aluminum Nitride.

Cellulose acetate (CA) is a synthetic compound that is derived from the acetylation of cellulose. CA is well known as it has been used for many commercial products such as textiles, plastic films, and cigarette filters. In this research, antibacterial CA composites were produced by addition of aluminum nitride (AlN) at different weight percentage, from 0 wt. % to 20 wt. %. The surface characterization was performed using laser microscope, Raman and FTIR spectroscopy. The mechanical and thermal properties of the composite were analyzed. Although the mechanical strength tended to decrease as the concentration of AlN increased and needed to be optimized, the melting temperature (Tm) and glass transition temperature (Tg) showed a shift toward higher values as the AlN concentration increased leading to an improvement in thermal properties. AlN additions in weight percentages >10 wt. % led to appreciable antibacterial properties against S. epidermidis and E. coli bacteria. Antibacterial CA/AlN composites with higher thermal stability have potential applications as alternative materials for plastic packaging in the food industry.

Facile and Scalable Fabrication of Porous Polystyrene Fibers for Oil Removal by Centrifugal Spinning.

The demand for an efficient oil sorbent with high sorption capacity, low cost, scalable fabrication, and high selectivity for the cleanup of spreading oil on water is increasingly urgent due to the frequent occurrence of oil spill accidents in seawater all over the world. In this study, porous polystyrene (PS) fibers with high hydrophobicity and superoleophilicity were directly fabricated by a centrifugal spinning method (CS). The effect of solvents, tetrahydrofuran (THF), and dimethylformamide (DMF) on the morphology and porous structure of the polystyrene fibers was evaluated by using scanning electron microscopy and nitrogen adsorption-desorption experiments. The formation mechanism for the porous structure on the fibers was also evaluated. The oil sorption capacities of the PS fibers for silicon oil, pump oil, and vegetable oil were investigated. The highest oil sorption capacity was found in PS fibers fabricated from PS solution with a THF/DMF weight ratio of 1/3, which exhibited the highest specific surface area, pore volume, and porosity. The high productivity and highly porous structure of PS fibers indicate that CS is a promising method to fabricate porous fibers for the cleanup of oil spills.