Comparison of antegrade and retrograde cross pin fixation in the surgical treatment of pediatric supracondylar femur fractures: A biomechanical study.

PURPOSE: The aim of this study is to compare biomechanical stability of Kirschner wires (K-wires) sent with antegrade and retrograde technique in the fixation of pediatric supracondylar femur fractures. MATERIALS AND METHODS: A transverse fracture model was created two centimeters above the physis in 24 synthetic bone models suitable for the pediatric femur bone structure. The models were randomly divided into two groups as 12 bones each. In the first group (Group 1), 12 bone fracture models were retrogradely fixed with two cross K-wires. In the second group (Group 2), the fracture was fixed antegradely. In Group 2, both wire ends were allowed to protrude three millimeters from the femoral condyles. The stability of the groups was tested biomechanically by exposing them to varus and extension forces. The forces corresponding to 1 mm, 2 mm, 3 mm and 4 mm displacement and failure loads were calculated in two groups. RESULTS: According to the test results regarding displacements and failure loads, the retrograde group was found to be significantly stronger than the antegrade group against varus loads (p < 0.05). When the groups were compared in terms of extension strength, the results of the two groups were similar and there was no statistical difference between them (p > 0.05). CONCLUSION: Retrograde cross K-wires fixation provides a more stable fixation against varus forces. This is important to prevent varus deformity, which is a clinically less tolerable deformity. However, considering that full-weight mobilization of patients is not allowed after surgery in pediatric supracondylar femur fractures, the surgeon should consider that K-wires can also be sent antegrade to decrease the risk of septic arthritis.

Is the Acetabular Cup Orientation Different in Robot-Assisted and Conventional Total Hip Arthroplasty With Right-Handed Surgeons Using an Anterolateral Approach?

Introduction Total hip arthroplasty (THA) is one of the most successful orthopaedic procedures. Survival rates from 90% at 10 years to 93% at 20 years have been reported in different studies. Differences in implant and patient characteristics can undoubtedly explain some of this variability observed in prosthesis durability, but the effect of surgical technique and implant orientation cannot be ignored. Therefore, many intraoperative methods (anatomic landmarks, intraoperative x-ray, fluoroscopy, navigation, and robotic surgery) have been attempted to avoid acetabular component malpositioning. Although postoperative computed tomography (CT) is accepted as the gold standard for the measurement of acetabular anteversion, it remains controversial in respect of costs and radiation exposure. The aim of this study was to examine how acetabular component orientation was affected in robotic and conventional THA operations performed by two surgeons with right-hand dominance. Material and methods The study included 113 primary THA operations performed on 113 patients between 2017 and 2022 in two groups: (i) robotic THA (Mako, Stryker Corporation, Kalamazoo, Michigan, United States) (55 patients) and (ii) conventional THA (58 patients). The patients comprised 51 males and 62 females. THA was performed on 54 right-side hips and 59 left-side hips. The operations were performed by two orthopaedic surgeons, each with 20 years of arthroplasty experience, on all the patients in the lateral decubitus position with an anterolateral approach. In all the cases, the orientation of the acetabular component was 40° inclination and 20° anteversion.  Difficult THA procedures (patients with developmental dysplasia of the hip (DDH), a history of hip surgery, revision THA, defect or deformity of the acetabulum, a history of scoliosis or lumbar posterior surgery, or those requiring proximal femoral osteotomy) were excluded from the study. Using the Liaw and Lewinnek methods, the acetabular component anteversion was measured on the radiographs taken in the optimal position postoperatively and the acetabular cup inclination angles were measured on the pelvis radiographs. The groups were compared using the Kolmogorov-Smirnov, Pearson Chi-square and Mann-Whitney U statistical tests. The limits were accepted as 40±5° for inclination and 20±5° for anteversion. Results No statistically significant difference was determined between the groups in respect of age, gender, or operated side. No statistically significant difference was determined between the optimal acetabular cup inclination angles of the robotic and conventional THA groups (p = 0.79). No statistically significant difference was determined between the optimal acetabular cup anteversion angles of the left and right conventional THA groups. Statistically significantly better results were determined in the robotic group in respect of acetabular cup anteversion (p<0,001).  Conclusion The optimal orientation of the acetabular component is a key factor for successful THA. Otherwise, revision surgery is inevitable for reasons such as instability, impingement, or increased wear. The results of this study demonstrated that robotic surgery was superior to the conventional method in the placement of the acetabular component in the desired orientation.

Ipsilateral chondral lesions worsen the long-term prognosis following arthroscopic partial medial meniscectomy.

PURPOSE: The effect of knee cartilage defects that are detected during partial meniscectomy remains controversial in terms of the long-term prognosis on knee function. This study aimed to investigate the effect of concurrent medial compartment focal cartilage lesions on the long-term prognosis of knee function in patients who underwent arthroscopic partial medial meniscectomy for traumatic medial meniscal tears. METHODS: This retrospective study analyzed 46 patients who underwent arthroscopic partial medial meniscectomy between 1991 and 2008 by a single surgeon. Twenty-one patients who underwent arthroscopic partial medial meniscectomy due to traumatic meniscal tear had focal chondral lesions only at the medial compartment, and these patients were assigned to group A. Twenty-five patients who had no cartilage lesions in any compartments were assigned to group B. The age, sex, body mass index (BMI), follow-up time, age at the time of surgery, clinical and radiological scores, and perioperative arthroscopy findings were analyzed. RESULTS: The mean follow-up time was 20 ± 3.7 years. No significant difference was found in the demographic data, and the average age of the patients at the time of operation was 35 ± 9.5 years. Both groups had improved Lysholm score at the last follow-up. Although no difference was found between the groups during the preoperative period, group B had a higher Lysholm score at the last follow-up than group A. The mean International Knee Documentation Committee (IKDC) and Knee injury and Osteoarthritis Outcome Score (KOOS) scores at the last follow-up were significantly higher in group B. The mean Kellgren-Lawrence grades in the operated knees of group A were higher than those of group B. In group A, a negative correlation was found between the BMI and postoperative Lysholm (r = - 0.461, p = 0.03) IKDC (r = - 0.433, p = 0.05) and KOOS (r = - 0.565, p = 0.008) scores. In group B, no correlation was found between BMI and any score. CONCLUSION: Among patients who underwent arthroscopic partial medial meniscectomy with an average follow-up of 20 years, those with concurrent focal cartilage defect in the medial compartment had clinically and radiologically worse outcomes than patients without any cartilage defect. Therefore, orthopedic surgeons should be meticulous before performing any arthroscopic partial medial meniscectomy in case of concurrent cartilage lesion. LEVEL OF EVIDENCE: Level III.

Objective laxity and subjective outcomes are more influenced by meniscal treatment than anterior cruciate ligament reconstruction technique at minimum2 years of follow-up.

OBJECTIVE: The purposes of this study were: (1) to compare three different surgical techniques for anterior cruciate ligament (ACL) reconstruction at a minimum 2 years of follow-up in terms of objective laxity and patient-reported outcomes; (2) to inspect the role of meniscal tears and treatment alongside with ACL reconstruction. METHODS: 59 patients were randomly assigned to one of the three reconstruction groups according to the ACL reconstruction technique: Double Bundle, Single Bundle, Single Bundle with Lateral Plasty. Autologous hamstring tendons were used in all the ACL reconstruction techniques. Objective laxity tests and KOOS were collected before surgery as a baseline and at a minimum of 2 years of follow-up and compared through a Repeated measure ANOVA. Secondary analysis to evaluate the effect of meniscal treatment on laxity reduction and scores improvement was also conducted using ANOVA. Three laxity evaluations were performed: anterior/posterior displacement at 30° of knee flexion (AP 30), anterior/posterior displacement at 90° of knee flexion (AP 90), and pivot-shift test. RESULTS: Objective laxity and KOOS showed statistically significant improvement at follow-up in all three groups (p < 0.0001) without differences among the techniques. A higher AP 30 (mean difference 2.4 mm, p = 0.0333, ES = 0.66) was found at baseline for the patients with irreparable medial meniscal tear compared to the patients with isolated ACL tear; a statistically significant difference in pain score at two-year follow-up was found between patients who underwent lateral meniscectomy and patients with either meniscal repair (mean difference 6.9 ± 12.5) or isolated ACL tear (mean difference 6.8 ± 16.1); patients with reparable meniscal tear had a statistically significant pain score improvement compared to the patients who underwent medial and lateral meniscectomy (mean difference of 9.5 ± 14.53 and 23.4 ± 19.2 respectively). CONCLUSION: Comparable objective laxity and subjective outcomes were found among the three ACL reconstruction techniques at a minimum of 2 years of follow-up. The presence of irreparable medial meniscal tear increased pre-operative laxity (AP 30, mean difference 2.4 ± 3.6 mm). Patients with meniscal repair presented higher pain relief between baseline and follow-up compared with patients undergoing medial or lateral meniscectomy (mean difference of 9.5 ± 14.53 and 23.4 ± 19.2, respectively).

Autologous free iliac crest bone grafting of glenoid through the rotator interval using double-barrelled cannula.

PURPOSE: The primary aim of this study is to prove that reconstructing the anterior glenoid defect with iliac crest graft arthroscopically using double-barrelled cannula through the rotator interval is safe and prevents both recurrence of instability and the neurovascular injury because subscapularis muscle is not split and procedure is far away from important structures. METHODS: Thirteen patients with anterior shoulder instability and engaging Hill-Sachs lesion were reviewed after arthroscopic reconstruction of the anterior glenoid with iliac crest autogenous graft. Patient satisfaction and Western Ontario Instability Score (WOSI) were evaluated on clinical examination. Computed tomography was used to analyse graft position on sagittal and axial planes. RESULTS: The mean follow-up was 28.7 months (SD 7.1), and age at surgery was 31 years (21 to 64 years). Post-operatively there was only one dislocation due to trauma. There was statistically significant improvement of WOSI scores (p: 0.001). There was not any neurological injury. Graft position on the axial plane was described as flush in 5 cases (41%), lateral in 2 (16%), too lateral in one (8%) and medial in 4 of the cases (33%). Graft position could be accepted as high in only three patients (23%). CONCLUSION: Arthroscopic reconstruction of glenoid defect using autogenous iliac bone graft, through rotator interval, without splitting subscapularis is safe and effective without any neurological injury, producing substantial graft position and good functional outcomes in patients.

Bony landmarks, distances and their correlations to each other, which can be used during periacetabular osteotomy: a CT study performed on dysplastic hips.

As a surgical technique for hip dysplasia, Bernese periacetabular osteotomy (PAO) still poses technical difficulties and unclear surgical steps like the depth of the first 'ischial' cut, the start of the iliac cut and the width of the retroacetabular cut to prevent either iatrogenic joint entrance or posterior column fracture. Twenty-seven dysplastic hips (CE < 25°) were randomly matched with nondysplastic hips (n: 27, CE > 25°). 3D CT sections of the hips were evaluated and the width of the ischium, the distance from the infra-acetabular groove to the ischial spine, from the anterior superior iliac spine (ASIS) to the joint or sciatic notch or the sciatic spine, from the most medial point at the acetabulum to the posterior column, ischial spine or sciatic notch were measured for each group and correlated. The distances (mm) from the infra-acetabular groove to the ischial spine (42 ± 4, 44 ± 4, P: 0.03), the anterior superior iliac spine to the joint (52 ± 6, 60 ± 3, P: 0.03), the most medial point at the acetabulum to the posterior column (34 ± 2, 36 ± 2, P: 0.005) were shorter in the dysplastic group. The distance from the ASIS to the sciatic notch was correlated with the distance from the infra-acetabular groove to the ischial spine, from the ASIS to the joint and the most medial point at the acetabulum to the posterior column. The distance from the ASIS to the sciatic notch can be used intraoperatively to guess the X-ray guided or blindly osteotomized stages to predict the width or depth of the osteotomy to prevent intraarticular extension or posterior column fracture.