First quantitative assessment of the adsorption of a fluorocarbon gas on phospholipid monolayers at the air/water interface.

HYPOTHESIS: Fluorocarbon gases introduced above monolayers of phospholipids at the air/water interface were recently found to promote the adsorption of diverse molecular compounds, with potential application in drug-loaded microbubble design. Quantitative determination of the fluorocarbon present in the monolayers is strongly needed for the development of such applications. We hypothesized that neutron reflectometry (NR) and ellipsometry experiments would allow quantification of the fluorocarbon trapped in the monolayers. EXPERIMENTS: We report the first quantitative determination of the extents of adsorption of perfluorohexane (F-hexane) on different phospholipid monolayers with respect to both their phase and isotopic form. To this aim, we applied an approach based on co-modeling the data obtained from NR and ellipsometry. FINDINGS: We found that F-hexane adsorbs strongly in monolayers of dipalmitoylphosphatidylcholine (DPPC) when they are both in the liquid expanded (LE) and liquid condensed (LC) phases, but to different extents according to the isotopic form of the phospholipid. Kinetic resolution of the interfacial composition from data on both isotopic contrasts (assuming chemical identicality) was therefore not possible using NR alone, so an alternative NR/ellipsometry co-modeling treatment was applied to data from each isotopic contrast. F-hexane adsorbs more abundantly on monolayers of hydrogenous DPPC than chain-deuterated DPPC when they are in the LE phase, whilst the opposite was observed when they monolayers are in the LC phase. The extents of adsorption of F-hexane in monolayers of dimyristoylphosphatidylcholine (DMPC, LE phase) and distearoylphosphatidylcholine (DSPC, LC phase) concurs with the strong dependence of those with phospholipids of different isotopic contrasts according to the monolayer phase. This new methodology can lead to advances in the novel characterization of fluorocarbons interacting with phospholipid monolayers of relevance to applications such as in the shells of fluorocarbon-stabilized medically-oriented microbubbles.

Ultrahigh Q microring resonators using a single-crystal aluminum-nitride-on-sapphire platform.

Aluminum-nitride-on-sapphire has recently emerged as a novel low-loss photonics platform for a variety of on-chip electro-optics as well as linear and nonlinear optics applications. In this Letter, we demonstrate ultrahigh quality factor (Qint) microring resonators using single-crystal aluminum nitride grown on a sapphire substrate with an optimized design and fabrication process. A record high intrinsic Qint up to 2.8×106 at the wavelength of 1550 nm is achieved with a fully etched structure, indicating a low propagation loss less than 0.13 dB/cm. Such high Qint aluminum-nitride-on-sapphire resonators with their wide bandgap and electro-optical and nonlinear optical properties is promising for a wide range of low-power and high-power compact on-chip applications over a broad spectral range.

Fluorocarbon Exposure Mode Markedly Affects Phospholipid Monolayer Behavior at the Gas/Liquid Interface: Impact on Size and Stability of Microbubbles.

Although most phospholipid-shelled microbubbles (MBs) investigated for medical applications are stabilized by a fluorocarbon (FC) gas, information on the interactions between the phospholipid and FC molecules at the gas/water interface remains scarce. We report that the procedure of introduction of perfluorohexane (F-hexane), that is, either in the gas phase above dimyristoylphosphatidylcholine (DMPC) or dipalmitoylphosphatidylcholine (DPPC) Langmuir monolayers, or in the aqueous subphase, radically affects the compression isotherms. When introduced in the gas phase, F-hexane is rapidly incorporated in the interfacial film, but is also readily desorbed upon compression and eventually totally expelled from the phospholipid monolayers. By contrast, when introduced in the aqueous phase, F-hexane remains trapped at the interface. These dissimilar outcomes demonstrate that the phospholipid monolayer acts as a barrier that effectively hinders the transfer of the FC across the interfacial film. F-hexane was also found to significantly accelerate the adsorption kinetics of the phospholipids at the gas/water interface and to lower the interfacial tension, as assessed by bubble profile analysis tensiometry. The extent of these effects is more pronounced when F-hexane is provided from the gas phase. The size and stability characteristics of DMPC- and DPPC-shelled microbubbles were also found to depend on how the FC is introduced. As compared to reference MBs prepared under nitrogen only, introduction of F-hexane always causes a decrease in MB mean radius. However, while for DMPC this decrease depends on the F-hexane introduction procedure, it is independent from the procedure and most pronounced (from ∼2.0 µm to ∼1.0 µm) for DPPC. Introducing the FC in the gas phase has the strongest effect on MB half-life (t1/2 = ∼1.8 and 6.8 h for DMPC and DPPC, respectively), as compared to when it is delivered through the aqueous phase (∼0.8 and ∼1.7 h). Fluorocarbonless reference DMPC and DPPC bubbles had a half-life of ∼0.5 and 0.8 h, respectively. The effects of F-hexane on MB characteristics are discussed with regard to the interactions between phospholipids and F-hexane and monolayer fluidization effect, as revealed by the Langmuir and tensiometric studies.