Involvement of the cytoplasmic loop L6-7 in the entry mechanism for transport of Ca2+ through the sarcoplasmic reticulum Ca2+-ATPase.

We have found that despite a markedly low calcium affinity the D813A/D818A mutant is capable, after complexation with Cr.ATP, of occluding Ca(2+) to the same extent (1-2 Ca(2+) per ATPase monomer) as wild- type ATPase. The inherent ability of the synthetic L6-7 loop peptide to bind Ca(2+) was demonstrated with murexide and mass spectrometry. NMR analysis indicated the formation of specific 1:1 cation complexes of the peptide with calcium and lanthanum with coordination by all three aspartate residues D813/D815/D818 that resulted in an altered conformation of the peptide chain. Overall our observations suggest that, in addition to mediating contact between the intramembranous Ca(2+) binding sites and the cytosolic phosphorylation site as previously suggested, the L6-7 loop, in a preceding step, participates in the formation of an entrance port important for lodging Ca(2+) at a high-affinity binding site inside the membrane.

Interaction of amphipols with sarcoplasmic reticulum Ca2+-ATPase.

Amphipols are short-chain amphipathic polymers designed to keep membrane proteins soluble in aqueous solutions. We have evaluated the effects of the interaction of amphipols with sarcoplasmic reticulum Ca(2+)-ATPase either in a membrane-bound or a soluble form. If the addition of amphipols to detergent-solubilized ATPase was followed by removal of detergent, soluble complexes formed, but these complexes retained poor ATPase activity, were not very stable upon long incubation periods, and at high concentrations they experienced aggregation. Nevertheless, adding excess detergent to diluted detergent-free ATPase-amphipol complexes incubated for short periods immediately restored full activity to these complexes, showing that amphipols had protected solubilized ATPase from the rapid and irreversible inactivation that otherwise follows detergent removal. Amphipols also protected solubilized ATPase from the rapid and irreversible inactivation observed in detergent solutions if the ATPase Ca(2+) binding sites remain vacant. Moreover, in the presence of Ca(2+), amphipol/detergent mixtures stabilized concentrated ATPase against inactivation and aggregation, whether in the presence or absence of lipids, for much longer periods of time (days) than detergent alone. Our observations suggest that mixtures of amphipols and detergents are promising media for handling solubilized Ca(2+)-ATPase under conditions that would otherwise lead to its irreversible denaturation and/or aggregation.

Ligand binding to macromolecules or micelles: use of centrifugal ultrafiltration to measure low-affinity binding.

We describe a method for estimating ligand binding to a macromolecular sample under conditions where this binding is of low affinity and must be measured under equilibrium conditions, without removal of the unbound ligand. The method is based on centrifugal ultrafiltration through a membrane with a molecular mass cut-off intermediate between that of the ligand and that of the target, and the amount of bound ligand is calculated from the difference between the (total) ligand in the concentrated sample and the (free) ligand in the ultrafiltrate. Centrifugal ultrafiltration makes it possible to separate free ligand from bound ligand (without changing its concentration) and to simultaneously concentrate the target (such that the proportion of bound ligand becomes significant, even under low-affinity binding conditions). We applied this technique, using Centricon 10 (Amicon) devices, to several cases (soluble proteins, intact membranes, detergent-solubilized proteins, and pure detergent micelles) and assessed its value with respect to the common artifacts that occur in other protocols involving protein retention on nitrocellulose filters (nonspecific ligand adsorption and protein denaturation).

The cytoplasmic loop located between transmembrane segments 6 and 7 controls activation by Ca2+ of sarcoplasmic reticulum Ca2+-ATPase.

During active cation transport, sarcoplasmic reticulum Ca2+-ATPase, like other P-type ATPases, undergoes major conformational changes, some of which are dependent on Ca2+ binding to high affinity transport sites. We here report that, in addition to previously described residues of the transmembrane region (Clarke, D. M., Loo, T. W., Inesi, G., and MacLennan, D. H. (1989) Nature 339, 476-478), the region located in the cytosolic L6-7 loop connecting transmembrane segments M6 and M7 has a definite influence on the sensitivity of the Ca2+-ATPase to Ca2+, i.e. on the affinity of the ATPase for Ca2+. Cluster mutation of aspartic residues in this loop results in a strong reduction of the affinity for Ca2+, as shown by the Ca2+ dependence of ATPase phosphorylation from either ATP or Pi. The reduction in Ca2+ affinity for phosphorylation from Pi is observed both at acidic and neutral pH, suggesting that these mutations interfere with binding of the first Ca2+, as proposed for some of the intramembranous residues essential for Ca2+ binding (Andersen, J. P. (1995) Biosci. Rep. 15, 243-261). Treatment of the mutated Ca2+-ATPase with proteinase K, in the absence or presence of various Ca2+ concentrations, leads to Ca2+-dependent changes in the proteolytic degradation pattern similar to those in the wild type but observed only at higher Ca2+ concentrations. This implies that these effects are not due to changes in the conformational state of Ca2+-free ATPase but that changes affecting the proteolytic digestion pattern require higher Ca2+ concentrations. We conclude that aspartic residues in the L6-7 loop might interact with Ca2+ during the initial steps of Ca2+ binding.

Characterization of a protease-resistant domain of the cytosolic portion of sarcoplasmic reticulum Ca2+-ATPase. Nucleotide- and metal-binding sites.

Treatment of rabbit sarcoplasmic reticulum Ca2+-ATPase with a variety of proteases, including elastase, proteinase K, and endoproteinases Asp-N and Glu-C, results in accumulation of soluble fragments starting close to the ATPase phosphorylation site Asp351 and ending in the Lys605-Arg615 region, well before the conserved sequences generally described as constituting the "hinge" region of this P-type ATPase (residues 670-760). These fragments, designated as p29/30, presumably originate from a relatively compact domain of the cytoplasmic head of the ATPase. They retain two structural characteristics of intact Ca2+-ATPase as follows: high sensitivity of peptidic bond Arg505-Ala506 to trypsin cleavage, and high reactivity of lysine residue Lys515 toward the fluorescent label fluorescein 5'-isothiocyanate. Regarding functional properties, these fragments retain the ability to bind nucleotides, although with reduced affinity compared with intact Ca2+-ATPase. The fragments also bind Nd3+ ions, leaving open the possibility that these fragments could contain the metal-binding site(s) responsible for the inhibitory effect of lanthanide ions on ATPase activity. The p29/30 soluble domain, like similar proteolytic fragments that can be obtained from other P-type ATPases, may be useful for obtaining three-dimensional structural information on the cytosolic portion of these ATPases, with or without bound nucleotides. From our findings we infer that a real hinge region with conformational flexibility is located at the C-terminal boundary of p29/30 (rather than in the conserved region of residues 670-760); we also propose that the ATP-binding cleft is mainly located within the p29/30 domain, with the phosphorylation site strategically located at the N-terminal border of this domain.

The cytoplasmic loop between putative transmembrane segments 6 and 7 in sarcoplasmic reticulum Ca2+-ATPase binds Ca2+ and is functionally important.

Limited proteolysis by proteinase K of rabbit SERCA1 Ca2+-ATPase generates a number of fragments which have been identified recently. Here, we have focused on two proteolytic C-terminal fragments, p20C and p19C, starting at Gly-808 and Asp-818, respectively. The longer peptide p20C binds Ca2+, as deduced from changes in migration rate by SDS-polyacrylamide gel electrophoresis performed in the presence of Ca2+ as well as from labeling with 45Ca2+ in overlay experiments. In contrast, the shorter peptide p19C, a proteolysis fragment identical to p20C but for 10 amino acids missing at the N-terminal side, did not bind Ca2+ when submitted to the same experiments. Two cluster mutants of Ca2+-ATPase, D813A/D818A and D813A/D815A/D818A, expressed in the yeast Saccharomyces cerevisiae, were found to have a very low Ca2+-ATPase activity. Region 808-818 is thus essential for both Ca2+ binding and enzyme activity, in agreement with similar results recently reported for the homologous gastric H+, K+-ATPase (Swarts, H. G. P., Klaassen, C. H. W., de Boer, M., Fransen, J. A. M. , and De Pont, J. J. H. H. M. (1996) J. Biol. Chem. 271, 29764-29772). However, the accessibility of proteinase K to the peptidyl link between Leu-807 and Gly-808 clearly shows that the transmembrane segment M6 ends before region 808-818. It is remarkable that critical residues for enzyme activity are located in a cytoplasmic loop starting at Gly-808.