Redox Properties and in Vivo Magnetic Resonance Imaging of Cyclodextrin-Polynitroxides Contrast Agents.

This paper reports the synthesis, characterization and in vivo application of water-soluble supramolecular contrast agents (Mw: 5-5.6 kDa) for MRI obtained from ß-cyclodextrin functionalized with different kinds of nitroxide radicals, both with piperidine structure (CD2 and CD3) and with pyrrolidine structure (CD4 and CD5). As to the stability of the radicals in presence of ascorbic acid, CD4 and CD5 have low second order kinetic constants (≤0.05 M-1 s-1 ) compared to CD2 (3.5 M-1 s-1 ) and CD3 (0.73 M-1 s-1 ). Relaxivity (r1 ) measurements on compounds CD3-CD5 were carried out at different magnetic field strength (0.7, 3, 7 and 9.4 T). At 0.7 T, r1 values comprised between 1.5 mM-1 s-1 and 1.9 mM-1 s-1 were found while a significant reduction was observed at higher fields (r1 ≈0.6-0.9 mM-1 s-1 at 9.4 T). Tests in vitro on HEK293 human embryonic kidney cells, L929 mouse fibroblasts and U87 glioblastoma cells indicated that all compounds were non-cytotoxic at concentrations below 1 µmol mL-1 . MRI in vivo was carried out at 9.4 T on glioma-bearing rats using the compounds CD3-CD5. The experiments showed a good lowering of T1 relaxation in tumor with a retention of the contrast for at least 60 mins confirming improved stability also in vivo conditions.

Decellularized fennel and dill leaves as possible 3D channel network in GelMA for the development of an in vitro adipose tissue model.

The development of 3D scaffold-based models would represent a great step forward in cancer research, offering the possibility of predicting the potential in vivo response to targeted anticancer or anti-angiogenic therapies. As regards, 3D in vitro models require proper materials, which faithfully recapitulated extracellular matrix (ECM) properties, adequate cell lines, and an efficient vascular network. The aim of this work is to investigate the possible realization of an in vitro 3D scaffold-based model of adipose tissue, by incorporating decellularized 3D plant structures within the scaffold. In particular, in order to obtain an adipose matrix capable of mimicking the composition of the adipose tissue, methacrylated gelatin (GelMA), UV photo-crosslinkable, was selected. Decellularized fennel, wild fennel and, dill leaves have been incorporated into the GelMA hydrogel before crosslinking, to mimic a 3D channel network. All leaves showed a loss of pigmentation after the decellularization with channel dimensions ranging from 100 to 500 µm up to 3 µm, comparable with those of human microcirculation (5-10 µm). The photo-crosslinking process was not affected by the embedded plant structures in GelMA hydrogels. In fact, the weight variation test, performed on hydrogels with or without decellularized leaves showed a weight loss in the first 96 h, followed by a stability plateau up to 5 weeks. No cytotoxic effects were detected comparing the three prepared GelMA/D-leaf structures; moreover, the ability of the samples to stimulate differentiation of 3T3-L1 preadipocytes in mature adipocytes was investigated, and cells were able to grow and proliferate in the structure, colonizing the entire microenvironment and starting to differentiate. The developed GelMA hydrogels mimicked adipose tissue together with the incorporated plant structures seem to be an adequate solution to ensure an efficient vascular system for a 3D in vitro model. The obtained results showed the potentiality of the innovative proposed approach to mimic the tumoral microenvironment in 3D scaffold-based models.

Electrophoretic processing of chitosan based composite scaffolds with Nb-doped bioactive glass for bone tissue regeneration.

Bioactive glasses (BGs), due to their ability to influence osteogenic cell functions, have become attractive materials to improve loaded and unloaded bone regeneration. BG systems can be easily doped with several metallic ions (e.g., Ag, Sr, Cu, Nb) in order to confer antibacterial properties. In particular, Nb, when compared with other metal ions, has been reported to be less cytotoxic and possess the ability to enhance mineralization process in human osteoblast populations. In this study, we co-deposited, through one-pot electrophoretic deposition (EPD), chitosan (CS), gelatin (GE) and a modified BG containing Nb to obtain substrates with antibacterial activity for unloaded bone regeneration. Self-standing composite scaffolds, with a defined porosity (15-90 µm) and homogeneous dispersion of BGs were obtained. TGA analysis revealed a BG loading of about 10% in the obtained scaffolds. The apatite formation ability of the scaffolds was evaluated in vitro in simulated body fluid (SBF). SEM observations, XRD and FT-IR spectra showed a slow (21-28 days) yet effective nucleation of CaP species on BGs. In particular, FT-IR peak around 603 cm-1 and XRD peak at 2θ = 32°, denoted the formation of a mineral phase after SBF immersion. In vitro biological investigation revealed that the release of Nb from composite scaffolds had no cytotoxic effects. Interestingly, BG-doped Nb scaffolds displayed antibacterial properties, reducing S. lutea and E. coli growth of ≈60% and ≈50%, respectively. Altogether, the obtained results disclose the produced composite scaffolds as promising materials with inherent antibacterial activity for bone tissue engineering applications.

Hierarchical microchannel architecture in chitosan/bioactive glass scaffolds via electrophoretic deposition positive-replica.

One of the main challenges in the design of scaffolds for cortical bone regeneration is mimicking the highly oriented, hierarchical structure of the native tissue in an efficient, simple, and consistent way. As a possible solution to this challenge, positive replica based on electrophoretic deposition (EPD) was here evaluated as a technique to produce organic/inorganic scaffolds with oriented micro-porosities mimicking Haversian canals diameter and spacing. Two different sizes of 45S5 bioactive glass (BG) powders were chosen as inclusions and loaded in a chitosan matrix via EPD on micro-patterned cathodes. Self-standing chitosan scaffolds, with a homogeneous dispersion of BG particles and regularly-oriented micro-channels (ϕ = 380 ± 50 µm, inter-channel spacing = 600 ± 40 µm), were obtained. In vitro analysis in simulated body fluid (SBF) revealed the ability to induce a deposition of a homogenous layer of hydroxyapatite (HA), with Ca/P nucleation reactions appearing kinetically favored by smaller BG particles. Cell interaction with hybrid scaffolds was evaluated in vitro with bone osteosarcoma cells (SAOS-2). The osteoconductive potential of EPD structures was assessed by evaluating cells proliferation, viability and scaffold colonization. Results indicate that EPD is a simple yet extremely effective technique to prepare composite micro-patterned structures and can represent a platform for the development of a new generation of bone scaffolds. © 2019 Wiley Periodicals, Inc. J Biomed Mater Res Part A, 2019.

Stem cell augmented mesh materials: an in vitro and in vivo study.

INTRODUCTION AND HYPOTHESIS: To test in vitro and in vivo the capability of mesh materials to act as scaffolds for rat-derived mesenchymal stem cells (rMSCs) and to compare inflammatory response and collagen characteristics of implant materials, either seeded or not with rMSCs. METHODS: rMSCs isolated from rat bone marrow were seeded and cultured in vitro on four different implant materials. Implants showing the best rMSC proliferation rate were selected for the in vivo experiment. Forty-eight adult female Sprague-Dawley rats were randomly divided into two treatment groups. The implant of interest-either seeded or not with rMSCs-was laid and fixed over the muscular abdominal wall. Main outcome measures were: in vitro, proliferation of rMSCs on selected materials; in vivo, the occurrence of topical complications, the evaluation of systemic and local inflammatory response and examination of the biomechanical properties of explants. RESULTS: Surgisis and Pelvitex displayed the best cell growth in vitro. At 90 days in the rat model, rMSCs were related to a lower count of neutrophil cells for Pelvitex and a greater organisation and collagen amount for Surgisis. At 7 days Surgisis samples seeded with rMSCs displayed higher breaking force and stiffness. CONCLUSIONS: The presence of rMSCs reduced the systemic inflammatory response on synthetic implants and improved collagen characteristics at the interface between biological grafts and native tissues. rMSCs enhanced the stripping force on biological explants.

Effects of the magnetic resonance field on breast tissue expanders.

BACKGROUND: Tissue expansion for breast reconstruction after mastectomy is a safe and effective procedure. A magnetic resonance imaging (MRI) scan can be requested for patients with a breast expander to evaluate concurrent diseases. The electromagnetic field of the MR can interfere with biomedical devices, resulting in potential hazards, compromising the diagnosis, or creation of artifacts. METHODS: Four tissue expanders with an integrated magnetic valve were tested. The temperature increase was measured using an infrared camera in the MR scanner. The expanders were tested (half-full and full of saline solution) both free in air and immersed in a phantom. The ferromagnetic properties of the devices were assessed using the deflection angle method. To evidence artifacts due to the presence of the expander, MR images were acquired for expanders tested in air and in the phantom. A valve localization test was performed after MRI analysis. RESULTS: A slight increase in temperature was demonstrated, without any clinical significance. The deflection angle due to the magnetic field depends on the distance from the bore of the magnet. The angle is higher when the device is closer to the bore. The presence of the magnetic valve influences the MRI signal, creating artifacts on the acquired images, even far from the valve itself. The valve localization test allowed verification of correct valve functioning for all the expanders after the MRI analysis. CONCLUSIONS: Under selected conditions, MRI scans can be feasible. Heating is not expected to be a major concern, whereas valve displacement could happen in certain clinical conditions. The presence of artifacts is almost unavoidable. LEVEL OF EVIDENCE III: This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266.

Enzymatic cross-linking of human recombinant elastin (HELP) as biomimetic approach in vascular tissue engineering.

The use of polymers naturally occurring in the extracellular matrix (ECM) is a promising strategy in regenerative medicine. If compared to natural ECM proteins, proteins obtained by recombinant DNA technology have intrinsic advantages including reproducible macromolecular composition, sequence and molecular mass, and overcoming the potential pathogens transmission related to polymers of animal origin. Among ECM-mimicking materials, the family of recombinant elastin-like polymers is proposed for drug delivery applications and for the repair of damaged elastic tissues. This work aims to evaluate the potentiality of a recombinant human elastin-like polypeptide (HELP) as a base material of cross-linked matrices for regenerative medicine. The cross-linking of HELP was accomplished by the insertion of cross-linking sites, glutamine and lysine, in the recombinant polymer and generating ε-(γ-glutamyl) lysine links through the enzyme transglutaminase. The cross-linking efficacy was estimated by infrared spectroscopy. Freeze-dried cross-linked matrices showed swelling ratios in deionized water (≈2500%) with good structural stability up to 24 h. Mechanical compression tests, performed at 37°C in wet conditions, in a frequency sweep mode, indicated a storage modulus of 2/3 kPa, with no significant changes when increasing number of cycles or frequency. These results demonstrate the possibility to obtain mechanically resistant hydrogels via enzymatic crosslinking of HELP. Cytotoxicity tests of cross-linked HELP were performed with human umbilical vein endothelial cells, by use of transwell filter chambers for 1-7 days, or with its extracts in the opportune culture medium for 24 h. In both cases no cytotoxic effects were observed in comparison with the control cultures. On the whole, the results suggest the potentiality of this genetically engineered HELP for regenerative medicine applications, particularly for vascular tissue regeneration.