Spinal cord stimulator medullary compression-a very rare SCS complication and surgical treatment.

INTRODUCTION: The risk of spinal cord damage after Spinal Cord Stimulator (SCS) implant is a very rare event. In our case report, the patient was affected by a progressively worsening spinal stenosis due to SCS compression. CASE REPORT: The authors describe a progressive paraparesis in a 58-year-old woman with a long history of back pain and multiple spine surgeries. Computed tomography (CT) outlined vertebral canal stenosis corresponding to an electrode array implanted in T9. A posterior T8-T10 spinal cord decompression with explanation of the SCS device was performed and a partial neurological improvement was observed immediately postoperative. DISCUSSION: Spinal cord stimulation has been used since 1967 for the treatment of refractory chronic pain, particularly failed back surgery syndrome (FBSS) and complex regional pain syndrome (CRPS). Still, the mechanism underlying its function is not completely clear. Moreover, complications are mainly related to implant dysfunction and the risk of direct and indirect spinal cord compression is described as exceptional in the literature. Our aim is to describe the case SCS device spinal cord direct compression and its surgical treatment.

Delayed postoperative cervical spinal cord ischemic lesion after a thoracolumbar fusion for syndromic scoliosis: a case report and systematic review of the literature.

INTRODUCTION: We report a case and a literature review of delayed postoperative cervical spinal cord injury after thoraco-lumbar spine surgery. CASE REPORT: A 13-year-old Prader-Willi Syndrome female was treated by a T3-L5 posterior spine fusion for progressive scoliosis. Intraoperative neuromonitoring and immediate postoperative neurological examination were normal. Sixty hours after surgery, she developed a tetraplegia. The immediate MRI and CT scan of the spine were negative. Two days after, a new MRI revealed an ischemic cervical lesion at the level C5-C6. After 1 week, she gradually improved breathing and motility/sensibility at the extremities. After 4 months of intensive neurologic rehabilitation, the patient improved to ASIA grade D and was discharged. At 1-year follow, the neurologic recovery was nearly completed. METHODS: We performed a systematic review of the literature through PubMed and Embase database focused on delayed postoperative cervical spinal cord lesion after a thoraco-lumbar fusion for spinal deformity. RESULTS: Only 14 cases of neurological injuries at levels above the site of surgery have been previously reported and never in Prader Willy Syndrome. All patients were adolescent and 86,7% were females but no specific risk factors were found. CONCLUSIONS: Delayed postoperative neurological deficit far from the surgical site can be considered a specific subgroup of these rare complication that can occur several hours after spine surgery, regardless of intraoperative complication. Despite the rarity of this complication, clinicians should be aware of it. Perioperative optimization of spinal cord perfusion and close neurological examination in first postoperative days may be helpful to quickly recognize and treat this complication.

Simulation-guided navigation: a new approach to improve intraoperative three-dimensional reproducibility during orthognathic surgery.

Because of the recent development of three-dimensional technology, computer software is increasingly being used for diagnosis, analysis, data documentation, and surgical planning for orthognathic surgery. Currently, the typical method to reposition jaws in the correct and planned location is based on the use of surgical splints, which have a quite high level of imprecision. The most important differences between planned and achieved maxillary movements are in the vertical and rotational positioning. Several methods have been described for intraoperative maxillary control, but none of these procedures is satisfactory. We present a new method to transfer individualized three-dimensional virtual planning of the patient using a navigation system in the operating room to improve reproducibility of the simulation. We enrolled 10 patients with dentofacial deformities from November 2008 to May 2009. All patients were studied and treated according to the following steps: cone-beam computed tomography data acquisition, virtual simulation of the surgical procedure, surgery with intraoperative navigation, and validation through reproducibility evaluation. We found 86.5% mean preoperative surgical plan reproducibility with the assistance of simulation-guided navigation compared with 80% mean reproducibility obtained in our previous group, in which no intraoperative navigation was performed. According to these results, we can assume that simulation-guided navigation would be a helpful procedure during orthognathic surgery to improve reproducibility of the preoperative virtual surgical planning.