Comparing Isolated Thumb Force Generation, Wrist Rotation, and Clinical Measurements in Healthy and Osteoarthritic Individuals before and after Surgery.

Thumb carpometacarpal (CMC) osteoarthritis (OA) is caused by the degeneration of joint surfaces at the base of the thumb. If conservative treatments have failed, surgery may be needed to improve symptoms. Typically, standard clinical tools, such as the pinch gauge, are used to measure thumb force. However, these devices have utilized multiple digits and do not represent forces specifically generated by the thumb. Therefore, different devices are necessary to accurately measure isolated thumb force. The primary objective was to research the effect of thumb force after ligament reconstruction with tendon interposition surgery. To accomplish this, several sub-objectives were implemented: (1) create a testing device to collect isolated thumb forces, (2) collect a normative thumb force data set of males and females to compare the impact of aging and surgery, (3) collect and compare clinical data to see if these data sets matched isolated thumb forces, (4) determine the effect of wrist position on isolated thumb force data in different wrist positions, and (5) collect thumb force in directions that mimic daily activities, a directional force downward (push) and inward (pull). On average, older participants generated statistically larger forces than younger participants. Additionally, only 50% of CMC OA participants showed greater than 5 N of improvement at 6-months post-surgery compared to pre-surgery, but did not reach healthy force levels. When evaluating wrist rotation, OA participants' push and pull decreased by 8 N and 7 N in the horizontal wrist position, and their push and pull increased by 2 N and 5 N in the vertical wrist position. Evaluation and results with standard clinical tools showed different post-surgery trends than isolated force data, which suggested the clinical approach has mixed results and may be under- or over-estimating the recovery process. These data sets allow surgeons and hand therapists to identify changes in isolated thumb force generation to create specialized therapies and treatment options, which is an improvement upon current clinical measurement tools.

Kinematic Investigation of Healthy, Arthritic, and Postsurgery Thumbs: Is the Metacarpophalangeal Joint the Gateway to Carpometacarpal Arthritis?

The thumb carpometacarpal (CMC) joint is one of the most likely joints to develop osteoarthritis (OA). If conservative treatments fail to alleviate symptoms, surgery may be pursued. Kinematic outcomes of CMC surgery techniques have been described, but current tools have limitations in capturing motion abilities. The goals of this study were (1) develop a new and robust set of kinematic outcome measures, and apply them to (2) a cohort of younger and older control individuals without CMC OA to determine age and sex-related changes, and (3) a cohort of participants with CMC OA before, 3 months, and 6 months after undergoing thumb ligament reconstruction with tendon interposition surgery to detect the impacts of surgery. 52 (26 males, 26 females) control and 18 (3 males, 15 females) surgical participants were tested. Kinematics were investigated using motion capture by mapping the three-dimensional motion space of the whole thumb, and two-dimensional motion boundaries of the metacarpal (MC) and proximal phalange (PP). Visual analog pain score was recorded. Older control participants had shifted regions of motion compared to younger participants (p ≤ 0.027), suggesting asymptomatic CMC wear. Control females had 31% more metacarpophalangeal (MCP) motion than control males (p = 0.013), which could alter loading paths through the CMC joint and increase OA risk. Pain at 6 months postsurgery was 72% less than presurgery (p < 0.001), but motion abilities were 20-28% less than presurgery (p ≤ 0.074) and 24-40% less than control participants (p ≤ 0.066). These techniques have the possibility of identifying presymptomatic motion changes, including those at the metacarpophalangeal joint in CMC OA progression.

The Female Thumb Carpometacarpal Joint: Motion and Force Changes Due to Arthritis and Surgical Intervention.

Thumb carpometacarpal (CMC) osteoarthritis (OA) has been one of the most common locations of hand OA. CMC OA disproportionately occurs in females over males. In severe cases, surgical intervention may be needed. However, to determine the effects of surgical treatment, normative, pre-, and postsurgery function must be understood. The goals of this work were to compare the thumb motion and force abilities of older healthy (OH) females without CMC OA to those of females with CMC OA and who received ligament reconstruction with tendon interposition (LRTI) surgery at time points presurgery, 3- and 6-months postsurgery. On average, CMC OA participants 3- and 6-months postsurgery showed 35.6% and 32.9% less overall metacarpal motion compared to presurgery, 31.9% and 29.1% less than OH, and exhibited altered motion. Metacarpal flexion/extension and abduction/adduction ranges were 51.9 deg and 43.4 deg for OH, 52.9 deg and 40.3 deg presurgery, 39.9 deg and 33.5 deg at 3-months, and 42.6 deg and 32.7 deg at 6-months postsurgery. On average, participants had increased force generation at 6-months postsurgery compared to presurgery, and 20% of participants returned to the level of OH females. These data sets highlight changes in thumb metacarpal movement and thumb force generation due to disease and surgical intervention. This work has the ability to support both surgeons and patients through improved outcome assessments as well as additional data to inform the decision process on intervention.

The Role of Environmental Factors in the Etiology of Nonsyndromic Orofacial Clefts.

BACKGROUND: Nonsyndromic orofacial clefts (NSOFCs) represent the most common congenital anomalies in the head and neck region. Multiple factors contribute to the occurrence of this anomaly. The etiology of NSOFCs in the Ethiopian population has not been investigated prior to this study. AIMS OF THE STUDY: To assess the role of maternal environmental factors in the occurrence of NSOFCs in the Ethiopian Population. METHODS: The authors used unmatched case control study design and evaluated the role of environmental factors to the occurrence of NSOFCs in the Ethiopian population. The participants were recruited from the same institution (Yekatit 12 Hospital Medical College). The authors studied 760 mothers (359 mothers of children born with NSOFCs and 401 mothers of children born without any congenital anomalies). Univariate and multivariate logistic regression analyses were used to calculate relative risk by odds ratio and 95% confidence interval. RESULTS: Mothers who gave history of bronchial asthma and mothers who were admitted for threatened abortion had a higher risk of delivering a child with NSOFCS P value=0.013; AOR=0.194, 95% CI [0.053-0.712], P value <0.001; AOR= 0.179, 95% CI [0.091-0.352] respectively. Higher number of children with NSOFCs were born to mothers who were exposed to diagnostic X-ray investigation during early pregnancy than those who were not exposed P value 0.048; AOR=0.375, 95% CI [0.142-0.990]. CONCLUSION: Maternal exposure to diagnostic x-ray, maternal chronic illness like bronchial asthma and threatened abortion were found to be associated with the occurrence of NSOFCS in the studied population.

Do Canes or Walkers Make Any Difference? NonUse and Fall Injuries.

Purpose of the Study: Examine patterns of cane and walker use as related to falls and fall injuries. Hypotheses: Among people who fall at home, most do not have an assistive device with them when they fall. Nonusers who fall sustain more severe injuries. Design and Methods: This was a cross-sectional study using a self-administered written survey completed by 262 people aged 60 and older who were community dwelling, cognitively intact, and current cane/walker users with a history of falls. They were recruited through clinical practice sites, churches, and senior housing in central Michigan. Outcomes of interest included patterns of device use, reasons for nonuse, device use at time of fall, and fall-related injuries. Results: Seventy-five percent of respondents who fell were not using their device at the time of fall despite stating that canes help prevent falls. Reasons for nonuse included believing it was not needed, forgetfulness, the device made them feel old, and inaccessibility. Perceived risk was not high enough to engage in self-protective behavior. However, nonuse led to a significantly higher proportion of falls resulting in surgery than among device users. Among respondents requiring surgery, 100% were nonusers. Most respondents never received a home safety evaluation (68%) and only 50% received training on proper device use. Implications: Providers must place increased emphasis on the importance of cane/walker use for injury prevention through patient education to promote personal relevance, proper fitting, and training. New strategies are needed to improve device acceptability and accessibility.

Comparison between healthy and reduced hand function using ranges of motion and a weighted fingertip space model.

Detection and quantification of changes in hand function are important for patients with loss of function and clinicians who are treating them. A recently developed model, the weighted fingertip space (WFS) quantifies the hand function of individuals in three-dimensional space and applies kinematic weighting parameters to identify regions of reachable space with high and low hand function. The goal of this research was to use the WFS model to compare and contrast the functional abilities of healthy individuals with the abilities of individuals with reduced functionality due to arthritis (RFA). Twenty two individuals with no reported issues with hand function and 21 individuals with arthritis affecting the hand were included in the research. Functional models were calculated from the ranges of motion and hand dimension data for each individual. Each model showed the volume of reachable space for each fingertip of each hand, the number of ways to reach a point in space, the range of fingertip orientations possible at each point, and the range of possible force application directions (FADs) at each point. In addition, two group models were developed that showed how many individuals in both the healthy and RFA groups were able to reach the same points in space. The results showed differences between the two groups for the range of motion (ROM) measurements, the individual model calculations, and the group models. The ROM measurements showed significant differences for the joints of the thumb, extension of the nonthumb metacarpophalangeal (MCP) joints, and flexion of the distal interphalangeal (DIP) joints. Comparing the models, the two groups qualitatively showed similar patterns of functional measures in space, but with the RFA group able to reach a smaller volume of space. Quantitatively, the RFA group showed trends of smaller values for all of the calculated functional weighting parameters and significantly smaller reachable volume for all of the fingers. The group models showed that all healthy individuals were able to reach an overlapping space, while 18 of 21 RFA individuals were able to reach similar spaces. Combined, the results showed that the WFS model presents the abilities of the hand in ways that can be quantitatively and qualitatively compared. Thus, the potential of this hand model is that it could be used to assess and document the changes that occur in hand function due to rehabilitation or surgery, or as a guide to determine areas most accessible by various populations.

Team science of nursing, engineering, statistics, and practitioner in the development of a robotic reflexology device.

The purpose of this article is to share the lessons learned in forming an interdisciplinary team that implements a team science approach to integrative medicine (IM) research. The disciplines of nursing, statistics, and engineering, along with consultants and a reflexology practitioner, formed this university-based team to conceptualize and develop a prototype robotic device for reflexology for breast cancer patients. The nurse investigator contributed the intervention background and access to the population; the statistician guided the team thinking on factors that needed to be controlled for; the engineers provided the expertise in device design and development; consultants facilitated the team's thinking in new directions; and the reflexology practitioner prescribed the protocol. We discuss the contributions and achievements of each discipline, as well as the challenges, and share the team experiences with the intent to help guide the formation of new IM teams that promote a conducive atmosphere for carrying out cutting-edge IM research and advancing the science.