The Self-assembling peptide P11-4 influences viability and osteogenic differentiation of stem cells of the apical papilla (SCAP).

OBJECTIVE: To analyze the effect of P11-4 self-assembly peptide on cell viability and osteogenic capacity of SCAPs through mineral deposition and gene expression of osteogenic markers. METHODS: SCAPs were seeded in contact with P11-4 (10 µg/ml, 100 µg/ml and 1 mg/ml) solution. Cell viability was evaluated using a colorimetric assay MTT: 3-(4,5-dimethyl-thiazolyl-2)-2,5- diphenyltetrazolium bromide) in an experimental time of 24, 48 and 72 h (n = 7). Mineral deposition and quantification provided by the cells was tested using the Alizarin Red staining and Cetylpyridinium Chloride (CPC), respectively, after 30 days (n = 4). Gene expression of Runt-related transcription factor 2 (RUNX2), Alkaline phosphatase (ALP) and Osteocalcin (OCN) was quantified using quantitative polymerase chain reaction (RT-qPCR), at 3 and 7 days with Glyceraldehyde-3-phosphate dehydrogenase (GAPDH) as the housekeeping gene, and relative gene expression was measured using the ΔΔCq method. Data were analyzed using Kruskall-Wallis followed by multiple comparisons, and T-test for gene expression with α=0.05. RESULTS: All tested concentrations (10 µg/ml, 100 µg/ml and 1 mg/ml) were not cytotoxic at time 24 and 48 h. After 72 h, a slight decrease in cell viability was observed for the lowest concentration (10 µg/ml). The concentration of 100 µg/ml P11-4 showed the highest mineral deposition. However, qPCR analysis of P11-4 (10 µg/ml) showed upregulation of RUNX2 and OCN at 3 days, with downregulation of ALP at 3 and 7d CONCLUSION: P11-4 did not affect cell viability, induced mineral deposition in SCAPs, and upregulated the expression of RUNX2 and OCN genes at 3 days, while downregulating ALP expression at 3 and 7 days. CLINICAL SIGNIFICANCE: Based on the results obtained in this study it can be stated that self-assembling peptide P11-4 is a potential candidate to induce mineralization on dental stem cells for regenerative purposes and also for a clinical use as a capping agent without compromising the cells health.

Influence of the incorporation of triclosan methacrylate on the physical properties and antibacterial activity of resin composite

Abstract The incorporation of antimicrobials in the composites as an attempt to reduce bacterial adhesion without jeopardizing mechanical properties is a challenge for Dentistry. Objective: To evaluate the bacterial adhesion and physical properties of a composite containing the methacrylate triclosan- derivative monomer (TM). Methodology: TM was synthesized and added to an experimental composite. Samples were divided into two groups: Control and TM (13.4 wt%). Antibacterial Activity: Three specimens of each material were prepared and placed on bacterial suspensions of Streptococcus mutans for 1, 5 and 10 days. After these periods the counting of the colonies (log10) was performed. Assays was performed in triplicate. Physical Properties: Three-body Abrasion (TBA): Ten specimens of each material were prepared and stored at 37°C/24 h. The surface roughness (Ra) and hardness (KHN) were analyzed. Next, the specimens were submitted to abrasive wear (30,000 cycles) and re-evaluated for Ra and KHN; Sorption/solubility (SS): cylindrical specimens (n=10) were prepared and weighted. The specimens were immersed in deionized water for 7 days at 37°C and then their weight was verified again. SS were calculated using accepted formulas; Diametral tensile strength (DTS): specimens (n=10) underwent test performed in an Instron universal testing machine at a crosshead speed of 1 mm/min. Data were submitted to appropriate statistical tests according to data distribution and assay (p<0.05). Results: Bacterial Adhesion: TM showed a significant reduction on biofilm accumulation in the evaluated periods: 1 day (1.537±0.146); 5 days (2.183±0.138) and 10 days (4.469±0.155) when compared with Control: 1 day (4.954±0.249); 5 days (5.498±0.257) and 10 days (6.306±0.287). Physical Properties: For TBA, SS and DTS no significant difference was found between groups Control and TM. The incorporation of methacrylate triclosan-based monomer in the experimental composite reduce bacterial adhesion of S. mutans and did not affect important polymer properties.