Studying the onset of galvanic steel corrosionin situusing thin films: film preparation, characterization and application to pitting.

This work reports about a novel approach for investigating surface processes during the early stages of galvanic corrosion of stainless steelin situby employing ultra-thin films and synchrotron x-radiation. Characterized by x-ray techniques and voltammetry, such films, sputter deposited from austenitic steel, were found representing useful replicas of the target material. Typical for stainless steel, the surface consists of a passivation layer of Fe- and Cr-oxides, a couple of nm thick, that is depleted of Ni. Films of ≈4 nm thickness were studiedin situin an electrochemical cell under potential control (-0.6 to +0.8 V vs Ag/AgCl) during exposure to 0.1 M KCl. Material transport was recorded with better than 1/10 monolayer sensitivity by x-ray spectroscopy. Leaching of Fe was observed in the cathodic range and the therefor necessary reduction of Fe-oxide appears to be accelerated by atomic hydrogen. Except for minor leaching, reduction of Ni, while expected from Pourbaix diagram, was not observed until at a potential of about +0.8 V Cr-oxide was removed from the steel film. After couple of minutes exposure at +0.8 V, the current in the electrochemical cell revealed a rapid pitting event that was simultaneously monitored by x-ray spectroscopy. Continuous loss of Cr and Ni was observed during the induction time leading to the pitting, suggesting a causal connection with the event. Finally, a spectroscopic image of a pit was recordedex situwith 50 nm lateral and 1 nm depth resolution by soft x-ray scanning absorption microscopy at the Fe L2,3-edges by using a 80 nm film on a SiN membrane, which is further demonstrating the usefulness of thin films for corrosion studies.

Biogenic supported lipid bilayers as a tool to investigate nano-bio interfaces.

HYPOTHESIS: Extracellular Vesicles (EVs) are natural nanosized lipid vesicles involved in most intercellular communication pathways. Given their nature, they represent natural cell membrane models, with intermediate complexity between real and synthetic lipid membranes. Here we compare EVs-derived (EVSLB) and synthetic Supported Lipid Bilayers (SLBs) in the interaction with cationic superparamagnetic iron oxide nanoparticles (SPIONs). The aim is twofold: (i) exploit SPIONs as nanometric probes to investigate the features of EVSLBs as novel biogenic platforms; (ii) contribute at improving the knowledge on the behavior of SPIONs with biological interfaces. EXPERIMENTS: Quartz Crystal Microbalance, X-ray Reflectivity, Grazing-incidence Small-angle X-ray Scattering, Atomic Force Microscopy, Confocal Microscopy data on SPIONs-EVSLB were systematically compared to those on SPIONs challenging synthetic SLBs, taken as references. FINDINGS: The ensemble of experimental results highlights the much stronger interaction of SPIONs with EVSLBs with respect to synthetic SLBs. This evidence strongly supports the hypotheses on the peculiar structure of EVSLBs, with cushioned non-flat areas and extended exposed surface; in addition, it suggests that these features are relevant in the response of biogenic membranes to nano-objects. These findings contribute to the fundamental knowledge on EVSLBs, key for their development both as biomimetic membranes, or as platforms for biomedical applications.

Simultaneous scanning tunneling microscopy and synchrotron X-ray measurements in a gas environment.

A combined X-ray and scanning tunneling microscopy (STM) instrument is presented that enables the local detection of X-ray absorption on surfaces in a gas environment. To suppress the collection of ion currents generated in the gas phase, coaxially shielded STM tips were used. The conductive outer shield of the coaxial tips can be biased to deflect ions away from the tip core. When tunneling, the X-ray-induced current is separated from the regular, 'topographic' tunneling current using a novel high-speed separation scheme. We demonstrate the capabilities of the instrument by measuring the local X-ray-induced current on Au(1 1 1) in 800 mbar Ar.

Dibenzo crown ether layer formation on muscovite mica.

Stable layers of crown ethers were grown on muscovite mica using the potassium-crown ether interaction. The multilayers were grown from solution and from the vapor phase and were analyzed with atomic force microscopy (AFM), matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry, and surface X-ray diffraction (SXRD). The results show that the first molecular layer of the three investigated dibenzo crown ethers is more rigid than the second because of the strong interaction of the first molecular layer with the potassium ions on the surface of muscovite mica. SXRD measurements revealed that for all of the investigated dibenzo crown ethers the first molecule lies relatively flat whereas the second lies more upright. The SXRD measurements further revealed that the molecules of the first layer of dibenzo-15-crown-5 are on top of a potassium atom, showing that the binding mechanism of this layer is indeed of the coordination complex form. The AFM and SXRD data are in good agreement, and the combination of these techniques is therefore a powerful way to determine the molecular orientation at surfaces.