Adsorption of 4-n-Nonylphenol, Carvacrol, and Ethanol onto Iron Oxide from Nonaqueous Hydrocarbon Solvents.

The adsorption of 4-n-nonylphenol (4NP), carvacrol, and ethanol onto the surface of iron oxide from nonaqueous solutions is presented. It is found that adsorption of 4NP from alkanes is strong and proceeds to monolayer formation, where the molecules are essentially "upright". However, at high relative concentrations, ethanol successfully out-competes 4NP for the iron oxide surface. Estimates of the enthalpy and entropy of binding of 4NP were found to be exothermic and entropically disfavored. Sum frequency generation vibrational spectroscopy data indicate some evidence of binding through a phenolate anion, despite the nonpolar, nonaqueous solvent. Carvacrol is also found to adsorb as a monolayer where the molecules are lying "flat". The adsorption of ethanol onto iron oxide from dodecane was investigated through the use of quantitative NMR, which is a convenient analytical technique for measuring adsorption isotherms. It was concluded that ethanol does not form adsorbed monolayers on the surface. Instead, it partitions onto the surface as a surface-enhanced local phase separation related to its poor solubility in alkane solvents.

Adsorption of 1- and 2-butylimidazoles at the copper/air and steel/air interfaces studied by sum frequency generation vibrational spectroscopy.

The structure of thin films of 1- and 2-butylimidazoles adsorbed on copper and steel surfaces under air was examined using sum frequency generation (SFG) vibrational spectroscopy in the ppp and ssp polarizations. Additionally, the SFG spectra of both isomers were recorded at 55 °C at the liquid imidazole/air interface for reference. Complementary bulk infrared, reflection-absorption infrared spectroscopy (RAIRS), and Raman spectra of both imidazoles were recorded for assignment purposes. The SFG spectra in the C-H stretching region at the liquid/air interface are dominated by resonances from the methyl end group of the butyl side chain of the imidazoles, indicating that they are aligned parallel or closely parallel to the surface normal. These are also the most prominent features in the SFG spectra on copper and steel. In addition, both the ppp and ssp spectra on copper show resonances from the C-H stretching modes of the imidazole ring for both isomers. The ring C-H resonances are completely absent from the spectra on steel and at the liquid/air interface. The relative intensities of the SFG spectra can be interpreted as showing that, on copper, under air, both butylimidazoles are adsorbed with their butyl side chains perpendicular to the interface and with the ring significantly inclined away from the surface plane and toward the surface normal. The SFG spectra of both imidazoles on steel indicate an orientation where the imidazole rings are parallel or nearly parallel to the surface. The weak C-H resonances from the ring at the liquid/air interface suggest that the tilt angle of the ring from the surface normal at this interface is significantly greater than it is on copper.

The structure of oleamide films at the aluminum/oil interface and aluminum/air interface studied by Sum Frequency Generation (SFG) vibrational spectroscopy and Reflection Absorption Infrared Spectroscopy (RAIRS).

The structure of oleamide (cis-9-octadecenamide) films on aluminum has been investigated by sum frequency generation vibrational spectroscopy (SFG) and reflection absorption infrared spectroscopy (RAIRS). Three different film deposition strategies were investigated: (i) films formed by equilibrium adsorption from oleamide solutions in oil, (ii) Langmuir-Blodgett films cast at 1 and 25 mN m(-1), (iii) thick spin-cast films. Both L-B and spin-cast films were examined in air and under oil. The adsorbate formed in the 1 mN m(-1) film in air showed little orientational order. For this film, the spectroscopic results and the ellipsometric thickness point to a relatively conformationally disordered monolayer that is oriented principally in the plane of the interface. Direct adsorption to the metal interface from oil results in SFG spectra of oleamide that are comparable to those observed for the 1 mN m(-1) L-B film in air. In contrast, SFG and RAIRS results for the 25 mN m(-1) film in air and SFG spectra of the spin-cast film in air both show strong conformational ordering and orientational alignment normal to the interface. The 25 mN m(-1) film has an ellipsometric thickness almost twice that of the 1 mN m(-1) L-B film. Taken in combination with the spectroscopic results, this is indicative of a well packed monolayer in air in which the hydrocarbon chain is in an essentially defect-free extended conformation with the methyl terminus oriented away from the surface. A similar structure is also deduced for the surface of the spin-cast film in air. Upon immersion of the 25 mN m(-1) L-B film in oil the SFG spectra show that this film rapidly adopts a relatively disordered structure similar to that seen for the 1 mN m(-1) L-B film in air. Immersion of the spin-cast film in oil results in the gradual disordering of the amide film over a period of several days until the observed spectra become essentially identical to those observed for direct adsorption of oleamide from oil.

Adsorption of sodium dodecyl sulfate at the hydrophobic solid/aqueous solution interface in the presence of poly(ethylene glycol): dependence upon polymer molecular weight.

The polar orientation and degree of conformational order of sodium dodecyl sulfate (SDS) adsorbed at the hydrophobic octadecanethiol/aqueous solution interface in the presence of poly(ethylene glycol) (PEG) has been investigated as a function of the surfactant concentration and the molecular weight of the polymer. Sum frequency generation (SFG) vibrational spectroscopy was employed to obtain spectra of interfacial surfactant; weak SFG signals from interfacial polymer were also detected for polymer molecular weights of 900 and above. The phase of the SFG spectra indicated that both the surfactant and polymer had a net orientation of their CH2 and/or CH3 groups toward the hydrophobic surface. Spectra of SDS in the presence of mixed polymer/surfactant solutions showed increasing conformational order as the surfactant concentration was raised. At the lowest surfactant concentrations, the spectra of SDS were weaker in the presence of the polymer than in its absence. All PEG molecular weights investigated, with the exception of PEG 400, gave rise to significant inhibition of ordered surfactant adsorption below the critical micelle concentration. The greatest inhibitory effect was noted for PEG 900. Probing interfacial PEG specifically through the use of perdeuterated SDS revealed that the polymer spectral intensity decreased monotonically as the surfactant concentration was increased for all polymer molecular weights where a PEG spectrum was apparent. These findings are interpreted in terms of the displacement of preadsorbed polymer as the surfactant concentration increases. This result is compatible with observations of adsorption from SDS/PEG solutions at solid/solution and solution/air interfaces made using other techniques.