Feasibility of a Heterogeneous Nanoscale Zero-Valent Iron Fenton-like Process for the Removal of Glyphosate from Water.

Glyphosate is a widely used herbicide, and it is an important environmental pollutant that can have adverse effects on human health. Therefore, remediation and reclamation of contaminated streams and aqueous environments polluted by glyphosate is currently a worldwide priority. Here, we show that the heterogeneous nZVI-Fenton process (nZVI + H2O2; nZVI: nanoscale zero-valent iron) can achieve the effective removal of glyphosate under different operational conditions. Removal of glyphosate can also take place in the presence of excess nZVI, without H2O2, but the high amount of nZVI needed to remove glyphosate from water matrices on its own would make the process very costly. Glyphosate removal via nZVI--Fenton was investigated in the pH range of 3-6, with different H2O2 concentrations and nZVI loadings. We observed significant removal of glyphosate at pH values of 3 and 4; however, due to a loss in efficiency of Fenton systems with increasing pH values, glyphosate removal was no longer effective at pH values of 5 or 6. Glyphosate removal also occurred at pH values of 3 and 4 in tap water, despite the occurrence of several potentially interfering inorganic ions. Relatively low reagent costs, a limited increase in water conductivity (mostly due to pH adjustments before and after treatment), and low iron leaching make nZVI-Fenton treatment at pH 4 a promising technique for eliminating glyphosate from environmental aqueous matrices.

Microwave-assisted extraction and gas chromatographic determination of thirty priority micropollutants in biowaste fraction derived from municipal solid waste for material recovery in the circular-economy approach.

European and national waste directives prioritize recycling of wastes, as well as material and energy recovery from wastes themselves. Bio-waste fraction can be converted into new resources whose quality is strictly dependent upon that of waste feedstock. Methods to evaluate the contamination from organic micropollutants in bio-waste are rarely investigated. The aim of this work was to develop an innovative analytical method for the extraction and quantification of 16 polycyclic aromatic hydrocarbons (PAHs) and 14 polychlorinated biphenyls (PCBs, including dioxin-like compounds) in bio-waste. Through a full-factorial experimental design, a microwave-assisted extraction technique was optimized to extract the thirty targeted micropollutants, studying the effect of cyclohexane and dichloromethane as extraction solvents with or without acetone, and of extraction temperature. Purification of the extract was obtained by a silica-based solid-phase extraction cartridge, followed by a sulfuric acid treatment. The analysis was carried out by gas chromatography coupled with mass spectrometry. The optimized method, validated directly in the bio-waste matrix fortified with isotopically marked surrogates, is characterized by good extraction recoveries, included within 47 and 106% (relative standard deviations <10%), by satisfactory intra-day (<1.1%) and inter-day (<9.3%) precision, and by low matrix effect (<17%), despite the complexity of the matrix. The optimized procedure, applied to the analysis of PAHs and PCBs in a bio-waste sample collected from a local anaerobic digestion and composting plant, showed a total PAHs content of 562 µg/kg. As regards PCBs, the dioxin-like congener PCB 118 was the only compound quantified (25 ± 6 µg kg-1).

A Review on the Degradation of Pollutants by Fenton-Like Systems Based on Zero-Valent Iron and Persulfate: Effects of Reduction Potentials, pH, and Anions Occurring in Waste Waters.

Among the advanced oxidation processes (AOPs), the Fenton reaction has attracted much attention in recent years for the treatment of water and wastewater. This review provides insight into a particular variant of the process, where soluble Fe(II) salts are replaced by zero-valent iron (ZVI), and hydrogen peroxide (H2O2) is replaced by persulfate (S2O82-). Heterogeneous Fenton with ZVI has the advantage of minimizing a major problem found with homogeneous Fenton. Indeed, the precipitation of Fe(III) at pH > 4 interferes with the recycling of Fe species and inhibits oxidation in homogeneous Fenton; in contrast, suspended ZVI as iron source is less sensitive to the increase of pH. Moreover, persulfate favors the production of sulfate radicals (SO4•-) that are more selective towards pollutant degradation, compared to the hydroxyl radicals (•OH) produced in classic, H2O2-based Fenton. Higher selectivity means that degradation of SO4•--reactive contaminants is less affected by interfering agents typically found in wastewater; however, the ability of SO4•- to oxidize H2O/OH- to •OH makes it difficult to obtain conditions where SO4•- is the only reactive species. Research results have shown that ZVI-Fenton with persulfate works best at acidic pH, but it is often possible to get reasonable degradation at pH values that are not too far from neutrality. Moreover, inorganic ions that are very common in water and wastewater (Cl-, HCO3-, CO32-, NO3-, NO2-) can sometimes inhibit degradation by scavenging SO4•- and/or •OH, but in other cases they even enhance the process. Therefore, ZVI-Fenton with persulfate might perform unexpectedly well in some saline waters, although the possible formation of harmful by-products upon oxidation of the anions cannot be ruled out.

Amino groups modified SBA-15 for dispersive-solid phase extraction in the analysis of micropollutants by QuEchERS approach.

In the analysis of contaminants in food products, sample preparation is performed by proper adsorbents, whose choice is crucial to eliminate matrix interference. In this work we modified SBA-15 adsorbents by functionalization with (3-aminopropyl)-triethoxysilane (SBA-15-APTES) and N-[3-(trimethoxysilyl)propyl]aniline (SBA-15-AN) aiming to use them for the first time in the clean-up step of a QuEChERS (quick, easy, cheap, effective, rugged and safe) extraction of micropollutants from strawberry, a sugar rich fruit. After physico-chemical characterization by nitrogen adsorption, infrared spectroscopy and thermogravimetric analysis, the adsorption capabilities of SBA-15 sorbents and possible interaction mechanisms were studied at different pH (2.1-8.5) for glucose, sucrose and fructose at concentrations characteristic of those found in strawberries. The performance of the two SBA-15 sorbents was compared with that of commercial PSA (primary secondary amine), usually proposed in QuEChERS protocols. Both SBA-15 materials exhibit up to 30% higher adsorption than PSA, suggesting their possible QuEChERS application. Synthesized SBA-15 adsorbents were hence used as innovative dispersive sorbents in the QuEChERS extractions of 13 PAHs and 14 PCBs from strawberry. For PCBs, SBA-15-AN provides better matrix removal than PSA and comparable extraction recoveries around 90%. For PAHs, the use of SBA-15-AN has the advantage of lower relative standard deviation (7%) than PSA (19%).

Extraction of Polycyclic Aromatic Hydrocarbons and Polychlorinated Biphenyls from Urban and Olive Mill Wastewaters Intended for Reuse in Agricultural Irrigation.

BACKGROUND: Domestic and industrial wastewater can be introduced in a reuse chain for irrigation purposes. OBJECTIVE: In this paper, we developed analytical procedures for the extraction of polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) along a wastewater reuse chain for irrigation purposes. Besides urban wastewaters, olive mill wastewater (OMWW) was considered as a potential water source. Wastewaters were purified by different treatments (urban wastewater plants, pilot-activated sludge, and constructed wetland) and used for the irrigation of olive trees. Suitable extraction procedures were used to analyze treated and untreated wastewaters, soils, and postirrigation leachates. RESULTS: For wastewater and leachate samples, the optimized reverse-phase solid-phase extraction (SPE) provided recoveries up to 79%. For OMWW, the SPE procedure was preceded by a normal-phase purification stage with silica gel for the removal of polyphenols, which were as high as 8.7 g/L. After optimization, extraction recoveries in blank solutions were in the range 20-67% and moderately reduced (10-38%) in OMWW as a result of the matrix effect (ME; -10/-60%) ascribed to the very high value of chemical oxygen demand (264 g/L). LODs of the method were below 1.1 µg/L (PAHs) and 3.2 µg/L (PCBs) using GC-MS analysis. For soil samples of different compositions, microwave-assisted extraction (MAE) provided better extraction recoveries and reproducibility than the more common quick, easy, cheap, effective, rugged, and safe approach, which was affected by a high ME. The LODs of the MAE/GC-MS method were below 4.9 µg/kg (PAHs) and 12.3 µg/kg (PCBs). CONCLUSIONS: The analytical procedures developed are a valuable tool to quantify the possible propagation of residual contamination from PAHs/PCBs with irrigation along the wastewater reuse chain.

Postpartum Bleeding in Pregnant Women Receiving SSRIs/SNRIs: New Insights From a Descriptive Observational Study and an Analysis of Data from the FAERS Database.

PURPOSE: To date, the available data on the relationship between the use of selective serotonin reuptake inhibitors (SSRIs) or the serotonin and norepinephrine reuptake inhibitor (SNRI) venlafaxine and postpartum hemorrhage (PPH) are conflicting and have not been extensively investigated, especially in terms of plasma drug concentrations. We performed data mining of antidepressant-induced PPH reported to the US Food and Drug Administration's Adverse Event Reporting System database, to assess the strength of the potential association between antidepressant pharmacotherapy and PPH in pregnant women. Concurrently, we carried out a descriptive observational population (pregnant women) analysis of the correlation between the plasma concentrations of SSRIs/SNRIs used during pregnancy and the extent of bleeding at delivery. METHODS: A disproportionality analysis of individual case study reports of PPH associated with SSRIs or venlafaxine in pregnant women was performed. Reporting odds ratio was used as a measure of disproportionality analysis. Pregnant women treated with an SSRI or SNRI (venlafaxine) for depressive or anxiety disorder and who consented to plasma drug concentration monitoring at the time of delivery were recruited. Plasma drug concentration assay was performed according to validated LC-MS/MS. Based on plasma drug concentrations, patients were classified into 1 of 2 groups, in therapeutic range or below therapeutic range for the drug administered, in accordance with the Arbeitsgemeinschaft für Neuropsychopharmakologie und Pharmakopsychiatrie guideline, and correlations with blood loss were identified, with PPH defined as a blood loss of >500 mL. FINDINGS: Only 43 Individual Case Safety Reports (ICSRs) reported at least one SSRIs or venlafaxine as suspect drug in 14 years (database analyses). Forty-three women were enrolled in the study population (observational study). In 24 patients (55.8%) the plasma drug concentration was below the therapeutic threshold. Unexpectedly, the mean blood loss in the below-range group was significantly higher than that in the in-range group. PPH occurred in 30% of women: in 9.3% and in 20.7% of patients in the in-range and below-range groups, respectively. IMPLICATIONS: Although preliminary, these data indicate a rather good tolerability profile of SSRIs/SNRIs regarding postpartum bleeding. Moreover, they suggest that keeping the plasma levels of SSRIs/SNRIs low as a precautionary measure does not reduce postpartum bleeding, which was higher in the below-range group. The findings from this study suggest that the use of therapeutic drug monitoring in pregnancy, a period in which multiple variables affect drug metabolism, may allow for better treatment customization, with subsequent advantages in terms of tolerability and efficacy of treatment.