An improved diagnostic method for taurodontism and a comparative study on its effectiveness evaluation.

OBJECTIVE: The two commonly used diagnostic methods for taurodontism are susceptible to aging changes, mastication wear and other factors. Therefore, this study proposed an improved diagnostic method for taurodontism, and compared it with the previous two methods as a supplement for taurodontism diagnosis. METHODS: The included patients were aged 10-89 years and admitted to the Department of Stomatology of Hebei Eye Hospital from June 1, 2022 to May 31, 2023. Eighty cone-beam computed tomography images were divided equally into 4 groups: 10-29, 30-49, 50-69, and 70-89 years old. The right mandibular first molars were selected as measurement objects. Firstly, |BD| and taurodontism index (TI)-related parameters were measured using Shifman and Chanannel's method and crown-body(CB) and root (R) lengths was measured by Seow and Lai's method. The improved method used the length from the cementoenamel junction(CEJ) to the root bifurcation point(body, B)and the root length(root, R)as the measurement objects. Finally, TI, CB/R ratios, and B/R ratios were calculated according to the formulas given below. One-way ANOVA analysis was mainly used to compare the differences in the values, indices and ratios of taurodontism among different age groups (p<0.05). RESULTS: With the increase of age, |BD| and TI values decreased significantly (p<0.01). The CB/R ratios of 70-89 years group were significantly lower than those of the other three groups (p<0.01). Ratios derived from the improved method were significantly lower in the 70-89 years than in 10-29 years group (p<0.05). CONCLUSIONS: The |BD| and TI parameters proposed by Shifman and channel are significantly influenced by age. The measurements of Seow and Lai (CB/R ratios) were less affected by age compared with those of the former. The improved method(B/R ratios) was least affected by age, which would reduce error and bias in the measurement of taurodontism and obtain more objective results in older patients.

Li+ mobility powered by a crystal compound for fast Li-S chemistry.

Placing blocking layers between electrodes has shown paramount prospects in suppressing the shuttle effect of Li-S batteries, but the associated ionic transport would be a concurrent obstacle. Herein, we present a Li-based crystal composited with carbon (LiPN2@C) by a one-step annealing of Li+ absorbed melamine polyphosphate, which simultaneously achieves alleviated polysulfide-shuttling and facilitated Li+ transport. As a homologous crystal, LiPN2 with abundant lithiophilic sites makes Li+ transport more efficient and sustainable. With a LiPN2@C-modified separator, the Li2S cathode exhibits a much-lower activation potential of 2.4 V and a high-rate capacity of 519 mA h g-1 at 2C. Impressively, the battery delivers a capacity of 726 mA h g-1 at 0.5C with a low decay rate of 0.25% per cycle during 100 continuous cycles.

Fast-Charging Sodium-Ion Batteries Enabled by Molecular-Level Designed Nitrogen and Phosphorus Codoped Mesoporous Soft Carbon.

Soft carbons have attracted extensive interests as competitive anodes for fast-charging sodium-ion batteries (SIBs); however, the high-rate performance is still restricted by their large ion migration barriers and sluggish reaction kinetics. Herein, we show a molecular design approach toward the fabrication of nitrogen and phosphorus codoped mesoporous soft carbon (NPSC). The key to this strategy lies in the chemical cross-linking reaction between polyphosphoric acid and p-phenylenediamine, associated with pyrolysis induced in-situ self-activation that creates mesoporous structures and rich heteroatoms within the carbon matrix. Thanks to the enlarged interlayer spacing, reduced ion diffusion length, and plentiful active sites, the obtained NPSC delivers a superb rate capacity of 215 mAh g-1 at 10 A g-1 and an ultralong cycle life of 4,700 cycles at 5 A g-1. Remarkably, the full cell shows 99% capacity retention during 100 continuous cycles, and maximum energy and power densities of 191 Wh kg-1 and 9.2 kW kg-1, respectively. We believe that such a synthetic protocol could pave a novel venue to develop soft carbons with unique properties for advanced SIBs.

Kinetically Controlled, Scalable Synthesis of γ-FeOOH Nanosheet Arrays on Nickel Foam toward Efficient Oxygen Evolution: The Key Role of In-Situ-Generated γ-NiOOH.

Layered γ-type iron oxyhydroxide (γ-FeOOH) is a promising material for various applications; however, its sheet-shaped structure often suffers from instability that results in aggregation and leads to inferior performance. Herein, a kinetically controlled hydrolysis strategy is proposed for the scalable synthesis of γ-FeOOH nanosheets arrays (NAs) with enhanced structural stability on diverse substrates at ambient conditions. The underlying mechanisms for the growth of γ-FeOOH NAs associated with their structural evolution are systematically elucidated by alkalinity-controlled synthesis and time-dependent experiments. As a proof-of-concept application, γ-FeOOH NAs are developed as electrocatalysts for the oxygen evolution reaction (OER), where the sample grown on nickel foam (NF) exhibits superior performance of high catalytic current density, small Tafel slope, and exceptional durability, which is among the top level of FeOOH-based electrocatalysts. Density functional theory calculations suggest that γ-NiOOH in situ generated from the electrooxidation of NF would induce charge accumulation on the Fe sites of γ-FeOOH NAs, leading to enhanced OER intermediates adsorption for water splitting. This work affords a new technique to rationally design and synthesize γ-FeOOH NAs for various applications.