Computer-Assisted Surgery Enables Beginner Surgeons, Under Expert Guidance, to Achieve Long-Term Clinical Results not Inferior to Those of a Skilled Surgeon in Knee Arthroplasty.

Purpose: The purpose of this study is to determine whether the use of a surgical navigation system in total knee replacement (TKR) enables beginner and intermediate surgeons to achieve clinical PROM outcomes as good as those conducted by expert surgeons in the long term. Methods: We enrolled 100 consecutive patients whose total navigated knee arthroplasty (TKA) was performed in our institution from 2008 to 2010. According to the principal surgeon's surgical experience, the patients were divided into three groups: (1) beginner surgeons, with no more than 30 previous knee replacement performances, (2) intermediate surgeons, with more than 30 but not more than 300, and (3) expert surgeons, with more than 300 knee replacements. Demographic data collected on the cohort included gender, laterality, age, and body mass index (BMI). The outcome measures assessed were Forgotten Joint Score (FJS), implant positioning, limb alignment, and prosthesis survival rate. A margin of equivalence of ± 18.5 points in the FJS scale was prespecified in terms of the minimal clinically important difference (MCID) to compare the FJS results obtained in the long period between the groups of interest. Results: The mean follow-up was 11.10 ± 0.78, 10.86 ± 0.66, and 11.30 ± 0.74 years, respectively, for each of the groups. The long-term FJS mean score was 80.86 ± 21.88, 81.36 ± 23.87, and 90.48 ± 14.65 for each group. The statistical analysis proved noninferiority and equivalence in terms of the FJS results reported in the long term by patients in Groups 1 or 2 compared to those in Group 3. More specifically, it has been proved that the mean difference between groups is within the interval of equivalence defined in terms of the MCID. The overall prostheses survival rate was 93.7%. Conclusion: Navigated assisted TKA, under expert guidance, can be as effective when performed by beginner or intermediate surgeons as performed by senior surgeons regarding the accuracy of implant positioning, limb alignment, and long-term clinical outcome.

Mechanical Alignment in Knee Replacement Homogenizes Postoperative Coronal Hip-Knee-Ankle Angle in Varus Knees: A Navigation-Based Study.

After knee replacement, postoperative lower limb alignment is influenced by the geometry of the prosthesis position and surrounding soft tissue that contributes to the hip-knee-ankle (HKA) angle. The purpose of this study is to determine the dynamic coronal HKA angle after mechanical alignment in total knee replacement using computer navigation. We conducted a pre-post design study of 71 patients with varus osteoarthritic knees on which total knee arthroplasty was performed. The HKA was measured before and at the end of the surgical procedure with the patient in the supine position using a navigation system at 30, 60, and 90 degrees of knee flexion. Postoperative implant position and flexion and extension gaps were assessed. HKA was clustered in three preoperative dynamic patterns (PDPs; Varus-Neutral, Varus-Valgus, and Varus-Varus). There were statistically significant differences in the dynamic coronal HKA between the preoperative and postoperative statuses after mechanically aligned knee replacement (with p < 0.0001) Before the surgical procedure, statistically significant differences were found between patterns at any angle of flexion confirming a well-differentiated preoperative dynamic behavior between the three groups. Postoperatively, 98.6% (71 out of 72) of the knees were within ± 3 degrees of the HKA at full extension. Fifty-eight knees (80.6%) were assessed to a "within-range" postoperative dynamic alignment at any grade of flexion considered. There are differences between the preoperative and postoperative status of the dynamic coronal HKA angle after mechanically aligned knee replacement. We proposed that an excellent dynamic HKA alignment is achieved not only at full extension within the range of 0 ± 3 degrees but also when this alignment is maintained at 30, 60, and 90 degrees.

Dynamic Alignment Analysis in the Osteoarthritic Knee Using Computer Navigation.

The lower limb alignment is influenced by the geometry of the joint surfaces and surrounding soft tissue tension. The mechanical behavior changes in a normal, osteoarthritic, and postoperative knee. The purpose of this study is to determine the dynamic coronal femoral tibial mechanical angle (FTMA) in osteoarthritic knees using computer navigation. The authors hypothesize that there are different varus-valgus patterns between flexion and extension in the osteoarthritic knee. We conducted a transversal observational study and included patients with osteoarthritis who underwent primary navigation TKA (Orthopilot version 4.2; B. Braun Aesculap, Tuttlingen, Germany). In total, 98 consecutive patients with 100 osteoarthritic knee joints, on which total knee arthroplasty was performed in our institution from 2009 to 2010, were enrolled in this prospective study. The FTMA was measured with the patient supine with maximum knee extension possible (considering the value as 0), 30, 60, and 90 degrees. All FMTA data obtained were segmented by hierarchic cluster measuring method. Through the clustering system, five segments were generated for varus patients and three for valgus patients: expected varus, expected valgus, severe varus, severe valgus, structured varus, structured valgus, concave varus, mixed varus-valgus, and mixed valgus-varus. The findings of the present study have demonstrated that there is a well-defined dynamic alignment in osteoarthritic knees, resulting in a wide kinematic variation in the coronal FTMA between flexion and full extension. Further studies will be necessary to determine whether this dynamic approach to FTMA has clinical utility in the surgeon's decision-making process.