Performing In Situ Closed-Cell Gas Reactions in the Transmission Electron Microscope.

Gas reactions studied by in situ electron microscopy can be used to capture the real-time morphological and microchemical transformations of materials at length scales down to the atomic level. In situ closed-cell gas reaction (CCGR) studies performed using (scanning) transmission electron microscopy (STEM) can separate and identify localized dynamic reactions, which are extremely challenging to capture using other characterization techniques. For these experiments, we used a CCGR holder that utilizes microelectromechanical systems (MEMS)-based heating microchips (hereafter referred to as "E-chips"). The experimental protocol described here details the method for performing in situ gas reactions in dry and wet gases in an aberration-corrected STEM. This method finds relevance in many different materials systems, such as catalysis and high-temperature oxidation of structural materials at atmospheric pressure and in the presence of various gases with or without water vapor. Here, several sample preparation methods are described for various material form factors. During the reaction, mass spectra obtained with a residual gas analyzer (RGA) system with and without water vapor further validates gas exposure conditions during reactions. Integrating an RGA with an in situ CCGR-STEM system can, therefore, provide critical insight to correlate gas composition with the dynamic surface evolution of materials during reactions. In situ/operando studies using this approach allow for detailed investigation of the fundamental reaction mechanisms and kinetics that occur at specific environmental conditions (time, temperature, gas, pressure), in real-time, and at high spatial resolution.

Dehydrogenative Coupling of Methanol for the Gas-Phase, One-Step Synthesis of Dimethoxymethane over Supported Copper Catalysts.

Oxymethylene dimethyl ethers (OMEs), CH3-(OCH2)n-OCH3, n = 1-5, possess attractive low-soot diesel fuel properties. Methanol is a key precursor in the production of OMEs, providing an opportunity to incorporate renewable carbon sources via gasification and methanol synthesis. The costly production of anhydrous formaldehyde in the typical process limits this option. In contrast, the direct production of OMEs via a dehydrogenative coupling (DHC) reaction, where formaldehyde is produced and consumed in a single reactor, may address this limitation. We report the gas-phase DHC reaction of methanol to dimethoxymethane (DMM), the simplest OME, with n = 1, over bifunctional metal-acid catalysts based on Cu. A Cu-zirconia-alumina (Cu/ZrAlO) catalyst achieved 40% of the DMM equilibrium-limited yield under remarkably mild conditions (200 °C, 1.7 atm). The performance of the Cu/ZrAlO catalyst was attributed to metallic Cu nanoparticles that enable dehydrogenation and a distribution of acid strengths on the ZrAlO support, which reduced the selectivity to dimethyl ether compared to a that obtained with a Cu/Al2O3 catalyst. The DMM formation rate of 6.1 h-1 compares favorably against well-studied oxidative DHC approaches over non-noble, mixed-metal oxide catalysts. The results reported here set the foundation for further development of the DHC route to OME production, rather than oxidative approaches.

Application of phase-pure nickel phosphide nanoparticles as cathode catalysts for hydrogen production in microbial electrolysis cells.

Transition metal phosphide catalysts such as nickel phosphide (Ni2P) have shown excellent activities for the hydrogen evolution reaction, but they have primarily been studied in strongly acidic or alkaline electrolytes. In microbial electrolysis cells (MECs), however, the electrolyte is usually a neutral pH to support the bacteria. Carbon-supported phase-pure Ni2P nanoparticle catalysts (Ni2P/C) were synthesized using solution-phase methods and their performance was compared to Pt/C and Ni/C catalysts in MECs. The Ni2P/C produced a similar quantity of hydrogen over a 24 h cycle (0.29 ±â€¯0.04 L-H2/L-reactor) as that obtained using Pt/C (0.32 ±â€¯0.03 L-H2/L) or Ni/C (0.29 ±â€¯0.02 L-H2/L). The mass normalized current density of the Ni2P/C was 14 times higher than that of the Ni/C, and the Ni2P/C exhibited stable performance over 11 days. Ni2P/C may therefore be a useful alternative to Pt/C or other Ni-based catalysts in MECs due to its chemical stability over time.

In situ spectroscopic detection of SMSI effect in a Ni/CeO2 system: hydrogen-induced burial and dig out of metallic nickel.

In situ APPES technique demonstrates that the strong metal support interaction effect (SMSI) in the Ni-ceria system is associated with the decoration and burial of metallic particles by the partially reduced support, a phenomenon reversible by evacuation at high temperature of the previously absorbed hydrogen.

Dendrimer templated synthesis of one nanometer Rh and Pt particles supported on mesoporous silica: catalytic activity for ethylene and pyrrole hydrogenation.

Monodisperse rhodium (Rh) and platinum (Pt) nanoparticles as small as approximately 1 nm were synthesized within a fourth generation polyaminoamide (PAMAM) dendrimer, a hyperbranched polymer, in aqueous solution and immobilized by depositing onto a high-surface-area SBA-15 mesoporous support. X-ray photoelectron spectroscopy indicated that the as-synthesized Rh and Pt nanoparticles were mostly oxidized. Catalytic activity of the SBA-15 supported Rh and Pt nanoparticles was studied with ethylene hydrogenation at 273 and 293 K in 10 torr of ethylene and 100 torr of H 2 after reduction (76 torr of H 2 mixed with 690 torr of He) at different temperatures. Catalysts were active without removing the dendrimer capping but reached their highest activity after hydrogen reduction at a moderate temperature (423 K). When treated at a higher temperature (473, 573, and 673 K) in hydrogen, catalytic activity decreased. By using the same treatment that led to maximum ethylene hydrogenation activity, catalytic activity was also evaluated for pyrrole hydrogenation.

Probing the interaction of poly(vinylpyrrolidone) with platinum nanocrystals by UV-Raman and FTIR.

The vibrational spectra of platinum nanoparticles (2.4-9 nm) capped with poly(N-vinylpyrrolidone) (PVP) were investigated by deep UV-Raman and FTIR spectroscopy and compared with those of pure PVP. Raman spectra of PVP/Pt show selective enhancement of C=O, C-N, and CH2 vibrational modes attributed to the pyrrolidone ring. Selective enhancement of ring vibrations is attributed both to the resonance Raman effect and SERS chemical enhancement. A red shift of the PVP carbonyl frequency on the order of 60 cm-1 indicates the formation of strong >C=O-Pt bonds. It is concluded that PVP adheres to the nanoparticles through a charge-transfer interaction between the pyrrolidone rings and surface Pt atoms. Heating the Pt nanoparticles under reducing conditions initiates the decomposition of the capping agent, PVP, at a temperature 100 degrees C below that of pure PVP. Under oxidizing conditions, both PVP/Pt and PVP degrade to form amorphous carbon.