CT Lesion Model-Based Structural Allografts: Custom Fabrication and Clinical Experience.

BACKGROUND: Patients requiring knee and hip revision arthroplasty often present with difficult anatomical situations that limit options for surgery. Customised mega-implants may be one of few remaining treatment options. However, extensive damage to residual bone stock may also be present, and in such cases even customised prosthetics may be difficult to implant. Small quantities of lost bone can be replaced with standard allografts or autologous bone. Larger defects may require structural macro-allografts, sometimes in combination with implants (allograft-prosthesis composites). METHODS: Herein, we describe a process for manufacturing lesion-specific large structural allografts according to a 3D, full-scale, lithographically generated defect model. These macro-allografts deliver the volume and the mechanical stability necessary for certain complex revisions. They are patient-and implant-matched, negate some requirements for additional implants and biomaterials and save time in the operating theatre by eliminating the requirement for intra-operative sizing and shaping of standard allografts. CONCLUSION: While a robust data set from long-term follow-up of patients receiving customised macro-allografts is not yet available, initial clinical experience and results suggest that lesion-matched macro-allografts can be an important component of revision joint surgery.

Sterilization and preservation influence the biophysical properties of human amnion grafts.

The introduction of amniotic membrane (AM) transplantation in ophthalmic surgery holds great promise and in many clinical situations it offers an alternative to existing management options. The purpose of this study was to examine the influence of established sterilization and preservation procedures on biophysical and histological properties of AM grafts. Amnion was sterilized by peracetic acid/ethanol sterilization [PES] and preserved by air-drying (sterile laminar flow) [AD] or in glycerol [GLYC]. Unsterilized AM were preserved at -80 degrees C [-80 degrees C] and served as an experimental control. Amnion allografts were characterized by the determination of their thickness, moisture vapour permeability (MVP), oxygen permeability (OPERM), tensile strength and sulphur content. Immunostaining for tissue-specific and basement membrane-related proteins was performed. Differences in biophysical parameters were found between the unsterilized allografts and the sterilized, air-dried or glycerol-preserved allografts. [PES/AD] showed the highest MVP and OPERM, the highest tensile strength and the lowest sulphur content and thickness. [PES/GLYC] exhibited the lowest OPERM and the highest thickness compared to [-80 degrees C] and [PES/AD]. Collagen types V and VII were preserved the best in the control group. Sterilization and preservation affect biophysical properties important for the use of AM as allogenic grafts. It has to be determined if any change, as noted, has a clinical impact.