Effect of Tungsten Inert Gas Remelting on Microstructure and Corrosion Resistance of Q450NQR1 High-Strength Weathering Steel-Welded Joints.

In this paper, the corrosion environment of a railway coal truck was simulated with 1.0%H2SO4 + 3%NaCl solution. The effect of weld toe Tungsten Inert Gas (TIG) remelting on the microstructure and corrosion resistance of welded joints of Q450NQR1 high-strength weathering steel was studied. The results show that the weld toe melts to form a remelting area after TIG remelting. After TIG remelting, the weld geometry was improved, and the stress concentration factor decreased from 1.17 to 1.06 at the weld toe, a decrease of 9.4%. TIG remelting refines the microstructure of the weld toe and improves the corrosion resistance of the welded joint. The surface of the TIG-remelted sample is uniformly corroded with no "deep and narrow" pits after the removal of corrosion products. The weight loss rate and corrosion rate of remelted welds are lower than those of unremelted welds. The structure of corrosion products is loose at the initial stage of corrosion, and the corrosion products are transformed into Fe3O4 and Fe2O3 protective rust layers with a dense structure after 480 h of corrosion. With the extension of corrosion time, the tensile strength and percentage elongation of the specimen decreased linearly. The decreasing rates of tensile strength of remelted and unremelted specimens were 0.09 and 0.11, respectively, and the decreasing rates of elongation after fracture were 0.0061 and 0.0076, respectively.

In-plane microvortices micromixer-based AC electrothermal for testing drug induced death of tumor cells.

Herein, we first describe a perfusion chip integrated with an AC electrothermal (ACET) micromixer to supply a uniform drug concentration to tumor cells. The in-plane fluid microvortices for mixing were generated by six pairs of reconstructed novel ACET asymmetric electrodes. To enhance the mixing efficiency, the novel ACET electrodes with rotating angles of 0°, 30°, and 60° were investigated. The asymmetric electrodes with a rotating angle of 60° exhibited the highest mixing efficiency by both simulated and experimental results. The length of the mixing area is 7 mm, and the mixing efficiency is 89.12% (approximate complete mixing) at a voltage of 3 V and a frequency of 500 kHz. The applicability of our micromixer with electrodes rotating at 60° was demonstrated by the drug (tamoxifen) test of human breast cancer cells (MCF-7) for five days, which implies that our ACET in-plane microvortices micromixer has great potential for the application of drug induced rapid death of tumor cells and mixing of biomaterials in organs-on-a-chip systems.