[Questionnaire Survey of Radiation Protection Education in Hospitals].

PURPOSE: The present study aimed to investigate the current situation of radiation protection education for designated radiation workers in hospitals. METHODS: A web-based questionnaire survey was conducted at 1,883 hospitals nationwide with 200 or more beds. RESULTS: Responses from 186 hospitals were included in the analysis. Seven hospitals (6.7%) regulated by the Act on the Regulation of Radioisotopes and six hospitals (7.4%) regulated by only the Ordinance on Prevention of Ionizing Radiation Hazards did not implement radiation protection education. In approximately 6% of the hospitals, designated radiation workers-including physicians, nurses, and radiological technologist-did not attend the education program. The education program attendance rate of physicians was lower than that of nurses. In more than 90% of the hospitals, the frequency of the periodical education program was once every year and lecture time spanned one or less than one hour. The topics of lecture in more than 90% of the hospitals were health effects of radiation and methods of radiation protection for occupational exposure. The radiological technologist was the instructor of the education program in approximately 70% of the hospitals. CONCLUSION: The implementation of radiation protection for designated radiation workers varied from hospital to hospital, and some hospitals did not comply with laws and regulations. Effective and efficient radiation protection education models should be implemented in hospitals.

[Effect of Gantry Speed on Image Quality of Four-dimensional Cone-beam Computed Tomography Using a Dynamic Phantom of Lung].

PURPOSE: The purpose of this paper was to determine the optimal imaging conditions for four-dimensional cone-beam computed tomography (4D-CBCT) using an X-ray tube and a flat-panel detector mounted on a radiotherapy device. METHODS: The optimal imaging conditions were examined by changing the gantry speed (GS) parameter that affected the exposure time. Exposed dose during imaging and image quality of moving phantom were compared between examined conditions. RESULTS: The weighted computed tomography dose index (CTDIW) decreased linearly with increasing GS. However, when GS was 180°/min or faster, the image quality degraded, and errors of 1 mm or more were observed regarding the size of mock tumor in the moving phantom. The accuracy of automatic image matching was within 0.1 mm when GS of 120°/min or slower was chosen. CONCLUSION: From the results of this study, we concluded that GS of 120°/min is the optimum imaging condition. Under this imaging condition, the exposure time and CTDIW can be reduced by about 50% without compromising the accuracy of image registration, compared to the conventional GS of 70°/min. In addition, it has been clarified that there is an event that image reconstruction is not performed correctly due to the influence of phantom artifacts without depending on GS.

Clinical Experience of Dual-phase Cone Beam Computed Tomography during Hepatic Arteriography to Apply 3D-DSA.

We report on the methods and experiences of the dual-phase cone beam computed tomography during hepatic arteriography (CBCTHA) to apply the 3D-DSA. A total of 32 ml contrast medium (150 mgI/ml) was injected at the rate of 2.0 ml/s for 16 s. The early phase scan was initiated 10 s after the start of contrast media injection. The delayed phase scan was started 40 s after that (24 s after the end of CM injection). When using the dual phase CBCTHA, it was able to obtain the classical hepatocellular carcinoma (HCC) images same as computed tomography during hepatic arteriography (CTHA). In the early phase, the tumor can be highly enhanced against the liver parenchyma. In delayed phase, corona enhancement was clearly appeared at the liver parenchyma. Of 58 cases of acquisitions, we experienced six cases with miss breath holding and 14 cases with over the field of view (FOV) due to hepatomegaly. We evaluated the tumor contrast in 18 cases because the other 40 cases were not applied to our criteria. The pixel values of ROIs on the tumor, coronal enhancement, and liver parenchyma were measured, respectively. Then, we calculated tumor-parenchyma contrast (T-P contrast), corona-tumor contrast (C-T contrast), and corona-parenchyma contrast (C-P contrast). The T-P contrast was 358±112, the C-T contrast was 132±51, and the C-P contrast was 168±66. The contrast was clearly visualized among them. The dual-phase CBCTHA that applies the 3D-DSA is a simple and useful technique for hepatocellular carcinoma treatment.

Understanding the Scatter Radiation Distribution during C-arm CT Examination: A Body Phantom Study.

The purpose of this study was to understand the scatter radiation distribution during C-arm CT examination in the interventional radiography (IVR) room to show the escaped area and the radiation protective method. The C-arm rotates 200° in 5 s. The tube voltage was 90 kV, and the entrance dose to the detector was 0.36 µGy/frame during C-arm CT examination. The scattered doses were measured each 50 cm from the isocenter like a grid pattern. The heights of the measurement were 50, 100, and 150 cm from the floor. The maximum scattered doses were 38.23±0.60 µGy at 50 cm, 43.86±0.20 µGy at 100 cm, and 25.78±0.37 µGy at 150 cm. The scatter radiation distribution at 100 cm was the highest scattered dose. The operator should protect their reproductive gland, thyroid, and lens. The scattered dose was low behind the C-arm body and the bed, so they will be able to become the escaped area for staff.

[Electronic portal image device dosimetry for volumetric modulated arc therapy].

Recently electronic portal image devices (EPIDs) have been widely used for quality assurance and dose verification. However there are no reports describing EPID dosimetry for Elekta volumetric modulated arc therapy (VMAT). We have investigated EPID dosimetry during VMAT delivery using a commercial software EPIDose with an Elekta Synergy linac. Dose rate dependence and the linac system sag during gantry rotation were measured. Gamma indices were calculated between measured doses using an EPID and calculation made by a treatment planning system for prostate VMAT test plans. The results were also compared to gamma indices using films and a two-dimensional detector array, MapCHECK2. The pass rates of the gamma analysis with a criterion of 3% and 2 mm for the three methods were over 96% with good consistency. Our results have showed that EPID dosimetry is feasible for Elekta VMAT.

Minimum requirements for commissioning and long-term quality assurance of Elekta multi-leaf collimator for volumetric modulated arc therapy.

We have proposed minimum requirements for commissioning and long-term quality assurance (QA) of an Elekta multi-leaf collimator (MLC) for volumetric modulated arc therapy (VMAT). The MLC leaf position accuracy during VMAT delivery was evaluated with the use of three different QA test plans: (1) a leaf gap-width test between opposing leaves by measurement of the isocenter dose during constant-gap sliding-window delivery with varied dose rates, MLC leaf speeds, and gantry angles; (2) a leaf position test by picket-fence delivery with and without gantry rotation; and (3) a leaf-bank symmetry test by measurement of the field geometry with different collimator angles at a fixed gantry position. All the QA test plans were created using an ERGO++ treatment-planning system. The leaf gap-width deviation was within 0.2 mm, the leaf position deviation was within 0.5 mm, and the leaf-bank symmetry error was within 0.5 mm under all the test conditions. MLC leaf position accuracy and long-term stability were confirmed by the proposed procedures.

[Positional accuracy and quality assurance of Backup JAWs required for volumetric modulated arc therapy].

The tolerance of the Backup diaphragm (Backup JAW) setting in Elekta linac was specified as 2 mm according to the AAPM TG-142 report. However, the tolerance and the quality assurance procedure for volumetric modulated arc therapy (VMAT) was not provided. This paper describes positional accuracy and quality assurance procedure of the Backup JAWs required for VMAT. It was found that a gap-width error of the Backup JAW by a sliding window test needed to be less than 1.5 mm for prostate VMAT delivery. It was also confirmed that the gap-widths had been maintained with an error of 0.2 mm during the past one year.

[Quality assurance procedure for assessing mechanical accuracy of a radiation field center in stereotactic radiotherapy].

Stereotactic radiotherapy requires a quality assurance (QA) program that ensures the mechanical accuracy of a radiation field center. We have proposed a QA method for achieving the above requirement by conducting the Winston Lutz test using an electronic portal image device (EPID). An action limit was defined as three times the standard deviation. Then, the action limits for mean deviations of the radiation field center during collimator rotation, gantry rotation, and couch rotation in clockwise and counterclockwise resulted in 0.11 mm, 0.52 mm, 0.37 mm, and 0.41 mm respectively. Two years after the QA program was launched, the mean deviation of the radiation field center during gantry rotation exceeded the above action limit. Consequently, a mechanical adjustment for the gantry was performed, thereby restoring the accuracy of the radiation field center. A field center shift of 0.5 mm was also observed after a micro multi-leaf collimator was unmounted.

[Mechanical accuracy of a stereotactic irradiation system using a micro multi-leaf collimator].

Mechanical accuracy of a stereotactic irradiation system using a micro multi-leaf collimator (mMLC), Elekta DMLC, has been evaluated. Measurements were made to obtain transmission, leakage, penumbra, and positioning accuracy of the DMLC leaf for a 6 MV photon beam. Mechanical accuracy and long term stability of a linac isocenter was also evaluated. The resulting transmission, along a line perpendicular to the leaf movement, was 0.31±0.01%, and the leakage from the closed opposing leaf pairs was 0.39±0.01%. The measured penumbra, at a depth incurring maximum dose, was 2.37±0.16 mm toward the leaf end and 2.14±0.18 mm toward the leaf side for various field sizes. The leaf gap width error, of 0.10±0.08 mm, was obtained by analyzing picket fence test results. The maximum leaf positioning error, of 0.14±0.06 mm, was obtained by analyzing the log file for a various gantry angles during an arc delivery. The isocenter accuracy was within a radius of 1 mm, without any recalibration for two years. In conclusion, our stereotactic irradiation system using DMLC was capable of providing accurate stereotactic treatment.