Radio-frequency exposure of the yellow fever mosquito (A. aegypti) from 2 to 240 GHz.

Fifth generation networks (5G) will be associated with a partial shift to higher carrier frequencies, including wavelengths comparable in size to insects. This may lead to higher absorption of radio frequency (RF) electromagnetic fields (EMF) by insects and could cause dielectric heating. The yellow fever mosquito (Aedes aegypti), a vector for diseases such as yellow and dengue fever, favors warm climates. Being exposed to higher frequency RF EMFs causing possible dielectric heating, could have an influence on behavior, physiology and morphology, and could be a possible factor for introduction of the species in regions where the yellow fever mosquito normally does not appear. In this study, the influence of far field RF exposure on A. aegypti was examined between 2 and 240 GHz. Using Finite Difference Time Domain (FDTD) simulations, the distribution of the electric field in and around the insect and the absorbed RF power were found for six different mosquito models (three male, three female). The 3D models were created from micro-CT scans of real mosquitoes. The dielectric properties used in the simulation were measured from a mixture of homogenized A. aegypti. For a given incident RF power, the absorption increases with increasing frequency between 2 and 90 GHz with a maximum between 90 and 240 GHz. The absorption was maximal in the region where the wavelength matches the size of the mosquito. For a same incident field strength, the power absorption by the mosquito is 16 times higher at 60 GHz than at 6 GHz. The higher absorption of RF power by future technologies can result in dielectric heating and potentially influence the biology of this mosquito.

Airway morphometry in COPD with bronchiectasis: a view on all airway generations.

The pathophysiological processes underlying bronchiectasis in chronic obstructive pulmonary disease (COPD) are not understood. In COPD, both small and large airways are progressively lost. It is currently not known to what extent the different airway generations of patients with COPD and bronchiectasis are involved.COPD explant lungs with bronchiectasis were compared to COPD explant lungs without bronchiectasis and unused donor lungs as controls. In order to investigate all airway generations, a multimodal imaging approach using different resolutions was conducted. Per group, five lungs were frozen (n=15) and underwent computed tomography (CT) imaging for large airway evaluation, with four tissue cores per lung imaged for measurements of the terminal bronchioles. Two additional lungs per group (n=6) were air-dried for lobar microCT images that allow airway segmentation and three-dimensional quantification of the complete airway tree.COPD lungs with bronchiectasis had significantly more airways compared to COPD lungs without bronchiectasis (p<0.001), with large airway numbers similar to control lungs. This difference was present in both upper and lower lobes. Lack of tapering was present (p=0.010) and larger diameters were demonstrated in lower lobes with bronchiectasis (p=0.010). MicroCT analysis of tissue cores showed similar reductions of tissue percentage, surface density and number of terminal bronchioles in both COPD groups compared to control lungs.Although terminal bronchioles were equally reduced in COPD lungs with and without bronchiectasis, significantly more large and small airways were found in COPD lungs with bronchiectasis.

In-Situ High Resolution Dynamic X-ray Microtomographic Imaging of Olive Oil Removal in Kitchen Sponges by Squeezing and Rinsing.

Recent advances in high resolution X-ray tomography (µCT) technology have enabled in-situ dynamic µCT imaging (4D-µCT) of time-dependent processes inside 3D structures, non-destructively and non-invasively. This paper illustrates the application of 4D-µCT for visualizing the removal of fatty liquids from kitchen sponges made of polyurethane after rinsing (absorption), squeezing (desorption) and cleaning (adding detergents). For the first time, time-dependent imaging of this type of system was established with sufficiently large contrast gradient between water (with/without detergent) and olive oil (model fat) by the application of suitable fat-sensitive X-ray contrast agents. Thus, contrasted olive oil filled sponges were rinsed and squeezed in a unique laboratory loading device with a fluid flow channel designed to fit inside a rotating gantry-based X-ray µCT system. Results suggest the use of brominated vegetable oil as a preferred contrast agent over magnetite powder for enhancing the attenuation coefficient of olive oil in a multi fluid filled kitchen sponge. The contrast agent (brominated vegetable oil) and olive oil were mixed and subsequently added on to the sponge. There was no disintegration seen in the mixture of contrast agent and olive oil during the cleaning process by detergents. The application of contrast agents also helped in accurately tracking the movement and volume changes of soils in compressed open cell structures. With the in house-built cleaning device, it was quantified that almost 99% of cleaning was possible for contrasted olive oil (brominated vegetable oil with olive oil) dispersed in the sponge. This novel approach allowed for realistic mimicking of the cleaning process and provided closer evaluation of the effectiveness of cleaning by detergents to minimize bacterial growth.