Elevated Wall Shear Stress in Aortic Type B Dissection May Relate to Retrograde Aortic Type A Dissection: A Computational Fluid Dynamics Pilot Study.

OBJECTIVE: Retrograde aortic type A dissection (RTAD) is a known complication in patients with aortic type B dissection. The purpose of this computational fluid dynamics (CFD) study was to identify haemodynamic risk factors for the occurrence of RTAD. METHODS: Computed tomographic angiography (CTA) images of 10 patients with type B dissections, who subsequently developed a RTAD, were retrospectively analysed together with patients constituting a control group (n = 10) where no further vascular events after the initial type B dissection occurred. CFD simulations were conducted based on 3D surface models of the aortic lumen derived from CTA datasets. For both groups, pressures, velocity magnitudes and wall shear stress (WSS) were compared at the site of the future RTAD entry tear and the surrounding aortic wall. RESULTS: WSS at the site of the future entry tear was significantly elevated compared with the surrounding wall (15.10 Pa vs. 5.15 Pa, p < .001) and was significantly higher in the RTAD group than in the control group (6.05 Pa, p < .002). Pressures and velocity magnitudes were not significantly elevated at the entry tear (3825.8 Pa, 0.63 m/s) compared with the aortic arch (3549.8 Pa, 0.50 m/s) or control group (3501.7 Pa, 0.62 m/s). CONCLUSIONS: Increased WSS accompanies the occurrence of RTAD. The results merit the design for a prospective study to confirm whether WSS is a risk factor for the occurrence of RTAD.

[Pre- and postoperative imaging of type B aortic dissection]. / Imagerie de la dissection aortique de type B : ce que veut savoir le chirurgien avant et après l'intervention.

Type B aortic dissections are serious diseases with a 60 to 80 % 5-year survival rate. Although typically managed with a medical treatment, surgery may be necessary in the acute/subacute or the chronic phase if significant complications are encountered. For these patients, CT angiography is the first-line imaging modality, used for indicating and preparing the surgical procedure as well as for follow-up. Physicians in charge of these patients should be familiar with the key reading points. Visceral malperfusion is the most common acute complication, while aneurysmal dilatation of the false lumen is the most common chronic complication, with surgical management generally indicated when the axial diameter of the aorta exceeds 55mm. Endovascular treatment tends to replace open surgery: it requires precise measurements and identification of the entry tear (contribution of 4D-MRA).

Quantitative comparison of hemodynamic parameters from steady and transient CFD simulations in cerebral aneurysms with focus on the aneurysm ostium.

OBJECTIVE: To quantitatively compare hemodynamics simulated with steady-state and transient computational fluid dynamics (CFD) simulations in cerebral aneurysms with single inflow, with focus at the aneurysm ostium. METHODS: Transient and steady-state CFD simulations were performed in 10 cerebral aneurysms. Distributions and average values for pressure, helicity, vorticity, and velocity were qualitatively compared at proximal and distal parent artery locations, at the ostium plane, and in the aneurysm, and scaling factors between the two kinds of simulations were determined. Relative inflow and outflow areas at the ostium were compared, as were average inflow and outflow velocities. In addition, values for the pressure-loss coefficient (PLC), a recently introduced parameter to assess aneurysm rupture risk, were compared for both kinds of simulation. RESULTS: Distributions of hemodynamic parameters had a similar shape but were lower for transient than for steady-state simulations. Averaged scaling factors over cases and anatomical locations showed differences for hemodynamic parameters (0.485 ± 0.01 for pressure, 0.33 ± 0.02 for helicity, 0.58 ± 0.06 for vorticity and 0.56 ± 0.04 for velocity). Good agreement between ratios of inflow and outflow areas at the aneurysm ostium was obtained (Pearson correlation coefficient >0.97, p<0.001) and for the PLC (linear regression slope 0.73 ± 0.14, R(2)=0.75). CONCLUSIONS: Steady-state simulations are a quick alternative to transient simulation for visualizing and quantifying inflow and outflow areas at the aneurysm ostium, potentially of value when planning flow diverter treatment and for quantifying the PLC, a potential indicator of aneurysm rupture.

Computational study of haemodynamic effects of entry- and exit-tear coverage in a DeBakey type III aortic dissection: technical report.

OBJECTIVES: Outcome prediction in DeBakey Type III aortic dissections (ADs) remains challenging. Large variations in AD morphology, physiology and treatment exist. Here, we investigate if computational fluid dynamics (CFD) can provide an initial understanding of pressure changes in an AD computational model when covering entry and exit tears and removing the intra-arterial septum (IS). DESIGN: A computational mesh was constructed from magnetic resonance images from one patient (one entrance and one exit tear) and CFD simulations performed (scenario #1). Additional meshes were derived by virtually (1) covering the exit tear (false lumen (FL) thrombus progression) (scenario #2), (2) covering the entrance tear (thoracic endovascular treatment, TEVAR) (scenario #3) and (3) completely removing the IS (fenestration) (scenario #4). Changes in flow patterns and pressures were quantified relative to the initial mesh. RESULTS: Systolic pressures increased for #2 (300 Pa increase) with largest inter-luminal differences distally (2500 Pa). In #3, false lumen pressure decreased essentially to zero. In #4, systolic pressure in combined lumen reduced from 2400 to 800 Pa. CONCLUSIONS: CFD results from computational models of a DeBakey type III AD representing separate coverage of entrance and exit tears correlated with clinical experience. The reported results present a preliminary look at a complex clinical problem.