Water Sorption and Structural Properties of Human Airway Mucus in Health and Muco-Obstructive Diseases.

Muco-obstructive diseases change airway mucus properties, impairing mucociliary transport and increasing the likelihood of infections. To investigate the sorption properties and nanostructures of mucus in health and disease, we investigated mucus samples from patients and cell cultures (cc) from healthy, chronic obstructive pulmonary disease (COPD), and cystic fibrosis (CF) airways. Atomic force microscopy (AFM) revealed mucin monomers with typical barbell structures, where the globule to spacer volume ratio was the highest for CF mucin. Accordingly, synchrotron small-angle X-ray scattering (SAXS) revealed more pronounced scattering from CF mucin globules and suggested shorter carbohydrate side chains in CF mucin and longer side chains in COPD mucin. Quartz crystal microbalance with dissipation (QCM-D) analysis presented water sorption isotherms of the three types of human airway mucus, where, at high relative humidity, COPD mucus had the highest water content compared to cc-CF and healthy airway mucus (HAM). The higher hydration of the COPD mucus is consistent with the observation of longer side chains of the COPD mucins. At low humidity, no dehydration-induced glass transition was observed in healthy and diseased mucus, suggesting mucus remained in a rubbery state. However, in dialyzed cc-HAM, a sorption-desorption hysteresis (typically observed in the glassy state) appeared, suggesting that small molecules present in mucus suppress the glass transition.

Effects of ethylene oxide chain length on crystallization of polysorbate 80 and its related compounds.

As a result of the synthesis protocol polyoxyethylene sorbitan monooleate (polysorbate 80, PS80) is a highly complex mixture of compounds. PS80 was therefore separated into its main constituents, e.g. polyoxyethylene isosorbide esters and polyoxyethylene esters, as well as mono- di- and polyesters using preparative high-performance liquid chromatography. In this comprehensive study the individual components and their ethoxylation level were verified by matrix assisted laser desorption/ionization time-of-flight and their thermotropic behavior was analyzed using differential scanning calorimetry and X-ray diffraction. A distinct correlation was found between the average length of the ethylene oxide (EO) chains in the headgroup and the individual compounds' ability to crystallize. Importantly, a critical number of EO units required for crystallization of the headgroup was determined (6 EO units per chain or 24 per molecule). The investigation also revealed that the hydrocarbon tails only crystallize for polyoxyethylene sorbitan esters if saturated. PS80 is synthesized by reacting with approximately 20 mol of EO per mole of sorbitol, however, the number of EO units in the sorbitan ester in commercial PS80 products is higher than the expected 20 (5 EO units per chain). The complex behavior of all tested compounds revealed that if the amount of several of the linear by-products is reduced, the number of EO units in the chains will stay below the critical number and the product will not be able to crystallize by the EO chains.

Interactions of Perfluorohexyloctane With Polyethylene and Polypropylene Pharmaceutical Packaging Materials.

Semifluorinated alkanes (SFAs) are aprotic solvents, which may be used as drug solvents for topical ocular applications, for instance, in dry eye syndrome. Their physical properties suggest that they might be prone to interaction with plastic materials, such as, polyethylene (PE) and polypropylene (PP), which are commonly used as packaging materials for pharmaceutical products. In this study, we investigate interactions of PE and PP with a liquid SFA perfluorohexyloctane (PFHO) using differential scanning calorimetry (DSC), thermogravimetric analysis (TGA) and cross-polarized light microscopy. Binary phase diagrams of PFHO-PE and PFHO-PP systems demonstrating interactions of PFHO with the polymeric materials were constructed based on DSC data. According to this data, PFHO tends to lower the melting temperatures of PE and PP. The equilibrium values of solubilities of the polymers in PFHO and PFHO in the polymers were obtained by extrapolation of melting enthalpy data. Absorption of PFHO by PE and PP materials at ambient conditions after 4 weeks of equilibration was also studied by TGA. From the presented results, it may be concluded that thorough studies of interactions of PE or PP with SFAs are required when these materials are used as packaging components in SFA-based formulations.