Remediation of zinc-contaminated groundwater by iron oxide in situ adsorption barriers - From lab to the field.

Heavy metals such as zinc cannot be degraded by microorganisms and form long contaminant plumes in groundwater. Conventional methods for remediating heavy metal-contaminated sites are for example excavation and pump-and-treat, which is expensive and requires very long operation times. This induced interest in new technologies such as in situ adsorption barriers for immobilization of heavy metal contamination. In this study, we present steps and criteria from laboratory tests to field studies, which are necessary for a successful implementation of an in situ adsorption barrier for immobilizing zinc. Groundwater and sediment samples from a contaminated site were brought to the lab, where the adsorption of zinc to Goethite nanoparticles was studied in batch and in flow-through systems mimicking field conditions. The Goethite nanoparticles revealed an in situ adsorption capacity of approximately 23 mg Zn per g Goethite. Transport experiments in sediment columns indicated an expected radius of influence of at least 2.8 m for the injection of Goethite nanoparticles. These findings were validated in a pilot-scale field study, where an in situ adsorption barrier of ca. 11 m × 6 m × 4 m was implemented in a zinc-contaminated aquifer. The injected nanoparticles were irreversibly deposited at the desired location within <24 h, and were not dislocated with the groundwater flow. Despite a constantly increasing inflow of zinc to the barrier and the short contact time between Goethite and zinc in the barrier, the dissolved zinc was effectively immobilized for ca. 90 days. Then, the zinc concentrations increased slowly downstream of the barrier, but the barrier still retained most of the zinc from the inflowing groundwater. The study demonstrated the applicability of Goethite nanoparticles to immobilize heavy metals in situ and highlights the criteria for upscaling laboratory-based determinants to field-scale.

Field-scale demonstration of in situ immobilization of heavy metals by injecting iron oxide nanoparticle adsorption barriers in groundwater.

Remediation of heavy metal-contaminated aquifers is a challenging process because they cannot be degraded by microorganisms. Together with the usually limited effectiveness of technologies applied today for treatment of heavy metal contaminated groundwater, this creates a need for new remediation technologies. We therefore developed a new treatment, in which permeable adsorption barriers are established in situ in aquifers by the injection of colloidal iron oxides. These adsorption barriers aim at the immobilization of heavy metals in aquifers groundwater, which was assessed in a large-scale field study in a brownfield site. Colloidal iron oxide (goethite) nanoparticles were used to install an in situ adsorption barrier in a very heterogeneous, contaminated aquifer of a brownfield in Asturias, Spain. The groundwater contained high concentrations of heavy metals with up to 25 mg/L zinc, 1.3 mg/L lead, 40 mg/L copper, 0.1 mg/L nickel and other minor heavy metal pollutants below 1 mg/L. High amounts of zinc (>900 mg/kg), lead (>2000 mg/kg), nickel (>190 mg/kg) were also present in the sediment. Ca. 1500 kg of goethite nanoparticles of 461 ± 266 nm diameter were injected at low pressure (< 0.6 bar) into the aquifer through nine screened injection wells. For each injection well, a radius of influence of at least 2.5 m was achieved within 8 h, creating an in situ barrier of 22 × 3 × 9 m. Despite the extremely high heavy metal contamination and the strong heterogeneity of the aquifer, successful immobilization of contaminants was observed in the tested area. The contaminant concentrations were strongly reduced immediately after the injection and the abatement of the heavy metals continued for a total post-injection monitoring period of 189 days. The iron oxide particles were found to adsorb heavy metals even at pH-values between 4 and 6, where low adsorption would have been expected. The study demonstrated the applicability of iron oxide nanoparticles for installing adsorption barriers for containment of heavy metals in contaminated groundwater under real conditions.