A Three-Dimensional Study of the Nasolabial Soft Tissue Symmetry in Children With Unilateral Complete Cleft Lip and Palate Using Traditional and Split-Type Nasoalveolar Molding.

BACKGROUND: Presurgical nasoalveolar molding (NAM) is the most common preoperative treatment for cleft lip and palate. However, NAM may have some limitations such as requiring high technical sensitivity and frequent visits. To simplify the device, some scholars have changed the traditional NAM into a split-NAM consisting of a alveolar molding plate and a nasal hook. This study compared the shaping effect of split NAM and traditional NAM on nasolabial soft tissue using three-dimensional (3D) measurement. METHODS: A total of 39 patients with unilateral cleft lip and palate (UCLP) were enrolled and divided into 2 groups. 13 patients were treated with split-NAM while the other 26 patients were treated with traditional NAM. 3D images of all patients' craniofacial soft tissue before and after NAM treatment were recorded and measured by three-dimensional software. Statistical analysis of measurements in both groups was performed using SPSS software. RESULTS: After treatment, nasal soft tissue symmetry in the split-NAM group was better improved than that in the NAM group in vertical and anterior-posterior direction, but was worse improved in transverse direction. There was no significant difference in labial soft tissue symmetry between two groups. CONCLUSIONS: The split NAM can better elevate the alar and nostrils of the cleft side, and have a better forward effect on alar outer edge, nasal base, and nostrils. However, the traditional NAM can better reduce the width of nasal base.

Novel Three-Dimensional Coordinate System to Analyze Alveolar Molding Effects of Pre-Surgical Nasoalveolar Molding on Infants With Non-Syndromic Unilateral Cleft Lip and Palate.

The aim of this study is to establish a stable 3-dimensional (3D) coordinate system for investigating the alveolar molding effects of pre-surgical nasoalveolar molding (PNAM) on non-syndromic unilateral cleft lip and palate (UCLP) patients, basing on the Frankfort Horizontal (FH) plane.Twenty-one non-syndromic UCLP neonates who sought medical advice in the department of Orthodontics, from 2016.5 to 2017.10 were enrolled in the present study. All neonates were subjected to PNAM before the cleft lip repair. The treatment duration was 75.76 days. Silicone rubber models were obtained and scanned using a 3D laser scanner pre- and post-PNAM treatment. A 3D coordinate system based on the FH reference plane was built utilizing Rhino3D software to record the landmark 3D coordinates, to measure the distance, angle, and length variables. The Paired Student's t test and the Pearson correlation coefficient were used to calculate reproducibility and reliability of the landmark localization for repeated measurements. Changes of the measurement variables were analyzed by the Paired Student's t test.This study revealed a high reproducibility and reliability for most of the landmarks. By the end of PNAM treatment, the cleft gap was reduced with the malformation of alveolar segments aligned normally and the anterior points of both alveolar segments were rotated to the cleft side.Utilizing the FH plane to set up a rigorous and stable 3D system is meaningful. PNAM therapy is effective in reducing the severity of the maxillary deformity not only on the non-cleft side, but also on the cleft side.

Presurgical nasoalveolar molding with 3D printing for a patient with unilateral cleft lip, alveolus, and palate.

An 8-day-old male infant with unilateral cleft lip, alveolus, and palate had a wide alveolar defect, soft tissue deformity, and a markedly sunken nasal wing at the cleft side. The patient was treated with a series of 3D-printed molding plates and synchronously with a nasal hook. The cleft edges moved closer by 9 mm at the alveolar ridge and the nasal wing was lifted considerably. Split-type 3D printing of presurgical nasoalveolar molding helped to reduce the cleft gap, improve the arch form, approximate lip segments, and distinctly improve the morphology of the nose by correcting the flattened nasal wings.

Receptor activator of nuclear factor-kappa ligand, OPG, and IGF-I expression during orthodontically induced inflammatory root resorption in the recombinant human growth hormone-treated rats.

OBJECTIVE: To investigate the effects of growth hormone (GH) on local receptor activator of nuclear factor-kappa ligand (RANKL), OPG, and IGF-I expression during orthodontically induced inflammatory root resorption in rats. MATERIALS AND METHODS: Forty Wistar rats (gender: male; age: 7 weeks) were randomly divided into control and experimental groups. A force of 50 g was applied to move the right upper first molars mesially. The experimental and control groups received daily subcutaneous injections of recombinant human growth hormone (GH; 2 mg/kg) and equivalent volumes of saline, respectively. The rats were sacrificed on days 1, 3, 7, and 14. Micro-computed tomography-reconstructed images of the upper right first molars were used to survey root resorption and tooth movement. Horizontal sections of the maxillae were prepared for hematoxylin and eosin, tartrate-resistant acid phosphatase, and immunohistochemical staining. RESULTS: Resorption lacunae appeared on the compressed side of the distal buccal root of the right first molar on days 7 and 14. Compared with the control groups, GH-treated groups showed more RANKL-positive cells and osteoclasts on day 3 and more OPG- and IGF-I-positive cells and fewer odontoclasts on days 7 and 14. Indexes of root resorption were lower and tooth movement was faster in the GH-treated groups than in the control groups on days 7 and 14. CONCLUSIONS: The inhibitory effect of GH on root resorption by heavy force might be mediated by RANKL/OPG and IGF-I. Short-term GH administration may be a method with which to reduce root resorption and shorten treatment time, especially in patients who are susceptible to root resorption.